3" Bull Bar with Stainless Skid Plate Installation Instructions

Part: # 35-4001/35-4002

GMC Yukon 2000-2006

Click To Select:

# 35-4001

2000-2006 Yukon

# 35-4002

2000-2006 Yukon XL

Grille Guard

Car Accessories

BULL BAR
PART# B35-4001 / 35-4001 INSTRUCTION SHEET
2000-06 TAHOE/YUKON/ 2000-06 SUBURBAN 1500 / YUKON XL 1500 1999-06 SILVERADO/SIERRA 1500 / 2007 SILERADO 1500 CLASSIC (both w/ & w/o clad) 2007 SIERRA 1500 CLASSIC 2001-06 AVALANCHE 1500 (both w/ and w/out clad)

QTY. 2

ITEM 3
CONTENT BULL BAR BRACKETS-PASSENGER & DRIVER SIDE BOLT PLATE
PLASTIC PLUG RUBBER BUMPER 1/2 -13 X 2.00 HEX HEAD BOLT FLAT WASHERS LOCK WASHERS - 13 HEX NUT 3/8 -16 X 1.25 HEX HEAD BOLT 3/8 FLATE WASHER 3/8 LOCK WASHER 3/8-16 HEX NUT M12- 1.75 X 40MM HEX HEAD BOLT M12-1.75 HEX NUT
STEP 1 REMOVE CONTENTS FROM BOX AND VERIFY ALL PART ARE PRESENT. READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING. STEP 2 IT MAY BE NECESSARY TO REMOVE/RELOCATE FRONT LICENSE PLATE AND LICENSE PLATE BRACKET. IT IS NOT REQUIRED, BUT SRONGLY RECOMMENDED. STEP 3 DETERMINE PASSENGER AND DRIVER BRACKETS. FROM UNDERNEATH VEHICLE, REMOVE TOW HOOKS. INSERT BOLT PLATES THROUGH LARGE HOLES AND M12 X 1.75 X 40MM HEX HEAD BOLTS THROUGH SMALL HOLES IN BOTH BOTTOM FRAME LOCATIONS. SEE FIGURE 2. STEP 4 ATTACH BRACKETS TO FRAME USING FASTENERS AS SHOWN. LEAVE LOOSE. NOTE, FOR VEHICLES W/OUT TOW HOOKS A SMALL OPENING MAY NEED TO BE CUT OUT IN THE TWO INSIDE INDENTS OF THE AIRDAM USING A UTILITY KNIFE. SEE FIGURE 3. STEP 5 ATTACH BULL BAR TO BRACKETS USING 3/8 FASTENERS AS SHOWN. NOTE: 1999-02 MODELS USE FRONT AND MIDDLE HOLES ON THE LOOP MOUNTING BRACKETS. 2003 UP MODELS USE MIDDLE AND REAR HOLES. SEE FIGURE 2. STEP 6 LEVEL AND ADJUST BULL BAR AS DESIRED. TORQUE FASTENERS TO 65 FT.LBS AND 3/8 FASTENERS TO 30 FT. LBS.
FINISH PROTECTION- ARIES PRODUCTS HAVE A HIGH FINISH THAT MUST BE MAINTAINED SUCH AS ANY OTHER HIGH FINISH PRODUCT ON THE VEHICLE. PROTECT THE FINISH WITH A NON-ABRASIVE AUTOMOTIVE WAX. THE USE OF SOAP, POLISH, OR WAX THAT CONTAINS ABRASIVES IS DETRIMENTAL, AS THE COMPOUNDS SCRATCH THE FINISH AND OPEN IT TO CORROSION.
DISCLAIMER- BUYER ASSUMES ALL RISK AND LIABILITY WHATSOEVER FROM THE INSTALLATION AND USE OF ARIES PRODUCTS. ARIES PRODUCTS ARE SOLD AS DECORATIVE ACCESSORIES AND SHOULD NOT BE RELIED UPON AS PROTECTION FOR THE VEHICLE OR OCCUPANTS IN THE EVENT OF A COLLISION OR ROLL OVER. ARIES AUTOMOTIVE ASSUMES NO LIABILITY FOR INJURY, LOSS, INCIDENTAL OR CONSEQUENTIAL DAMAGES IN THE EVENT OF A COLLISION OR ROLLOVER.

35-4001

B35-4002 / 35-4002 INSTRUCTION SHEET
1999-06 SILVERADO 2500LD / 2001-06 SIL 1500HD/2500HD/3500HD 2000-06 SUBURBAN/TAHOE 2500 / 2001-06 AVALANCHE 2500 (both w/ and w/out clad) 1999-06 SIERRA 2500 LD / 2001-06 SIERRA 1500HD/2500HD/3500HD / 2000-06 YUKON XL 2500LD
CONTENT BULL BAR BRACKETS-PASSENGER & DRIVER SIDE SPACER PLATE
RUBBER BUMPER 1/2 -13 X 2.00 HEX HEAD BOLT FLAT WASHERS LOCK WASHERS 3/8 -16 X 1.25 HEX HEAD BOLT 3/8 FLATE WASHER 3/8 LOCK WASHER 3/8-16 HEX NUT M12- 1.75 X 40MM HEX HEAD BOLT M12-1.75 HEX NUT
STEP 1 REMOVE CONTENTS FROM BOX AND VERIFY ALL PART ARE PRESENT. READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING. STEP 2 IT MAY BE NECESSARY TO REMOVE/RELOCATE FRONT LICENSE PLATE AND LICENSE PLATE BRACKET. IT IS NOT REQUIRED, BUT SRONGLY RECOMMENDED. STEP 3 DETERMINE PASSENGER AND DRIVER BRACKETS. FROM UNDERNEATH VEHICLE, REMOVE TOW HOOKS. SLIDE BRACKETS THROUGH END FRAME AND ALIGN HOLES IN BOTTOM OF FRAME WITH THE TWO NUTS WELDED TO THE BRACKETS. ATTACH BRACKETS TO FRAME RAIL WITH FASTENERS AS SHOWN. NOTE: USE ONE SPACER PLATE FOR LARGE HOLE IN BOTTOM OF FRAME AS SHOWN. LEAVE LOOSE. NOTE FOR VEHICLES WITHOUT TOW HOOKS A SMALL OPENING MAY NEED TO BE CUT OUT IN THE TWO INSIDE INDENTS OF THE AIRDAM USING A UTILITY KNIFE. SEE FIGURE 3. STEP 4 ATTACH HOOP MOUNTS BRACKETS TO FRAME BRACKETS USING 3/8 FASTNERS AS SHOWN. NOTE: 1999-02 MODELS USE FRONT AND MIDDLE HOLES ON THE LOOP MOUNTING BRACKETS. 2003 UP MODELS USE MIDDLE AND REAR HOLES. SEE FIGURE 2.

STEP 5

LEVEL AND ADJUST BULL BAR AS DESIRED. TORQUE FASTENERS TO 65 FT.LBS AND 3/8 FASTENERS TO 30 FT. LBS.

35-4002