These Images were Taken Through This Celestron CPC 1100. See User Reviews Here: ...
Observatory Bosb33r :0) Celestron Nexstar 11" Test and again BAD seeing conditions :( This Celestron NexStar 11 GPS system ...
My Nexstar 8i doing gps align celestron nexstar nexstar8i telescope sct.
... using the hand cont rol "Utilities: Version" menu item) or any NexStar+ or StarSense hand control. If you have a CGE Series mount you must use the "Utilities: RTC " menu ... is set to Universal Time with Standard Time. NOTE: Mounts that support the CN16 GPS Accessory Kit (CGE, AS-GT, SLT, SE, iSeries) have a "Utilities: GPS on/off" menu ... GTO. Note: For the most efficient use of StarGPS with your Astro-Physics GTO system, we recommend that you change the way you have your keypad set up. Since ... location. 7) The message "Finishing." is followed by the Select Item: Object menu prompt. 8) Proceed to Select Item: Setup > Align to continue with alignment. 9) You can press ... to "R". The GPS receiver LED indicates the receiver status (see General Information above). 8) Wait until the GPS LED flashes once every 2 seconds. Rapid sustained blinking indicates that ... if desired, disconnect it from the StarBook. 10) Proceed with setup/alignment as usual. 11) You can use the "Location" menu item to view the latitude and longitude. These ...
Celestron Nexstar GPS 11 Removal and Replacement of Azimuth Clutch
(Slip Joint) by Adrian C. Richards December 17th 2004 ...
Now remove the large nut holding the upper assembly to the base. I used a /8", 12 point socket to achieve this. Pay attention to the wire in the center of ... . Extra force may be required!
Most likely you will now see what the problem is!
8/10
Remove the 3 nuts from the tension adjuster.
Remove the Clutch and go order ... Celestron Inc. USA for the parts are as follows: Azimuth Lever $21.00, Ring Clamp $11.00, S & H $5.00
End of part one.
Many thanks to Adrian for allowing ...