PHONE EASY

Big Button Telephone

User guide

LOCATION OF CONTROLS

RECALL REDIAL

STORE/MUTE MEMORY
Handset hanger hook Memory card Direct memories M1, M2, M3 Store/Mute button and indicator Memory button (Indirect)
Recall button Last number redial Visual ring indicator Keypad 0-9, *, # Volume controls

CONNECTING

# Connect the line cord to the telephone and to the telephone socket. # Lift the handset and check for a dial tone.

WALL MOUNTING

The Audioline Phone Easy can be wall mounted directly onto the standard wall plate or to the wall by following the instructions below: # Mark the position of the two holes 83 mm apart, one above the other. # Ensure there are no hidden cables, water pipes, etc., before drilling holes. Check that the intended mounting point is within reach of a telephone socket. # Drill the holes. # Fit the screws (not supplied) to the wall, leaving 5 mm protruding (use wall plugs if necessary, not supplied). # Place the telephone in position and locate the two holes on the base of the telephone over the screws, then slide into place. # The handset hanger hook (item 1 on page 1) must be removed, rotated 180 degrees and replaced.

TO MAKE A CALL

P Lift the handset and wait for dial tone. P Dial the phone number. P Replace the handset to terminate the call.

LAST NUMBER REDIAL

To redial the number called, lift the handset and press the [REDIAL] button. The number will be dialled automatically. The number will be retained in memory until another number is dialled. The [REDIAL] button will not operate if the number dialled was from memory.
To speak privately to a third party while on a call, press the [MUTE] button (the small red LED will flash). When you wish to resume your telephone conversation, press the [MUTE] button again.

DIRECT MEMORY

The telephone has 3 direct dial memories (M1-M3). When a phone number is stored into these memories you need to press only one button to make the call. STORING DIRECT MEMORIES P Lift the handset and press [STORE] button (ignore any sound in the earpiece). P Select the desired direct memory button M1 - M3 by pressing the corresponding button. P Enter the phone number (max 21 digits). P Press [STORE] button again. P Replace the handset. The number is now stored. DIALLING DIRECT MEMORIES P Lift the handset and wait for a dial tone. P Select the desired direct memory M1-M3 by pressing on the corresponding button. The telephone will automatically dial the stored number.

INDIRECT MEMORY

The telephone has 10 indirect memories (keypad 0-9). When a phone number is stored in a memory you need to press two buttons only to make the call. STORE INDIRECT MEMORY P Lift the handset and press [STORE] (ignore any sound through the earpiece). P Press [MEMORY] button. P Select the desired indirect memory (0-9) by pressing on the corresponding button. P Dial the phone number (max 21 digits). P Press [STORE] button again. P Replace the handset. The number is now stored. DIALLING INDIRECT MEMORIES P Lift the handset and wait for a dial tone. P Press [MEMORY] button. P Select the desired indirect memory (0-9) by pressing on the corresponding button. The telephone will automatically dial the stored number.

VOLUME CONTROL

The volume level in the earpiece can be increased or decreased using the volume buttons on the base unit during a call.

ADJUSTABLE RINGER

There are three different ringing tones available and three different volume settings for each ringer P P P P P Lift the handset and press the [STORE] button. Press [#]. Select a ring signal by pressing 0 - 9 according to the table below. Press the [STORE] button again. Replace the handset. The ringer type is now selected.
Keypad digit (factory setting) 9 0
Ringer type Melody A Melody A Melody A Melody B Melody B Melody B Melody C Melody C Melody C Off * (see below)
Setting Low Normal High Low Normal High Low Normal High -
* If setting 0 is selected, the ringer type will be turned off until the handset is lifted again. After that, the ringer type reverts to the previous setting.
ADDITIONAL NETWORK SERVICES
Network services such as call waiting, reminder calls, charge advice, etc., can be accessed via the [RECALL], [#] and [*] buttons. For further information, contact your Network Operator.

HEARING AID COMPATIBLE

The phone is hearing aid compatible. When used with a suitable hearing aid set to the T mode.

