POWER-I & POWER-II BATTERY BACK-UP
PROVIDES FULL SYSTEM BACK-UP POWER FULLY OPERATIONAL BATTERY BACK-UP
AVERAGE APPROXIMATE CYCLES PER 12 GATE TRAVEL HOUR PERIOD
20 0-90 0-90 0-90 0-50 30

CYCLE CHART

EAGLE POWER-I

EAGLE GATE OPERATOR

EAGLE-I
ADDITIONAL CYCLES WITH EXTRA BATTERY

SLIDE GATE OPERATORS

EAGLE-1000 (FSF OR FSC) EAGLE-2000 (FSF OR FSC) EAGLE-2000-DM

SWING GATE OPERATORS

EAGLE-II EAGLE-100 EAGLE-200 EAGLE-200-DM

EAGLE POWER-II

EAGLE-2000-1HP EAGLE-2000-APT EAGLE-2000-APT-1.5HP EAGLE-2000-APT-DM
EAGLE-200-1HP Dimensions: Power-I 12-3/8 (H) x 17-1/2 (W) x 12-3/8 (D) Weight 85 lbs
Note: 1. Operating Cycles are estimates and may vary based on your conditions. 2. All ratings are for operator including Diamond Control Board, 2 Loop Detectors, Receiver, MAG Lock, Telephone Entry System and 1 Photo Detector. Additional accessories will reduce number of cycles. 3. Surge Protection on incoming 110V AC recommended. 4. Eagle Power-I and Power-II warranted 1-year. No warranty when used with a non-Eagle Operator.
0-140 Power-II 13-3/8 (H) x 21 (W) x 10-7/8 (D) Weight 90 lbs Second Battery Compartment 8-3/4 (H) x 16 (W) x 12-1/2 (D) Weight 65 lbs
Eagle Access Control Systems, Inc. 13286 Paxton Street Pacoima, CA 91331
Toll Free: 800-708-8848 Fax: 818-899-2666 www.EagleOperators.com
Create PDF with GO2PDF for free, if you wish to remove this line, click here to buy Virtual PDF Printer

INSTALLATION & OWNER'S MANUAL
THE EAGLE POWER II BATTERY BACK UP

Control Box

Battery Box
PHONE (818) 764-6690 / TOLL FREE (800) 708-8848
PRE INSTALLATION INSTRUCTIONS

CAUTION!

CAUTION
BEFORE PROCEEDING WITH INSTALLATION READ THIS MANUAL THOROUGHLY AND CAREFULLY FOLLOW ALL THE OPERATION INSTRUCTIONS.
THE POWER II IS INTENDED FOR USE WITH ONE 1HP OPERATOR, OR TWO 1/2 HP OPERATORS INSTALLED ON ONE INDEPENDENT BREAKER. DO NOT INSTALL THE POWER II ON TWO OPERATORS THAT ARE ON SEPARATE INDEPENDENT BREAKERS.
The Eagle-Power II Battery Back up is designed to provide back up power to a gate operator when the main AC supply voltage is interrupted or disconnected. There are two operations to the Eagle-Power II. First, (and recommended) when experiencing a power failure the back-up system not only supplies continuous power to run the gate operator, but will supply all of the the AC accessories (i.e. Loop Detectors, MAG lock, Photo Eyes and Edge Sensors) with all the power required to keep their full functions uninterrupted. Secondly, in the occurrence of power failure the gate can be opened by the Power I "hold open" relay and left open until power is restored. However, with the availability of continuous power available to the operator, this would not be necessary unless desired. Using the Power II battery back up system with its 115V continuous power, enables the gate operator and all of its safety features to continue to be UL 325 / 991 compliant.
IMPORTANT: THE PHONE SYSTEM TRANSFORMER SHOULD BE INSTALLED DIRECTLY
TO THE OPERATOR OUTLETS AND NOT TO THE EAGLE POWER I UNIT.
IMPORTANT: MONTHLY TESTS MUST BE PERFORMED ON BATTERY.

WARNING - HIGH VOLTAGE

ONLY A QUALIFIED TECHNICIAN SHOULD SERVICE THIS GATE OPERATOR

BATTERY TEST LOG

BATTERY TEST DATES OPERATOR SERVICES DATES

/ / / / / /

THE EAGLE POWER II INFORMATION & WARNINGS
The following items are included with the POWER II:
(A) (B) (C) (D) (E) (F) (G) Power II Control Box 1 - 75 AH Battery Box (in a second box) 1 - N/O Relay Output 2 - 3/4" Raintight Flexible Conduits 2 - 3/4" Raintight Conduit Connectors 1 - 12VDC Output (Optional) 1 - Instruction Manual
Power II Approximate Dimensions: Control Box : 13 3/8" (h) x 18 5/8" (w) x 11" (d) Battery Box : 14 1/2" (h) x 12 1/2" (w) x 9" (d)
(SEE PAGE #6 FOR FURTHER MEASUREMENTS)
The Eagle-Power II is a indoor & outdoor unit
THE POWER II IS DESIGNEDTO PROVIDE POWER TO A GATE OPERATOR IN CASE OF A POWER FAILURE OR THE POWER IS SHUT OFF. THE OPERATOR CAN START UNEXPECTEDLY WHEN THE AC POWER IS NOT SUPPLIED. PRIOR TO THE SERVICING OF GATE OPERATOR, BE SURE TO DISCONNECT THE BATTERY PACK OR TURN THE POWER OFF
THE POWER II PRODUCES LETHAL VOLTAGES. THE BATTERY CAN CARRY HAZARDOUS CURRENTS. THE ASPS SHOULD BE INSTALLED BY A QUALIFIED TECHNICIAN.
DO NOT SHORT THE BATTERY TERMINALS!
INSTALLATION OF THE EAGLE POWER- II

