CHAPTER 7

PARTS LISTS, SCHEMATIC DIAGRAMS AND WARRANTY
Parts List - Nozzle and Front Axle Assembly
NOTE: Part numbers listed are available through Country Home Products, Inc. Ref# Part# Description Yoke 1/2"-20 Pin, Yoke 1/2" Bolt, Carriage, 3/8"-16 x 1-1/2", ZP Washer, Flat, 3/8", SAE, ZP Nut, Lock, Nylon, 3/8"-16, Thin, ZP Screw, Cap, 5/16"-18 x 3-1/2" Nut, Lock, Nylon, 5/16"-18, UNC Washer, Flat, Fender, 5/16" Nut, Lock, Nylon, 1/2"-13, UNC Thin Washer, 1/4", FC, ZP Label, Warning, Open Bolt, Carriage, 5/16"-18 x 3-1/2" Roll Pin, 1/4" x 1" long Washer, 1/2", SAE Nozzle, Vacuum, 27", Plastic Cap, 5", Vacuum Hose Handle, Lower, Vacuum Wheel, 14", Assy w/Bearing & Tire Axle, Front Bracket, Height Ref# Part# Description Bolt, 1/4"-20 x 3/4", HWH Link, Height Adjuster Bracket, Nozzle, Wear Guard Rod, Connect, Height Adjuster Bushing, 0.5" ID x 0.625" OD x 0.250" Rod, Handle, Crank Handle, Crank, 0.5" ID x 3.72" Long Bushing, 3/8" ID x 1/2" OD x 3/8" long Washer, Lock, Twisted Tooth, 1/4" Nut, Pal, 1/2" Diameter Cover, Nozzle Label, Product Decal, DR Screw, Plastic Label, Height Adjuster Screw, Drill Point, 1/4" x 1" Bracket, Nozzle, Cover Reinforcement Bolt, Carriage, 1/4"-20 x 3/4" Nut, Flange, 1/4"-20
DR WALK-BEHIND LEAF & LAWN VACUUM
Schematic Diagram - Nozzle and Front Axle Assembly

060928

CALL TOLL-FREE 1-800-DR-OWNER
Parts List - Drive/Rear Axle Assembly
NOTE: Part numbers listed are available through Country Home Products, Inc. Ref# 106 Part# 21804 Description Bracket, Transmission Mount Bearing, 3/4" w/Pillow Block Differential, 54 Tooth D-Cut Bracket, Trans., Anti Rotation Guard, Drive Trans., 3-Speed Sprocket, 8 Tooth Belt, 3L34 Bearing, 1/2" Clip Plate, Trans., Bearing Mount Washer, Lock, Internal Tooth, 1/2" Screw, Socket Head, 1/4"-20 x 3/4" Washer, 5/16" Lock, Twisted Tooth Wheel, 14" Assembly Drive Bolt, Carriage 1/4"-20 x 1" Bracket, Trans., Reinforce Bolt, Carriage 3/8"-20 x 1-1/2" Pulley, Idler, 2" OD x 3/8" ID Tube, 3/4" ID, Wheel Spacer Washer, 1/4" Lock, Twisted Tooth Washer, 1/4", SAE, ZP Nut, Lock, Nylon Insert, 1/4"-20 Screw, Cap, 5/16"-18 x 3", HCS, ZP Nut, Lock, Nylon Insert, 5/16"-18 Screw, Cap, 5/16"-18 x 3/4", ZP Washer, 3/8", SAE, ZP Bolt, 1/4"-20 x 5/8", GR5 Ref# Part# Description Screw, Drill Point, 1/4" x 1" Chain, #41 x 42 Pitch Spring, Tension Washer, 1/4", FC, ZP Washer, 3/4", SAE Key, Woodruff, 1/8" x 1/2" Clip, 1/2" Control, Shift, Wescon Control Lever Assy, Clutch Washer, Flat, 1/2", SAE Screw, Cap, 1/4"-20 x 4", HCS, ZP Label, Danger, Guard Nut, Lock, 3/8"-16, LT. WT. Thin, ZP Label, Clutch Drive Bracket, Bearing Screw, Cap, 5/16"-18 x 3-1/2", HCS, ZP
The following are applicable to the Push model only: Washer, Flat, 1/2", SAE Bolt, Carriage, 5/16"-18 x 2-1/2" Washer, 1/4", FC, ZP Nut, Lock, Nylon Insert, 5/16"-18, UNC Nut, Lock, Nylon Insert, 1/2"-13 UNC Shaft, Rear Axle Bracket, Mount, Rear Axle Wheel, 14", w/Bearing and Tire