TROUBLESHOOTING

In the unlikely event of a fault occurring, proceed as follows: # Check that telephone is plugged into telephone socket. # Check telephone operation in master telephone socket. There may be a fault with the line in which case contact your Network Operator. # Check that total of REN numbers does not exceed 3 (the Phone Easy has a REN of 1.) # If the telephone does not ring, lift and replace the handset (the ringer may be programmed off).

WARNING

It is recommended that you disconnect your telephone during a thunderstorm as you can get a shock from your telephone (and other electrical appliances). We recommend you follow these simple precautions during a thunderstorm: # Do not use your telephone unless the call is urgent. # If you must use your telephone, make the call as brief as possible and keep clear of electrical equipment and metal fixtures. # Do not stand in bare feet on uncovered concrete floors. # Do not touch brick or concrete walls. NOTE: Do not install your telephone in damp or high humidity locations, such as a laundry or bathroom. If any damage is caused by such elements it is not covered by the manufacturers warranty.

CLEANING

The casing should be cleaned by wiping with a damp cloth. # Do not use abrasives, solvents or spray polish that may enter through holes in the earpiece and mouthpiece and cause damage. # Do not place the telephone in direct sunlight or use in extreme humidity.

REN (RN for New Zealand)

The REN (Ringer Equivalance Number) or RN is of significance only if you wish to connect more than 1 telephone to your telephone line. Your telephone line has a maximum REN capacity of 3 (RN of 5). Your Audioline Phone Easy has a REN of 1 (RN of 1), thus it is feasible to connect 2 (4) more telephones of a value of 1 to your system. You should not exceed a value of 3 (5) on the complete system, otherwise the volume of the ringer in any phone will decrease and one telephone may not ring at all.

GUARANTEE

If you believe your Phone Easy is malfunctioning, please refer to the relevant section and/or consult the troubleshooting guide in this manual to ensure that you have followed the instructions carefully. The Phone Easy is guaranteed for a period of 12 months from the date of purchase. In the unlikely event of a fault during this period, please contact us for assistance. If the product is then found to be faulty you will be asked to return it directly to us with a copy of the purchase receipt.
AUSTRALIA DORO Australia Pty Ltd PO Box 6760 Baulkham Hills BC NSW 2153 Australia Helpline Ph: (02) Fax: (02) 8853-8489 Email: doro@doro.com.au NEW ZEALAND Atlas Gentech (NZ) Limited Private Bag 14927, Panmure Auckland Consumer Support Ph: 0900 50-025 (Toll Call) Fax: (09) 574-2722 Email: support@atlasgentech.co.nz
NOTE: The guarantee does not extend to damage caused by misuse, negligence, excessive voltage, faults on the telephone line or lightning. This guarantee in no way affects your statutory rights. DORO is the trademark of DORO AB.
Notes For Operation In New Zealand
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with the minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment o f a different make or model, nor does it imply that any product is compatible with all of Telecoms network services. This equipment shall not be set to make automatic calls to the Telecom 111" Emergency Service. This Equipment may not provide for the effective hand-over of a call to another device connected to the same line.

PHONE EASY

Telephone

User guide

LOCATION OF CONTROLS

STORE/MUTE MEMORY

RECALL REDIAL
Handset hanger hook Memory card Direct memories M1, M2, M3 Store/mute button and indicator Memory button (Indirect)
Recall button Last number redial Ring indicator Keypad 0-9, *, # Volume controls

CONNECTING

# Connect the line cord to the telephone and to the telephone socket. # Lift the handset and check for a dial tone.

WALL MOUNTING

Check for hidden cables, water pipes, etc., before drilling holes. Check that the intended mounting point is within reach of a telephone socket. # Mark the position of the two holes 83 mm apart, one above the other. # Drill the holes. # Fit the screws (not supplied) to the wall, leaving 5 mm protruding (use wall plugs if necessary, not supplied). # Place the telephone in position and locate the two holes on the base of the telephone over the screws, then slide into place. Note: When the phone is wall mounted the hanger hook (with serrated top) located on the base directly below the circular earpiece resting point, must be removed, rotated 180 degrees (so that the lip protrudes) and replaced.

