Oczyszczanie z kamienia.

Naley usuwa kamie ze sterylizatora co 4 tygodnie, aby zapewni jego maksymalnie efektywne dziaanie. Aby ograniczy osadzanie si kamienia w sterylizatorze mona stosowa uprzednio przegotowan lub filtrowan wod. 1) Wymieszaj saszetk kwasu cytrynowego (10 g) z 200 ml wody. Wlej do pustego sterylizatora. Nie zakadaj pokrywy. Wcz urzdzenie na 1-2 minuty, tzn. nie ustawiaj penego cyklu. Wycz urzdzenie z prdu i odczekaj 30 minut. Wylej zawarto i opucz sterylizator. Nastpnie wlej dokadnie 90 ml wody i uruchom peny cykl (w rodku nie powinny znajdowa si adne przedmioty). Na koniec wytrzyj wntrze ciereczk. LUB: 2) Wlej 100 ml octu zmieszanego z 200 ml zimnej wody. Pozostaw w urzdzeniu do rozpuszczenia si kamienia. Nastpnie oprnij urzdzenie i starannie opucz.

Pierwsza pomoc

Sterylizator nie wcza si Zbyt duo pary wydostaje si spod pokrywy Na artykuach poddanych sterylizacji powstaje osad Czas sterylizacji jest zbyt dugi Sprawd prawidowo woenia wtyczki oraz czy jest napicie w gniazdku. Artykuy s nieprawidowo uoone. Sprawd ich uoenie posikujc si rysunkiem.
Ze sterylizatora trzeba usun kamie (zobacz w instrukcji usuwania kamienia).
Zbyt duo wody wlaa do sterylizatora. Stosuj dokadnie 90ml wody. LUB: Do sterylizatora woya za mao artykuw niewielkie zaadowanie przedua sterylizacj.
Philips AVENT Express Electric Steam Steriliser
Please take 5 minutes to read through the whole of this leaflet before you use your Philips AVENT Express Electric Steam Steriliser for the first time. As well as bottles and breastfeeding accessories, you can sterilise any other boilable items (please refer to the manufacturers instructions regarding sterilisation). Please keep these instructions safe for future use. These instructions are also available on our website. NB: When loading, always ensure that the steam can effectively circulate around all surfaces and that any water can drain off easily. 8) Removed items must be used/assembled immediately or re-sterilised. Expressed milk can be stored in a sterile breast milk container in the refrigerator for up to 48 hours (not in the door) or in the freezer for up to 3 months. Infant formula should be made up fresh for each feed. 9) The steriliser must be left to cool for at least 10 minutes between each use to allow the thermostat to reset. 10) After each use, pour away any remaining water, rinse and wipe dry.

Warnings

1) Under no circumstances should anything other than citric acid or vinegar be used for de-scaling as it may cause irreparable damage. 2) Do not use bleach or chemical sterilising solutions/tablets in your steam steriliser or on products to be sterilised. 3) Do not use abrasive, anti-bacterial materials or scourers to clean the steriliser. 4) Do not use softened water in the steriliser. 5) The lead supplied must not be used on any other appliance and no other lead should be used with the Express Electric Steam Steriliser. 6) This appliance is intended for use by responsible persons, Keep out of reach of small children and the infirm. 7) This appliance is not intended for use by persons including children with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 8) Children should be supervised to ensure that they do not play with the appliance.
To sterilise up to six 260ml, 125ml or 330ml AVENT Bottles (see diagram C)
1) Slide the lower basket onto the central stem. 2) Thread 2 screw rings onto the central stem. 3) Slide the bottle rack down the central stem, with the neck facing down, until it rests on the top screw ring. 4) Place the teats through the centre of the holes in the bottle rack onto the lower basket. 5) Thread 4 screw rings onto the central stem. 6) Place the 6 inverted bottles in the bottle rack. 7) Push the upper basket onto the central stem until it rests on the catch. Place the 6 dome caps and tongs into the upper basket. 8) The upper basket is not required when sterilising 330ml bottles (see diagram C8). 9) Place the assembled unit into the steriliser body and put the lid on. 10) Put the lead into the back of the steriliser body and plug into the mains supply. Switch on. 11) Cycle times will vary depending on the load. After each cycle the unit will switch off automatically and the light will go out (approx. cycle time: 8 minutes).

Hazard Warning

When in use, the steriliser contains boiling water and steam escapes from the vent in the lid. Ensure the steriliser is placed on a firm level surface when in use. Never open the unit when in use. Always keep out of reach of children. Always unplug from the mains when not in use. Never place items on top of the steriliser. To stop the steriliser during the cycle, unplug at the mains. Take care when opening as steam can burn. Never immerse the steriliser in water. Never use the steriliser without water. Failure to follow de-scaling instructions may cause irreparable damage. There are no servicable parts inside the Express Electric Steam Steriliser. Do not attempt to open, service or repair the Express Electric Steam Steriliser yourself.

