User Manual

Model: G7-630

www.a4tech.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Federal Communications Commission Requirements The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient of relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. THE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USERS AUTHORITY TO OPERATE THE EQUIPMENT. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement The equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. The equipment has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio (SAR).

Knowing the Product

Far Range Up to 15 Meters
X-Far Wireless range ensures more operation freedom. (Note: Actual operating distance may vary and depend on working environments)
3 Shiftable Report Rates for power saving, Ensures No Lag Response
Instantly shifts mouse report rate between 8/4/2 ms for power saving and delivers smooth, accurate cursor control.
8 Gestures in Right Button
The mouse allows you get 8 functions on Right button.

Battery Status Indicator

Aware of the battery power anytime with A4 Techs uniquely designed 8 in Right software

Hardware Installation

2. Plug Nano-receiver into USB port of your computer or notebook. 1. Pull out the Nano-Receiver from the bottom of mouse.
3. Insert the supplied battery, make sure that the positive (+) and negative (-) ends of the battery match the polarity indicators inside the battery housing.
Power Management of the Mouse
1. To power on the mouse, switch the power button to ON position. 2. To turn off the mouse power, switch the power button to OFF position. Note: The mouse can be awaked easily by moving the mouse randomly if long time no using. The wireless mouse is plug-and-play. No driver is required. If you would like to get more function, please download software in our website: www.a4tech.com.

Software Installation

1. 2. 3. Before installing the mouse software, please uninstall any previous installed mouse software. Extract the ZIP file to your local disk and double click to start installation. Follow on-screen instructions to complete the installation. will appear on your desktop, then you have successfully installed
4. The icon the software.
5. To launch the software, double click the icon on your desktop or go to StartProgramsA4tech 8 in Right, then the icon will appear in the taskbar at the right corner of your screen.

Software Instructions

A. How to get 8 functions in right button of the mouse
From the task pull-down menu of each arrow direction, you can select keyboard, mouse, office sets, key combinations, multimedia and internet 6 main function categories and there are more than 30 different functions that are ready for your immediate selection.

Task Pull-down Menu

B. How to Pair the X-Far Wireless Devices
The G5/G7/G9 mouse series have been preset the ID Code in the factory. But under the circumstances you lose receiver or want to use with the other receiver in the same product series, you need to refresh the ID Code before using it. Step 2: Press Start Pair ID to refresh Step 1: Right click on the icon in ID Code. the taskbar and select Pair ID Program
Step 3: Remove the mouse batteries and insert again in 15 seconds 6 digits of matching code will be displayed on the menu as shown Mouse Pair ID OK.
C. How to Indicate Battery Status
All of G7 series have Battery status Indicator in the software, click in the main menu of the software, then the battery power status will be displayed on the screen. It is convenient that you can easily be aware when the battery power is low and change battery in time.
Smart Mouse Battery Low Warning Remind you to replace the battery right away when Figure. A will pop up in the right corner of your screen Mouse Battery Low Warning 100% Mouse Working Voltage 1.2V and Above

Display

1.12~1.1 9V

1.0~1.05 V

D. Three Shiftable Report Rates
There are 3 report rates can be preset for high sensitive response time of 2/4/8 milliseconds, it improves cursor delay and jumping problems of wireless mouse, saves power in working and increases accuracy playing the games. Mouse Suitable Response Time Report Rate Range 500Hz 250Hz 125Hz 2ms 4ms 8ms Game Photo design Office
F. Set RF Channel to Avoid Wireless Interference
In case there are many wireless mice working in the adjacent area, you may set a specific channel so as to avoid wireless interface, hence ensures better wireless communication quality.
Step 1: Right click on the icon in the taskbar and select RF Channel Setting
Step 2: Tick Channel Lock and distribute each mouse a different channel.

Notice:

To ensure that your mouse and keyboard send and receive perfectly, please read below instructions for your reference: 1. Interference from iron panel of PC.

To get optimal performance, please plug the Nano-receiver into to avoid shielding wireless signal when placing at .
USB Ports 2. Use USB extension wire to position the Nano-receiver at a far location to prevent
electromagnetism interference from devices which dont pass safety standard. 3. Avoid using the wireless mouse on a metal surface. Metals such as iron, aluminum, or copper shield the radio frequency transmission and slow down the mouses response time or cause the mouse to fail temporarily. The radio frequency is 2.4HZ, it is safe for our bodies, but please be cautious in using cardiac pacemaker or other body auxiliary instruments.

Troubleshooting

If the mouse is not working: 1. Make sure the mouse is on. 2. Check battery and battery installation. 3. Check receiver installation. 4. Try another USB port. Product Support Need help with technical support? Please go to: http://www.a4tech.com/ennew/support.asp and our support team will respond within 72 hours. **Features and specifications of all A4 TECH products are subject to change without notification. Specification
RF Data Transmit Rate Modulation Type 500k bps GFSK Frequency ID Codes 2.407GHz 2.473GHz 524,288 sets

111.07 145.12 91.47 73.84 184.27 109.11 373.75 218.89 145.00 73.16 73.16 287.48 36.51 181.70 111.06 111.06 531.21 181.65 181.65 260.06 373.75 145.00 93.75 111.07 145.71 35.81 60.46 35.81 30.42 65.02 30.42 30.42 30.42 37.60 37.60 65.02 71.55 90.52 45.37 45.37 84.59 52.21 83.44 101.08 136.93 242.03 136.93 270.72 162.41 181.52 114.65 101.90 234.98 241.99 54.14 101.90 121.01 143.32 143.31 342.66 167.52 336.94 167.52

Strona 2

Microsoft Microsoft Microsoft Microsoft Microsoft Microsoft Microsoft Microsoft A4 Tech A4 Tech
OEM Laser Mouse 6000 USB B7G-00006/03 OEM IntelliMouse Optical PS/USB D58-00021/17 OEM Wheel Mouse Optical PS/USB Black N71-00025/08 OEM Basic Optical Mouse PS/USB Q66-00004/P58-00007 OEM Basic Optical Mouse PS/USB Black Q66-00032/31 OEM Wireless Optical Mse PS/USB N73-00017/14 OEM Noteb Optical Mse 2.0 USB N64-00003/02 OEM Wireless Notebook Optical Mse 4000 USB FA2-00005/04 Navigator Opto 325 (optyczna) Navigator Opto 315 PS/2 (3 przyciski)
105.18 59.44 36.58 32.02 32.02 73.16 43.45 86.88 20.52 23.67

Strona 3