Schematic Diagram - Drive/Rear Axle Assembly

061009

Drive Assembly - Self-Propelled Models
Rear Axle Assembly - Push Model CALL TOLL-FREE 1-800-DR-OWNER 49
Parts List - Engine w/Impeller and Housing - Manual-Start Model
NOTE: Part numbers listed are available through Country Home Products, Inc. Ref# Part# 22267 Description Engine, Briggs & Stratton Quantum, M/S Engine, Briggs & Stratton Quantum, M/S, CA Impeller Assembly, Self-Propelled models Impeller Assembly, Push model Plate, Top, Self-Propelled models Plate, Top, Push model Housing, Plastic Washer, Lock, 3/8", Twisted Tooth Label, Hot Engine Key, Square, 2.125" x.187" Control, Throttle Nut, Lock, Nylon Insert, 1/4"-20, UNC Washer, 1/4", SAE, ZP Washer, Fender, 1/4" ZP Bolt, 1/4"-20 x 3/4", HWH Screw, Cap, 3/8"-24 x 2-3/4" w/Patch Lock Screw, Cap, 3/8"-16 x 2-1/2", Taptite Bolt, 1/4"-20 x 5/8", GR5 Screw, Cap, 1/4"-20 x 4", HCS, ZP Washer, 1/4", FC, ZP Washer, 1/4" Lock, Twisted Tooth
Schematic Diagram - Engine w/Impeller and Housing - Manual-Start Model
070809 CALL TOLL-FREE 1-800-DR-OWNER 51
Parts List - Engine w/Impeller and Housing - Electric-Start Model
NOTE: Part numbers listed are available through Country Home Products, Inc. Ref# Part# 22583 Description Engine, Briggs & Stratton Quantum, E/S Engine, Briggs & Stratton Quantum, E/S, CA Impeller Assembly Plate, Top Housing, Plastic Washer, Lock, 3/8", Twisted Tooth Label, Hot Engine Key, Square, 2.125" x.187" Control, Throttle Nut, 1/4"-20, UNC Washer, 1/4", SAE, ZP Washer, Fender, 1/4" ZP Bolt, 1/4"-20 x 3/4", HWH Screw, Cap, 3/8"-24 x 2-3/4" w/Patch Lock Screw, Cap, 3/8"-16 x 2-1/2", Taptite Bolt, 1/4"-20 x 5/8", GR5 Screw, Cap, 1/4"-20 x 4", HCS, ZP Washer, 1/4", FC, ZP Switch, Ignition Bracket, Starter Switch Solenoid, Electric Start Hold Down, Battery Harness, Cable, Electric Start Harness, Cable, Battery Harness, Cable, Ground Screw, Cap, 1/4"-20 x 1", HCS, ZP Battery, 12V - 5.6 AH Label, Start/Stop, Toggle Bracket, Mount, Solenoid Screw, Drill Point, 1/4" x 1" Washer, 1/4" Lock, Twisted Tooth Washer, Lock, External Tooth, 1/4"
Schematic Diagram - Engine w/Impeller and Housing - Electric-Start Model
070809 CALL TOLL-FREE 1-800-DR-OWNER 53
Parts List - Top Shield, Bag Assembly and Controls - All Models

NOTE: Part numbers listed are available through Country Home Products, Inc. Ref# 164

Part# 21887

Description Top Shield, Plastic Bracket, Bag, Channel, RH Seal, Bag Tube, Handle, Brace, RH Tube, Handle, Brace, LH Bracket, Bag, Channel, LH Bracket, Nozzle Door, Adjuster Bag Assembly Bar, Lift, Nozzle Door Rod, Lift, Nozzle Door Plate, Bag, Latch Grip, Lever, Lift Switch, Interlock, Bag, E/S Model Switch, Interlock, Bag, Push Model Bolt, Carriage, 1/4"-20 x 1-3/4" Harness, Wire Assy, Push Model Harness, Bag Wire Assy, E/S Model Washer, 1/4", FC, ZP Nut, Lock, Nylon Insert, 1/4"-20, UNC Screw, 10-24 x 1", HEX Washer, #10, SAE,ZP Nut, Lock, Nylon Insert, 10-24, UNC Tie Wrap Pin, Screw, 1/4"-28 Washer, Flat, 5/16", ZP Nut, Lock, Nylon, 5/16"-18 UNC Spring, Lever, GZ Washer, Fiber Screw, Cap, 5/16"-18 x 2" Bolt, 1/4"-20 x 2-1/4" x 3/4"-N, HF (Electric Start Model only) Screw, Cap, 1/4"-20 x 1" HCS, ZP Screw, Cap, 5/16"-18 x 1-3/4", ZP Bracket, Switch, Start, E/S Model only Washer, 1/4", SAE, ZP Label, Ear, Eye, Breathing Label, Read Rod, End, Ball Joint, 3/8", NF

Ref# 175 184

Part# 21859 21879

189 21884

Description Screw, Cap, 3/8"-16 x 1-1/2", ZP Nut, Lock, Nylon Insert, 3/8"-16, UNC Screw, Cap, 3/8"-16 x 2-1/2", ZP Seal, Bag, Top Shield Front, 1.8ft Long Nut, 3/8"-24, NF Screw, 1/4"-20 x 3/4", HWH Washer, Fender, 1/4", ZP Screw, Cap, 1/4"-20 x 4", HCS, ZP Nut, Acorn, 1/4"-20 Label, Danger, Flying Debris Label, Nozzle Door Plate, Shift Control, Anti-Rotation (Self-Propelled Model only) Screw, Cap, 10-24 x 1-1/4" (Self-Propelled Model only) Plug, Snap, Rivet, 0.166" Dia. (Push Model only) Plug, Snap, Rivet, 0.232" Dia. (Push Model only)
Not Illustrated 22268 Grommet, Clutch Cable 22317 Bracket, Hood Front
Schematic Diagram - Top Shield, Bag Assembly and Controls - All Models