Dashboard Armaturenbrett Tableau de bord Dashboard
Stay (option) Anker (Option) Hauban (en option) Steun (facultatief)
Flat type screws (M5 x 8 mm)* Senkkopfschrauben (M5 x 8 mm)* Vis tte plate (M5 x 8 mm) * Platkopschroeven (M5 x 8 mm)* Bracket* Konsole* Support * Console* Pocket Taschen Poche Zak
* Not included with this unit. * Nicht Teil dieses Gerts. * Non fourni avec cet appareil. * Niet meegeleverd.
Screw (option) Schraube (Option) Vis (en option) Schroef (facultatief)
Flat type screws (M5 x 8 mm)* Senkkopfschrauben (M5 x 8 mm)* Vis tte plate (M5 x 8 mm) * Platkopschroeven (M5 x 8 mm)* Bracket* Konsole* Support * Console*
Note Install the unit at an angle of less than 30. Stellen Sie das Gert mit einem Winkel von weniger als 30 auf. Installez lappareil avec un angle de moins de 30. Installeer het toestel met een hoek kleiner dan 30.
: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are used, they could damage the unit. Hinweis : Beim Anbringen des Gert an der Konsole sicherstellen, da 8 mm lange Schrauben verwendet werden. Werden lngere Schrauben verwendet, knnen sie das Gert beschdigen. Remarque : Lors de linstallation de lappareil sur le support de montage, sassurer dutiliser des vis dune longueur de 8 mm. Si des vis plus longues sont utilises, elles peuvent endommager lappareil. Opmerking : Wanneer u het apparaat aan de bevestigingsklem vastmaakt, moet u de 8 mm lange schroeven gebruiken. Als u langere schroeven gebruikt, kan het apparaat worden beschadigd.

ELECTRICAL CONNECTIONS

To prevent short circuits, we recommend that you disconnect the batterys negative terminal and make all electrical connections before installing the unit. Be sure to ground this unit to the cars chassis again after installation. Notes: Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC IN-CAR ENTERTAINMENT dealer. It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 to 8 ). If the maximum power is less than 50 W, change AMP GAIN setting to prevent the speakers from being damaged (see page 34 of the INSTRUCTIONS). To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape. The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.

ELEKTRISCHE ANSCHLSSE