First Alert developed this video for the Sound the Alarm program, demonstrating how to install a SA340CN smoke alarm.
I'm a big fan of Apple's HomeKit technology, and did a tour of my large 1870's home, which is filled with dozens of HomeKit ...
the precise way the simple little battery is supposed to go in the smoke detector which if not done right will cause big head aches.
... -DP or IPGSM-4G). For "Direct Wire" downloading, you must install kit part number VBPCOMKIT. For "Direct Wire" downloading, you must install kit part number VFBPCOMKIT. Refer to chart on page 3 ... the panel ECP Bus (keypad bus) and programmed for ECP mode. In addition, you must install the Direct Wire wiring kit applicable to your panel. The notes on page 2 will ... , the radio should be used only on "UL-compatible" control panels. Refer to the communicator installation instructions for a list of these panels.
IPGSM-DP/IPGSM-4G The IPGSM-DP and ... communicators do not support ECP, 4204, or Zone trigger interface to the control panel. For installs where only one dialer circuit is available, refer to the iGSMCF or iGSMCFP4G. -6Updated: 4 ...
AlarmNet Services Compatibility
Vista-Low and Mid Series Panels
AlarmNet Control Panel Compatibility
Modes Supported Honeywell/ Private Label DL 4110XM Vista-10/10SE Safewatch Pro Via-30/P/PSE Vista- P1 Vista-20 Vista-20SE SL150 Safewatch 2000 Vista-10P Vista-15P Vista 20P/PS 320P1 Safewatch 3000/EN Vista-21iP Safewatch 4000 LYNX-R/REN LYNXR-I APX32 / APX32EN LYNXR-2 L3000 (LynxPlus)
Keypad Type Full Control (AUI)
GSM, GSMR, i, i-GSM
FA100C FA110C FA120C FA140C/ FA142C FA147C FA148C FA160C FA162C FA 130CP FA148CP FA168CPS/FA168CGP ReadyGuard-R/REN ReadyGuard-I ReadyGuard-R2 READYGD3000
Zone V+ V+ V+
Rev 15 +
Rev 15 +
V+ V- / Rev 2.0+ 5.2+ 5.4+ 3.0+
VRev 17+ Rev
Notes: 1. When "Rev." is referred to, it is referencing the revision of the control panel. 2. To support Total Connect features, your AlarmNet device must be v2.0.7 or later. 3. To support "Full ...