EAGLE POWER- II

Eagle Operator E-POWER II Eagle-2000-1HP Gate Size 10' 15' 20' Eagle-200-1HP
Cycles Per 12 Hour Period 80** 50** 30** 70**
Cycles Per 12 Hour Period With Extra Battery * 60 140

E-POWER II

* An extra 70AH battery comes with separate mounting box and cables - Weight: 65 lbs ** All ratings are for operators (including The Diamond Control Board) and three of the following
accessories: Loop Detector, Receiver, MAG Lock, Phone System and Electric Eye. Additional accessories will reduce the amount of cycles. Testing was only performed on the above specified Eagle Operators. All cycle estimates are based on properly installed gates and operators.
CONNECTING THE AC LINE VOLTAGE:
Electrically, the Power II is wired in series with the incoming AC supply from the breaker box to the operator. The connector labeled "AC In" is connected to the main AC supply. The "AC Out" is connected to the operator. Connect the incoming AC line to the AC In as follows: L - AC Line In (Live): Black N - AC neutral (Common): White G - AC Ground (Earth): Green Connect the outgoing AC line to the AC Out as follows: L - AC Line Out: Black N - AC neutral: White G - AC Ground: Green

Refer to the installation manual provided with operator for the proper connections to the operator
APPLYING THE POWER AND CONNECTING THE SYSTEM RELAY
With the power to the operator and breaker box turned off and all of the AC line connections are complete, install the provided relay. After 5 to 10 seconds the green inverter light will turn on. Then run the operator with the main breaker off to test the Power I. When testing is completed, turn on the breaker and the green inverter light will go off, then the charger green or yellow light will go on.
FOR HOLD OPEN APPLICATION
Connect the two orange wires from the sub panel to the "exit open" on the operator. Using this connection will immediatly open the gate upon power failure. The operator will resume normal operation when power is resumed.
REMINDER: There is a time delay of approximately 1-3 seconds between a power
failure and the initial functioning of the Power II.
Eagle recommends surge protection be installed on the incoming 110 AC Line to the battery back-up unit.

IMPORTANT!

INSIDE OF THE EAGLE POWER II Control Box

Battery Charger

2000 Watt Inverter

Control Sub Panel AC OUT

Hold Open

Battery Terminals

70 Ah Battery
MOUNTING THE EAGLE POWER PS INSTALLATION OF THE E-I I

21"

Mounting Bracket Holes 3/8" Diameter

13 3/8"

Rear View of Control Box

10" OC

1" 18 1/2" 20" OC Drawings Not To Scale 16" 2 1/2"

12 1/2"

7 1/2" OC

Rear View of Battery Box

2 1/2" 13 3/4" 14 1/2" OC
THE EAGLE POWER II Recommended Installation with flex conduit
3/4" Water-tight flexible conduit with fittings
S P E C IF IC AT IONS & WAR R ANT Y
T E C HNIC AL S P E C IF IC AT IONS
INP UT V OLTAG E : B AT T E R Y: R E C HAR G E T IME : OUT P UT V OLTAG E : OUT P UT F R E QUE NC Y: OUT P UT C UR R E NT: S UR G E C UR R E NT: AC OUT P UT P OWE R : S UR G E P OWE R : R E LAY OUT P UT S :
105 - 125 VAC 12V DC / 70AH 8 HOUR S 115 VAC 60 Hz 15 AMP S AMP S 2000 WAT T S 4000 WAT T S 10 AMP S

C A UT ION!

DO NOT E XC E E D T HE OUT P UT C APAC IT Y OF T HE P OWE R II. C ONNE C T ING A MOTOR LOAD LAR G E R T HAN R E C OMME NDE D MAY DAMAG E T HE P OWE R II AND V OID T HE WAR R ANT Y.
MA NUFA C T UR E R 'S L IMIT E D WA R R A NT Y
E agle Acces s C ontrol S ys tems , Inc. warrants its P ower II to be free from defect in material and workmans hip for a period of one(1) year from the date of purchas e for s ingle family home or multi-family and commercial us e. To obtain s ervice contact your dealer. To obtain s ervice under this warranty the buyer mus t obtain authorization ins tructions for the return of any goods from E agle before returning the goods. T he goods mus t be returned with complete identification, with copy of proof-of-purchas e, freight prepaid and in accordance with E agle's ins tructions or they will not be accepted. In no event will E agle be res pons ible for goods returned without proper authorization or identification. G oods returned to E agle for warranty repair within the warranty period , which upon receipt by E agle are confirmed to be defective and covered by this limited warranty, will be repaired or replaced at E agle's s ole option, at no cos t and returned prepaid. Defective parts will be repaired or replaced with new or factory rebuilt parts E agle's s ole option. T his limited warranty does not cover non-defect damage, damage caus ed by unreas onable us e, damage caus ed by improper ins tallation or care, vandalis m, or lightning, fire or exces s ive heat or other acts of G od (including, but not limited to mis us e, abus e or alterations , failure to provide reas onable and neces s ary maintenance), labor charges for dis mantling or reins talling a repaired or replaced unit, or replacement batteries. T hes e warranties are in lieu of all other warranties , either expres s ed or implied. All implied warranties of merchantability and/or a particular purpos e are hereby dis claimed and excluded. Under no circums tances s hall E agle be liable for cons equential , incidental or s pecial damages aris ing in connection with the us e or inability to us e this product. In no event s hall E agle's liability for breach of warranty, breech of contract, negligence or s trict liability exceed the cos t of this product hereby. No pers on is authorized to as s ume for E agle any other liability in connection with the s ale of this product.

F or F urther Information: P hone (800) 708-8848 / F ax (818) 764-6869 (8)