*2 Not included for this receiver. *2 No suministrado con esta unidad. *2 Non fourni avec cet appareil.
Bracket *2 Mnsula *2 Support *2 Flat type screwsM5 x 8 mm (M5 x 3/8") *2 Tornillos tipo planoM5 x 8 mm (M5 x 3/8 pulgada) *2 Vis tte plateM5 x 8 mm (M5 x 3/8 pouces) *2 Bracket *2 Mnsula *2 Support *2

Note Nota

: When installing the receiver on the mounting bracket, make sure to use the 8 mm (3/8") -long screws. If longer
screws are used, they could damage the receiver.
: Cuando instala la unidad en la mnsula de montaje, asegrese de utilizar los tornillos de 8 mm (3/8 pulgada) de
longitud. Si se utilizan tornillos ms largos, stos pueden daar la unidad. (3/8 pouces). Si des vis plus longues sont utilises, elles peuvent endommager lappareil.
Remarque : Lors de linstallation de lappareil sur le support de montage, sassurer dutiliser des vis dune longueur de 8 mm
Install the receiver at an angle of less than 30. Instale la unidad a un ngulo de menos de 30. Installez lappareil avec un angle de moins de 30.

Removing the receiver

Before removing the receiver, release the rear section.

Extraccin de la unidad

Antes de extraer la unidad, libere la seccin trasera.

Retrait de lappareil

Avant de retirer lappareil, librer la section arrire.
Insert the two handles, then pull them as illustrated so that the receiver can be removed. Inserte las dos manijas y, a continuacin, extrigalas de la manera indicada en la ilustracin para poder desmontar la unidad. Insrez les deux poignes, puis tirez de la faon illustre de faon retirer lappareil.

ELECTRICAL CONNECTIONS

To prevent short circuits, we recommend that you disconnect the batterys negative terminal and make all electrical connections before installing the receiver.

CONEXIONES ELECTRICAS

Para evitar cortocircuitos, recomendamos que desconecte el terminal negativo de la batera y que efecte todas las conexiones elctricas antes de instalar la unidad.
RACCORDEMENTS ELECTRIQUES
Pour viter tout court-circuit, nous vous recommandons de dbrancher la borne ngative de la batterie et deffectuer tous les raccordements lectriques avant dinstaller lappareil.
Be sure to ground this receiver to the cars chassis again after installation. Notes: Replace the fuse with one of the specified rating. If the fuse blows frequently,
consult your JVC car audio dealer. It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 to 8 ). If the maximum power is less than 50 W, change Amplifier Gain setting to prevent the speakers from being damaged (see page 40 of the INSTRUCTIONS). To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape. The heat sink becomes very hot after use. Be careful not to touch it when removing this receiver. Heat sink Sumidero trmico Dissipateur de chaleur