Proof Sign-off: N.Yoshie CRE Kawakami K.Yoda editor

R4CE770 SETUP Rev.C

SETUP.FM 3/2/04 A2 size

Color Ink Jet Printer

Warnings, Cautions and Notes

XXXXXXX-00 xxx

Unpacking

English

Warnings must be followed carefully to

avoid bodily injury.

Cautions must be observed to avoid
damage to your equipment.
Notes contain important information and
useful tips on the operation of your printer.
Installing the Printer Software
1. Press the P power button to turn off the printer. The green light goes off.
Note: If the language selection window appears, select your preferred language.
1. Remove the contents from the box. Remove all tape and packing material from the printer.
2. Attach the paper support and plug in the printer.
Caution: Be sure not to touch the ribbon cable inside the printer.
2. Connect the printer and computer with a USB cable, then insert the printer software CD into the CD-ROM drive.
Follow the on-screen instructions. If the installer dialog box does not appear, double-click EPSETUP.EXE on the CD-ROM. printer paper support ink cartridges CD-ROM

Setup power cord

The contents may vary in certain locations. The power cord comes attached in some countries.
3. Install the printer software.
Select your country or area of residence if the selection window appears. Then except where otherwise instructed, click or double-click the areas circled in red to proceed.
After installation is complete, see the Reference Guide for detailed information about printing from your computer for the first time.
The CD-ROM includes EPSON PhotoQuicker, EPSON PhotoStarter, EPSON CardMonitor, EPSON PRINT Image Framer Tool, PIF DESIGNER, and EPSON Web-To-Page. EPSON PhotoQuicker is a fun and easy to use program with a number of features that help you create outstanding photos. For more details, double-click the ESC45 Software Guide icon on the desktop to view Photo Print Software Setup.
Installing the Ink Cartridges
1. Press the P power button to turn on the printer.
Caution: Turn off all virus protection programs before installing the printer software.

Loading Paper

left edge guide
2. Remove the ink cartridges from their protective bags.
Do not remove or tear the label on the cartridge. output tray extension locking tab

Do not touch this part.

Note: To adjust the left edge guide, hold down the locking tab and slide the guide against the paper stack.
3. Install the ink cartridges as shown below.
Viewing the Reference Guide
The Reference Guide provides detailed information about printing from a computer, printer maintenance, problem solving, and safety. To view the Reference Guide, double-click the ESC45 Reference Guide icon on the desktop. You can also access the Reference Guide via the Start menu. To do so, click Start, point to All Programs in Windows XP or Programs in Windows Me, 98, or 2000, point to EPSON, then select ESC45 Reference Guide. Note: Install all ink cartridges. The printer will not work unless all cartridges are installed properly.
4. Press the ( Maintenance button.
The printer begins ink charging. It takes about one and a half minutes. While charging, the printer produces a variety of mechanical sounds. This is normal. When the green light stops flashing, ink charging is complete.

Safety Instructions

Read all of the instructions in this section when setting up and using your printer.
When handling ink cartridges
Keep ink cartridges out of the reach of children. Do not allow children to drink from or otherwise handle the cartridges. Do not open the ink cartridge packages until just before you install them. Do not shake the ink cartridges; this can cause leakage. Be careful when you handle used ink cartridges, as there may be some ink remaining around the ink supply port. If ink gets on your skin, wash the area thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. If discomfort or vision problems remain after a thorough flushing, see a doctor immediately. You must remove the yellow tape seals from the cartridges before installing them; otherwise, the cartridges will become unusable. Do not remove the blue portion of the tape seal from the top of the cartridges. Do not remove the tape seals from the bottom of the cartridges. The IC chip on this ink cartridge retains a variety of cartridge related-information, such as the amount of ink remaining, so that a cartridge may be removed and reinserted freely. However, each time the cartridge is inserted, some ink is consumed because the printer automatically performs a reliability check. Do not touch the green IC chip on the side of the cartridge. Do not put your hand inside the printer or touch the ink cartridges during printing. Do not block or cover the vents and openings in the printer. Do not attempt to service the printer yourself. Unplug the printer and refer servicing to qualified service personnel under the following conditions: The power cord or plug is damaged; liquid has entered the printer; the printer has been dropped or the casing damaged; the printer does not operate normally or exhibits a distinct change in performance. Do not insert objects through the slots in the printer. Take care not to spill liquid on the printer. Leave the ink cartridges installed. Removing the cartridges can dehydrate the print head and may prevent the printer from printing.

When choosing a place for the printer
Avoid places subject to rapid changes in temperature and humidity. Also, keep the printer away from direct sunlight, strong light, or heat sources. Avoid places subject to dust, shocks, or vibrations. Leave enough room around the printer to allow for sufficient ventilation. Place the printer near a wall outlet where the plug can be easily unplugged. Place the printer on a flat, stable surface that extends beyond the base of the printer in all directions. If you place the printer by the wall, leave more than 10 cm between the back of the printer and the wall. The printer will not operate properly if it is tilted at an angle. When storing or transporting the printer, do not tilt it, stand it on its side, or turn it upside down. Otherwise ink may leak from the cartridge. Use only the type of power source indicated on the printers label. Use only the power cord that comes with this product. Use of another cord may result in fire or electric shock. This products power cord is for use with this product only. Use with other equipment may result in fire or electric shock. Be sure your AC power cord meets the relevant local safety standard. Do not use a damaged or frayed power cord. If you use an extension cord with the printer, make sure that the total ampere rating of the devices plugged into the extension cord does not exceed the cords ampere rating. Also, make sure that the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlets ampere rating. If you plan to use the printer in Germany, the building installation must be protected by a 10 or 16 amp circuit breaker to provide adequate short-circuit protection and over-current protection for this printer.
Caution: Do not turn off the printer during the ink charging process.
Note: The ink cartridges packaged with your printer are partly used during initial setup. In order to produce high quality printouts, the print head in your printer will be fully charged with ink. This one-off process consumes a quantity of ink and subsequent cartridge sets will last for their full rated life.

When choosing a power source

When using the printer

All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this Epson printer. Epson is not responsible for any use of this information as applied to other printers. Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by the purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U.S.) failure to strictly comply with Seiko Epson Corporation's operating and maintenance instructions. Seiko Epson Corporation shall not be liable for any damages or problems arising from the use of any options or any consumable products other than those designated as Original Epson Products or Epson Approved Products by Seiko Epson Corporation. Seiko Epson Corporation shall not be held liable for any damage resulting from electromagnetic interference that occurs from the use of any interface cables other than those designated as Epson Approved Products by Seiko Epson Corporation. EPSON is a registered trademark and EPSON Stylus is a trademark of Seiko Epson Corporation. Copyright 2001 Seiko Epson Corporation. All rights reserved. PRINT Image Matching is a trademark of Seiko Epson Corporation. The PRINT Image Matching logo is a trademark of Seiko Epson Corporation. Microsoft and Windows are registered trademarks of Microsoft Corporation. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. Epson disclaims any and all rights in those marks.

Copyright 2004 by Seiko Epson Corporation, Nagano, Japan.
Printed in XXXXXX XX.XX-XX

XXXXXXX Rev.0 1-F BK2

XXXXXXX Rev.0 1-F C

XXXXXXX Rev.0 1-F M

XXXXXXX Rev.0 1-F Y

XXXXXXX Rev.0 1-F BK