15.25 cm

FM 65R Amplifier
Fender touch-sensitive circuit design simulates the feel of tube distortion PRE-AMP OUT and POWER-AMP IN jacks allow you to connect external effects devices, other amplifiers or sound/recording equipment to your FM 65R FOOTSWITCH jack for use with a 1-button Fender footswitch (optional). A footswitch provides remote channel selection
Thank you for choosing Fender The Worlds Worlds most popular instrument amplifierssince 1946 instrument
Your new FM 65R amplifier delivers worldclass Fender tone and worldstandard Fender quality: 65W output power into 8 ohms Selectable Normal and Drive channels independent volume and tone controls with
MID-CONTOUR button furnishes many different variations in distortionfrom Rock to Blues to Metal to whatever! Classic Fender spring Reverb

Panel Functions

CH SELECT MID CONTOUR

INPUTS

VOLUME

TREBLE

REVERB

FOOT SWITCH

PRE OUT

PWR IN

F E N D E R M U S I C A L I N ST R U M E N TS
A. INPUT - Plug your guitar in here. INPUT 1 is normal sensitivity for most guitars, INPUT 2 is lower sensitivity for guitars with high output (active) pickups. B. VOLUME - Adjusts the loudness of the Normal channel. C. TREBLE/BASS - Adjusts the high- and lowfrequency tones of the Normal channel. D. DRIVE - Adjusts the distortion level in the Drive channel. Use together with VOLUME {F} to adjust the overall loudness of the Drive channel. E. CHANNEL INDICATOR LED OFF Normal channel is active LED ON Drive channel is active F. VOLUME - Adjusts the loudness of the Drive channel together with DRIVE {D}. G. CHANNEL SELECT Button OUT selects the Normal channel Button IN selects the Drive channel H. TREBLE/MID/BASS - Adjusts the high-, middle-, and low-frequency tones of the Drive channel. I. MID-CONTOUR - Activates a scooped midrange EQ useful for modern distortion sounds in the Drive channel. J. REVERB - Adjusts the Reverb level for both channels.
K. FOOTSWITCH - Connect a 1-button Fender footswitch (optional) at this jack to enable remote channel selection. When plugged in, the footswitch overrides the CH SELECT button. L. PRE OUT/PWR IN - (1) Effects Loop - Connect PRE OUT to an effects device input, then connect the effects device output to PWR IN. (2) Multiple Amps - Connect the primary units PRE OUT to the auxiliary units PWR IN. The primary unit is used to control all auxiliary amps. (3) Recording or Reinforcement Connect PRE OUT to sound equipments input. Both jacks use a TS (Tip-Sleeve) standard type plug for connections. PRE OUT includes onboard tone shaping. M. POWER INDICATOR - Lights up when the amplifier is on. N. POWER - Switches the amplifier on and off. O. POWER CORD SOCKET - Connect the included power supply cord in accordance with the voltage and frequency ratings listed on the rear panel of your amplifier.