Jason goes over a 2010 Harley-Davidson Softail Rocker C. View Our Current Pre-Owned Inventory ...
Used 2009 Harley Davidson FXCWC Softail Rocker C Motorcycles for sale in Panama City Beach Florida USA with stage1 fuel ...
Harley Davidson Softail Rocker C FXCWC with exhaust Vance & Hines Big Radius and air cleaner Kuryakyn Velociraptor.
HD ROCKER & ROCKER C MODELS
3- Function Wiring Diagram (Run, Turn and Brake)
In order to obtain all three functions from your Heartland USA Billet Tear lights you will need one of the following:
BILLET TEAR WIRING
HL-LER 2008-2010 MODELS ONLY
3. At each Billet-Tear, twist the Red and Orange wires together. The two wire combo will be connected to the Greenpigtail wire for the Run, Turn and Brake for the RIGHT side light. Connect other Red, Orange Combo to the Green wire for the Run, Turn and Brake for the LEFT side. If you need a Run only light, for the Plate light use the pigtail with the Red and black wires only. Black is Ground and Red is the power wire.
1.Under the seat, at the right rear of the battery find the rear wire harness.
2. From the fender side of the harness cut at least 10" from the plug. Unplug the connection and plug in the new Badlands Illuminator. Plug the pigtail into the Illuminator. Each side has it's own pigtail. Connect the black wires from lights to pigtails black wire. This is ...
2007-2011 Harley Davidson Softail Models
*These instructions do not cover the Crossbones model*
PowerCommander USBCable CD-ROM InstallationGuide PowerCommanderDecals DynojetDecals Velcrostrips Alcoholswab Ziptie
THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION!
YOUCANALSODOWNLOADTHE POWERCOMMANDERSOFTWAREAND LATESTMAPSFROMOURWEBSITEAT:
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Remove the seat. Unplug the stock wiring harness from the ECM as shown in Figure A. Remove the four nuts securing the ECM to the bracket and remove the ECM. Remove the bolt that holds the seat strap to the rear fender. Remove the ECM bracket from the fender. Remove one nut at a time or the bracket will fall into the tire. Reinstall the nuts to support the inner fender ...