INFINITI INTEGRATED HOMELINK TRANSCEIVER

(If so equipped)

WARNING: During the set up procedure, the device you are programming (e.g., garage door, electric gate, entry door, etc.) will be activated. To avoid injury, make sure that people and objects are clear of all doors and gates during programming. Also, your vehicles engine should be turned off while programming the HomeLink Transceiver. Refer to your Owners Manual for complete details.
4. Continue to hold down both buttons until the HomeLink indicator light flashes slowly then rapidly (this could take up to 90 seconds). The rapidly flashing light indicates successful programming, and at this point you can release the buttons. Your HomeLink button should now be programmed. To confirm this, press the programmed button to activate the device. If the HomeLink Indicator Light Blinks Rapidly for Two Seconds and then Illuminates Solid HomeLink has picked up a rolling code garage door opener signal. You will need to perform the following steps to train HomeLink to complete programming. You may require a ladder and another person for convenience. 5. To activate the training mode, press and release the smart or learn button located on the motor of the garage door opener. This button is usually near the antenna wire that hangs down from the motor. If the wire originates from under a light lens, you will need to remove the lens to access the button.
Indicator light changes from a slow blink to a rapid flash

Step 3-4

Smart or learn button

Mirror

Console

Step 5

PROGRAMMING YOUR INFINITI INTEGRATED HOMELINK TRANSCEIVER
(Mirror controls shown; same steps apply for console and visor controls)

Fold here

To program your HomeLink Transceiver to operate a garage door, gate, home/office lighting, or entry door opener, you will need to be in the same location as the device. Note: Garage door openers manufactured after 1996 have rolling code protection. To program a garage door opener equipped with rolling code protection, you will need to be able to reach the motor of the garage door opener. This is where the smart or learn program button is located. For this step (#5), you may need a ladder. Red indicator

liht li light

Note: Once you have pressed and released Step 6 the button on the motor, you will have 30 seconds to perform the next step. For convenience, use the help of a second person.
To complete training, firmly press and release the programmed button
1. To begin, press and hold the two outer HomeLink buttons to clear the memory. Hold down both buttons until the indicator light blinks (this should take about 20 seconds). Release the buttons. 2. Position the hand-held transmitter for the device you would like to program 1-3 inches away from the HomeLink buttons. 3. Using both hands, simultaneously press and hold down the hand-held transmitter button and the HomeLink button you want to program. DO NOT release these buttons until Step 4 has been completed.

Step 1

6. Within 30 seconds of pressing the button on the motor, firmly press the HomeLink button youve just tried to program, holding it down for two seconds and then releasing it. Repeat the press/hold/release sequence up to three times. When the indicator light illuminates solid/continuous, training is complete and your HomeLink button should now be programmed. To Program Remaining Homelink Buttons: Perform Steps 2-4 (and 5 and 6, if needed) again. DO NOT perform Step 1 unless you want to clear all previously programmed HomeLink buttons. To Activate Programmed Devices: Press and hold the programmed HomeLink button, releasing it when the device begins to activate.
Hold end of hand-held transmitter 1-3 away from HomeLink

Step 2

If you have any questions or are having difficulty programming your HomeLink buttons, please refer to the HomeLink Web site at www.HomeLink.com or call 1-800-355-3515.