MoniServ, Inc.

http://www.moniserv.com
Tools: Philips screw driver Small Flat screwdriver thats all! Preparation: Make sure your desk is clean and you also need a piece of soft clothes because you need to place your LCD Monitor face down. How to open the back cover: First, remove all screws on the back cover, then, use a small flat head screw driver to push down the plastic Clip inside the LCD Monitor star at the bottom of monitor. Then you can easily separate the front bezel and back cover like the photos shown below.
Backlight Inverter Installation Procedures for Dell W1700
Place the Monitor Face Down
Push This Plastic Button Down and Remove Swivel Base as shown on Next Photo

Remove these screws

Star at the bottom of monitor as shown on photo. Use a small flat head screw drive to push down the plastic clip. Do it one side at the time as shown on next 2 photos
When you have unlocked all 4 sides of plastic clips, Place the monitor face down again as shown on photo
Slowly tilt upward from left side of back cover
Disconnect this cable and remove back cover
Remove two screws and Pull out this small circuit board
Disconnect Speaker cable and remove the tapes
Disconnect Backlight cables.
Remove these screws on the both side of Panel
Caution!!! Slowly tilt upward the chassis and disconnect the flat cable between Chassis and Panel As shown on next 2 photos.
Holding the chassis upward and Use small flat head screw drive to unlock this plastic clip

Slowly pull it out

Backlight Inverter board. Photo Shown with our Substitute Board
Remove 4 screws and disconnect this cable
Remove defective inverter board and replace with our New Substitute Board (T501045.00MSS) and re-install all disassembly components back. Now your LCD Monitor working again. MoniServ Substitute Board is available at http://www.lcdpart.com/Products/t50104500mss.html