TO MAKE A CALL

P Lift the handset and wait for dial tone. P Dial the phone number. P Replace the handset to terminate the call.

LAST NUMBER REDIAL

To redial the number called, lift the handset and press the REDIAL button. The number will be dialled automatically. The number will be retained in memory until another number is dialled. The Last Number Redial button will not operate if the number dialled was from memory.
To speak privately to a third party while on a call, press the MUTE button (the small red light will flash). When you wish to resume your telephone conversation, press the MUTE button again.

DIRECT MEMORY (M1-M3)

The telephone has 3 direct dial memories. When a phone number is stored into these memories you need to press the M1 - M3 buttons only to make the call.
STORING DIRECT MEMORIES P Lift the handset and press STORE button (ignore any sound in the earpiece). P Select the desired direct memory button M1 - M3 by pressing the corresponding button. P Dial the phone number (max 21 digits). P Replace the handset. The number is now stored. DIALLING DIRECT MEMORIES P Lift the handset and wait for a dial tone. P Select the desired direct memory M1-M3 by pressing on the corresponding button. The telephone will automatically dial the stored number.
INDIRECT MEMORY (keypad 0-9)
The telephone has 10 indirect memories. When a phone number is stored in a memory you need to press two buttons only to make the call. STORE INDIRECT MEMORY P Lift the handset and press STORE (ignore any sound through the earpiece). P Press MEMORY button. P Select the desired indirect memory (0-9) by pressing on the corresponding button. P Dial the phone number (max 21 digits). P Press STORE button again. P Replace the handset. The number is now stored. DIALLING INDIRECT MEMORIES P Lift the handset and wait for a dial tone. P Press MEMORY button. P Select the desired indirect memory (0-9) by pressing on the corresponding button. The telephone will automatically dial the stored number.

VOLUME CONTROL

The volume level in the earpiece can be increased or decreased using the volume buttons on the base unit during a call.

ADJUSTABLE RINGER

There are three different ringing tones available and three different volume settings for each ringer P P P P P Lift the handset and press the STORE button. Press #. Select a ring signal by pressing 0 - 9 according to the table below. Press the STORE button again. Replace the handset. The ringer type is now selected.
Keypad digit (factory setting) 9 0
Ringer type Melody A Melody A Melody A Melody B Melody B Melody B Melody C Melody C Melody C Off * (see below)
Setting Low Normal High Low Normal High Low Normal High -
* If setting 0 is selected, the ringer type will be turned off until the handset is lifted again. After that, the ringer type reverts to the previous setting.
ADDITIONAL NETWORK SERVICES
Optional Network services such as call waiting, reminder calls, charge advice, etc., can be accessed via the RECALL, # and * buttons. For further information, contact your Network Operator.

HEARING AID COMPATIBLE

The phone is hearing aid compatible. When used with a suitable hearing aid set to the T mode.

FAULT FINDING

In the unlikely event of a fault occurring, proceed as follows: # Check that telephone is plugged into telephone socket. # Check telephone operation in master telephone socket. There may be a fault with the line in which case contact your Network Operator. # Check that total of REN numbers does not exceed 4 (the PHONE EASY has a REN of 1.) # If the telephone does not ring, lift and replace the handset (the ringer may be programmed off). Technical Support: If you cannot resolve the fault using the fault finder section, please call the Technical Helpline on: 0114 between 9AM - 5PM MondayFriday. Please note that this is a Premium Line number and all calls are charged at 50 pence per minute. Price correct at the time of going to press. Alternatively, you can write to: Technical Support Group, Doro-Audioline Ltd., 22 Walkers Road, North Moons Moat, Redditch, Worcestershire, B98 9HE.

GUARANTEE

The AUDIOLINE PHONE EASY is guaranteed for a period of 12 months from the date of purchase. In the unlikely event of a fault during this period, please return it with a copy of the purchase receipt to your place of purchase. The guarantee does not extend to damage caused by misuse, negligence, excessive voltage, faults on the telephone line or lightning. This guarantee in no way affects your statutory rights.