Dishwasher Basket (see diagram F) 1) The upper and lower baskets can be clipped together to hold small items such as teats, breast pump parts, soothers, etc for washing in the top rack of your dishwasher prior to sterilisation. 2) To clip together, align the two baskets so that the indicators are opposite each other and snap the baskets together. To open basket, pull apart with fingers using side recesses. Warning: If your Philips AVENT items are washed in the dishwasher with dirty items covered with remnants of strong sauces, such as tomato sauce, they may discolour over time. Care of your steriliser
You should de-scale your steriliser every four weeks to ensure it continues to work 100% effectively. It may be advantageous to use pre-boiled or filtered water in your steriliser in order to reduce limescale build up. EITHER: 1) Mix one sachet of citric acid (10gms) with 200ml of water. Pour into the empty steriliser. Do not put lid on. Switch on for 1-2 minutes, i.e. do not run a full cycle. Switch off at mains and leave to stand for 30 minutes. Drain and rinse out the steriliser. Run a full cycle empty with the lid on, using exactly 90ml of water. Wipe out the steriliser. (Citric Acid is available from most chemists avoid contact with eyes as this may cause irritation. Keep out of reach of children.) OR: 2) Pour 100ml vinegar mixed with 200ml cold water into steriliser. Allow to stand in the unit until any limescale has dissolved. Empty the unit and rinse thoroughly.

Guarantee

Philips AVENT guarantees that should the Express Electric Steam Steriliser become faulty during twelve months from the date of purchase, it will be replaced free of charge during this time. Please return it to the retailer where it was purchased. Please keep your receipt as a proof of purchase, together with a note of when and where purchased. For the guarantee to be valid, please note: The Express Electric Steam Steriliser must be used according to the instructions in this leaflet and connected to suitable electricity supply. The claim must not be a result of accident, misuse, dirt, neglect or fair wear and tear. This does not affect your statutory rights. Philips AVENT is here to help GB: Call FREE on 064 IRL: Call FREE on 021 AU: AVENT Ltd, Suffolk, CO10 7QS, England

Contents (see diagram A)

a) Lid b) 2 x Upper basket c) Bottle rack d) Lower basket e) Central stem f) Steriliser body g) Measuring cup h) Lead and plug i) Tongs NB: Upper and lower baskets are identical

To sterilise the Philips AVENT ISIS Manual Breast Pump (see diagram D)
1) Click the ISIS Breast Pump body into the slot in the upper basket and arrange the other breast pump components as shown. Assemble remaining components of the ISIS Breast Pump in the lower basket. 2) Up to six bottles (not including screw rings, teats or dome caps) can be sterilised with the pump. 3) Place assembled unit into the steriliser body, put the lid on. 4) Put the lead into the back of the steriliser body and plug into the mains supply. Switch on.
Before using your steriliser for the first time
(see diagram B) Remove all items from inside the steriliser body. 1) Pour in exactly 90ml of tap water. 2) Assemble all the blue components (baskets, stem and bottle rack). Place the assembled components in the steriliser and put the lid on. 3) Connect the lead into the back of the steriliser and plug into the mains supply. The light should come on automatically. If it does not, press down on the steriliser switch. 4) At the end of the cycle the unit will switch off automatically and the light will go out. 5) Allow unit to cool, turn off at the mains, unplug and disconnect the lead from the back of the steriliser. 6) Remove baskets and bottle rack, pour away any remaining water and wipe dry.
To sterilise narrow neck bottles and other feeding items
Teats should be placed around the central stem in the lower basket and screw rings in the top basket, as they are too narrow for the stem. Always ensure items are positioned within baskets /racks to ensure effective circulation of steam. The bottle rack and/or upper basket can be removed to make more room.

Before each use

1) Before sterilising, wash all items in mild soapy water and rinse. 2) Pour exactly 90ml of water into the steriliser body. If you add more than 90ml you will prolong the cycle time. If you use less than 90ml, your items may not be properly sterilised.
After sterilisation (see diagram E) 1) Do not remove the lid straight away. Let the steriliser cool down for 3 minutes. 2) Turn off at the mains, unplug and disconnect the lead from the back of the steriliser. 3) Wash your hands thoroughly before removing the sterilised items. 4) Remove the lid. 5) If necessary, shake excess water from items before assembling. 6) The tongs can be used to remove small items and to pull the sterile teats through the screw rings of the bottles. 7) The contents will remain sterile for up to six hours, following the end of the cycle, provided the lid is not removed.