THE FENDER BASSMAN 410 PRO SL LOUDSPEAKER ENCLOSURE
Your new Bassman 410 Pro SL Bass Loudspeaker Enclosure is constructed from 3/4 (1.9 cm) 7-ply Birch Maple Plywood and is capable of handling 300 watts of continuous power. The Bassman 410 Pro SL features four 10 (25.4cm) speakers with 44 oz (1.25 kg) magnets and is designed for use with a Fender Bassman 1200, Bassman 300, Bassman 400 Head or other professional quality bass amplifier. Please read these instructions and the instructions that accompanied your amplifier before making connections. Follow all equipment caution and safety labeling.

SPECIFICATIONS

PART NUMBER: DRIVERS: 2217000000 Four 10 (25.4 cm) Fender Special Design Cast Frame Woofers 2 (5.1 cm) voice coil, 44 oz (1.25 kg) magnet One Horn Tweeter 1 (2.5 cm) voice coil, 8 oz (0.23 kg) magnet CABINET: SENSITIVITY: POWER HANDLING: 3/4 (1.9 cm) 7-ply Birch Maple Plywood 94 dB, 1 Watt - 1 Meter 300 Watts, Continuous 600 Watts, Program 8 Dual, Parallel Wired, 1/4 High Current Input Jacks and Binding Posts VB = 4.4 ft3 (125 l)
SPEAKER AND AMPLIFIER CONNECTIONS
Use 16 gauge (or heavier) speaker cable with standard 1/4 plugs to make connections. You may also connect to your Bassman 410 Pro SL with a dual banana plug or stripped wires using the red and black binding posts. Multiple 410 Pro SL cabinets can be linked as illustrated, when additional output is needed. Note: Follow the speaker impedance load guidelines set by the manufacturer of your amplifier to avoid damage to your equipment.

IMPEDANCE: CONNECTIONS:

ENCLOSURE VOLUME: DIMENSIONS:

HORN TWEETER

The horn tweeter is protected from power-overload damage by an incandescent lamp. If the horn tweeter stops responding, replace the lamp as you would a blown fuse. The lamp and a spare (reorder P/N 051857) are located on the circuit board on the inside of the input jack panel. Lamp Replacement: 1) Remove the 4 screws from the input jack panel corners. 2) Pull the panel out, then up. 3) Use a small flathead screwdriver to remove the blown lamp which is visible through a cutout in the circuit board. 4) Remove the spare lamp stowed on the side of the circuit board and install it where the blown lamp was located. 5) Install the input jack plate in the reverse order of removal.

P/N 057981

Height: Width: Depth: WEIGHT:
25.5 in 25.5 in 18.5 in 78 lb
(64.8 cm) (64.8 cm) (47.0 cm) (35.5 kg)
Product specifications are subject to change without notice.
A PRODUCT OF: FENDER MUSICAL INSTRUMENTS CORP. CORONA, CA USA Bassman and Fender are registered trademarks of FMIC Copyright 2002 FMIC