Plug the unit into the mains and place the handset on the charger.
Before using for the first time, we recommend that you leave the handset to charge on the base for a whole day (24 hours), in order to optimise battery performance and life. When the batteries are totally flat, it may take several minutes for the handset display to light up. 1.2
VERSATIS 80 HANDSET RECOGNITION BY THE BASE Press Select Select. "MULTI H/S" + "REGISTER" +.
Enter the PIN code (base code: by default 0000) + Press the or
key (depending on the product) on the base until it emits 3 tones.
" The display shows REGISTERING.

After a few seconds, the

icon appears steady on the display.
" The handset has now been registered "The number of the handset will be displayed on the right of the screen (unless specific programming is displayed: base ringer deactivated, etc.).
To check recognition, go off-hook:

and listen for the tone.

For more information on using the additional handset, see the instruction booklet for your VERSATIS 780.

2. WARRANTY

We would remind you that VERSATIS is approved in conformity with European regulations, as certified by the CE marking. You are covered by a legal warranty on this product and for all information concerning this warranty, please contact your reseller. Regardless of the legal warranty on the product, the reseller guarantees conformity of the products with their technical specifications for a period of twelve (12) months, parts and labour, starting from the date on the proof of purchase of the product. You should therefore keep your invoice or till receipt specifying the date of purchase of the product and the name of the reseller. However, if the legal warranty in your country exceeds twelve (12) months, the legal warranty alone then applies. If the legal warranty is on the contrary less than twelve (12) months, the total duration of the warranty (legal and commercial) will be of twelve (12) months. The non-conforming part or product will be repaired or replaced free of charge, by an identical part or product, or one at least equivalent in terms of function and performance. If repair or replacement were to prove impossible, you would receive a refund for the product. The spare product or part, which may be either new or reconditioned, is guaranteed for a period either of three months from the date of repair, or up to the end of the initial warranty period if this is longer than three months. All parts or products returned and replaced become the property of the manufacturer. However, this warranty becomes null and void in the following cases:

installation or use other than as instructed in this guide; incorrect connection or abnormal use of the product, in particular with accessories not specifically recommended; products which have been knocked or dropped; products damaged by lightning, voltage surge, source of heat or radiation, water damage, exposure to excessive humidity, or any other cause outside the product itself; defective maintenance, negligence; maintenance, modification or repair by a person not approved by the manufacturer or reseller.
SUBJECT TO LEGAL PROVISIONS, ALL WARRANTIES OTHER THAN THOSE DESCRIBED HEREIN ARE EXPRESSLY EXCLUDED.

3. SAFETY

The device is energized through an AC/DC adapter in conformity with standard EN 60950. Its input is classified hazardous and its output is classified SELV. The mains adapter must be installed close to the device and must be easily accessible. To disconnect the device from the primary power source, the mains adapter must be removed from the 230V AC 50 Hz outlet. If the mains adapter fails, it must be replaced by an identical model. If there is no mains power or a mains power cut, the terminals using cordless handsets will not be able to operate. You will be unable to make or receive calls in an emergency. This is why we recommend that you also have an additional conventional telephone set. The device is designed for connection to a TNV3 class analogue telephone line. The handset battery must be disposed of in compliance with waste disposal legislation. In the event of battery fluid leakage, avoid contact with the skin, eyes and mouth. In the event of contact, rinse the affected area for several minutes under running water. Clean up the fluid with absorbent paper or a dry cloth, and contact your retailer to replace the batteries. ! Do not use your telephone to report a gas leak while standing close to the leak.
In stormy weather, we recommend that you not use this device. ATLINKS hereby declares that this Versatis 80 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The certificate of conformity is available on the web site: "www.atlinks.com" or will be sent on request.

1. PRIMERA UTILIZACION

1.1 PUESTA EN SERVICIO.. del telfono
Conectar y colocar las bateras. Cerrar la lengeta.
! recargables o no conformes puede originar deterioros en su aparato.

. del cargador

Utilizar exclusivamente bateras recargables con las mismas caractersticas que las que equipan el producto. El uso de pilas no El constructor no asumir ninguna responsabilidad en caso de incumplimiento de esta recomendacin. No tirar las bateras al fuego: se corre el riesgo de una explosin
Conectar la toma de red y situar el aparato en el cargador.
Antes de usar el telfono por primera vez, se recomienda dejar el aparato en carga sobre la base durante 24 horas para optimizar la eficacia y la vida til de las bateras. Cuando las bateras estn completamente descargadas, es posible que la pantalla del telfono tarde unos minutos en iluminarse. 1.2