Installation instructions Steering head presentation rum kit new execution Moto Guzzi V35 - V65
Reading through thoroughly before the assembly absolutely.
This one resulting for damages from nonobservance of these instructions, being not replaced.

Scope of supply:

Steering head store adapter above (O) Steering head store adapter below (U) Tapered roller bearing above (Lo) tapered roller bearing with a great inside diameter (in front of mounted into store adapters O)
Tapered roller bearing below (Lu) tapered roller bearing with a small inside diameter (in front of mounted into store adapters U)
Cover sheet steering head store above (AB) Nut steering head store above (M) 2 x spacer for lamp holder on the left and on the right (D)
Copyright ; Martin Hagemann ; Bruchsal 21.08.2004

Assembly preparation:

1. Dismantling fork. 2. Cleaning threads of the fork bridge well and examining for burr formations, flattening outs and other damages. 3. the threads of the new steering head nut and the fork bridge grease well! 4. check whether the new nut (M) for the new steering head store runs easily on the thread of the fork bridge. The Nut (M) must have turned without tool by hand and without effort until end of the thread. 5. Shouldn't this be the case, they send me her fork bridge with the new nut for the adjustment so.
The probability is very high at nonobservance of this check that the thread of the fork bridge and the nut are destroyed at the assembly.
6. Removing lower store bowl of the fork bridge with a Spread tool 7. removing the upper and lower store bowl from the steering shaft

Assembly:

8. on the fork bridge (5) the tapered roller bearing (Lu) with the smaller inside diameter on-press 9. the store adapter U, mount into the steering shaft below 10.the store adapter O, mount into the steering shaft above 11.greasing the store bowls well in the store adapters 12.importing the fork bridge (5) into the steering shaft and putting on the upper tapered roller bearing (Lo) 13.putting the cover sheet (M) on the store (Lo) On the whole 14.turn on the nut (M), that with hand she grips into the upper tapered roller bearing (Lo) and only another low game is noticeable. 15.The original plate establishing with nose (6) on the nut (M) 16.originals put on the upper fork bridge (7) and with which stare at steering head nut (8) (take care that the nose of the plate (6) grips into the void in the fork bridge (7)). 17.Hiring steering head stores game vacant and countering steering head nut originally with this one.
If any problems should appear at the assembly, then they immediately call me (+49/177/8081919)
! ! ! don't start experiments by yourself ! ! !
Translation of the original text with Personal Translator 2004 Office The German installation instructions are authoritative