SP Controls Application Note Hitachi CP-S860 Revision B I. Driver Features
1. Command Format This device is controlled through a combination of RS-232 and IR commands; both are necessary for full control of the device. 2. RS-232 Commands
Power On Power Off Volume (absolute) Source: Video 1 Source: RGB 1 Source: RGB 2

IR Commands

Menu Adj Up Adj Down Adj Left Adjust Right Reset Zoom Up Zoom Down Focus Up Focus Down Timer Freeze P in P Magnify Up Magnify Down Magnify Off Mute Blank
3. Other Driver Features Default Power Status Feedback: Projector Restart Lockout Timer (Default):
RS-232 Power Polling 80 Seconds
II. RS-232 Control Wiring
For IR wiring, see product manual for the SP Controls device. Wire RS-232 control to a female HD15 as follows: RX to 14 TX to 13 GND to 10 SP Controls

Device

Control Cable (shown from front)
Connect female HD15 to projector port labeled CONTROL. Serial Adapters (for NRC only): B, C, and D
III. Projector Configuration
Baud Rate: The Hitachi projector may be configured via the onscreen menus to accept RS-232 control over a range of speeds. This driver is configured for 9600bps. Verify that the projector is set to 9600bps in the onscreen OPT. (OPTIONS) Menu: COM. SPEED setting. If not, set the projector to 9600. Data Word: This driver is configured to use 8 data bits, no parity bit, and one stop bit (8N1). Verify that the projector is set to 8N1 in the onscreen OPT. (OPTIONS) Menu: COM. BITS setting. If not, set the projector to 8N1.

2003-9 SP Controls Inc.

SP Controls reserves the right to modify specifications without notice at any time.