A CT 20 Pin Pad Ins tallation Diagram

12-24V AC/DC

+ ORANGE

Connect to 12Vdc

INTERLOCK (PB2) PUSH BUTTON

BUZZER

DOOR CONTACTY

BL AC K ELL BR OW OW N

ITE OP3 WH E BLU OP2N EE GR

BATCH:

TAMPER
98XX-1 ACT20 REV2.1 SERIAL NUMBER: 012345 PRODUCT:

SENSE UNUSED

OR AN GE
Cable: 8 Core Screened, Max 30m

ENTRY/EXIT READER

OPTIONAL EXIT READER
U IDA B us B us Park, Centre, W hites tow n, T 24, Ireland. U nit nitT allaght ines s ines sW hites tow n, T allaght, Dublin allaght, Dublin 24, Ireland. T elephone: 462 2585. T elefax : 462 2587. E -m ail: s ales @ actrl.com W eb: w w w.actrl.com T elephone: 462 2585. T elefax : 462 2587. E -m ail: s ales @ acces s control.ie W eb: w w w.acces s control.com

ENTRY READER

Controller
Sense Clock Data +5V 0V Red LED Grn LED +12V
White Green Blue Red Black Brown Yellow Orange
Buzzer OP2 OP3 0V Door Contact Push Button +12V
The ACT20 connects in parallel between the reader and the controller. An extra line (ORANGE) is used to bring +12VDC power to the ACT20. The shields should be joined.

ACT20 Pin Entry Keypad

The ACT20 is a rugged metal-housed pinpad for use with a separate controller. It is usually used in conjunction with an ACT1010 magnetic swipe card reader for pin and swipe operation. Physically similar to the ACT10, the function of this device is quite different. The ACT20 is a slave device which transmits each keypress directly to the system controller. The unit is connected to the controller via an 8 core screened cable. The same cable may be used to carry the signals from a swipe reader as the ACT20 connects in parallel (refer to diagram). Pin Pad Cable Connections
Core Colour White Green Blue Red Black Brown Yellow Orange Shield Description Media Sense (open collector) Clock (open collector) Data (open collector) 5V Power (for reader only) 0V Ground Red LED control (negative applied) Green LED control (negative applied) 12V Power (for ACT20 only) Bonded to Reader housing

ACT20 Specification

Voltage Current Output Sink Current Operating Temperature Cable Reader Distance 12VDC nominal (10.5-16V) 20mA standby, 75mA maximum 50mA maximum -10 oC to +55 oC 8-core screened (shared with reader) Max 30m from controller
Operation with ACT1000 Controller PIN entry on the ACT1000/2000 or Ds100 is selected by setting the PIN Required option in the Installer menu/Door settings/Timed actions menu for the doors in question. A valid PIN must also be entered for the required group or user. The unit acts as a slave to the ACT1000/2000 controller and is connected in parallel with the reader (swipe or proximity). Normally the unit is dormant with only the standby LED illuminated. When a pin only entry is required the X button must be pressed before the pin code is entered, the keypad backlight and all LEDs illuminate. When a pin code is required with a swipe card the pin code is entered after the card is swiped. The ACT1000/2000 will process the entered PIN/Card and illuminate the red or green LED to indicate access granted or denied.
Note that the ACT20 may only be used with clock and data readers.