Mounting Suggestions Kawasaki Vulcan 900 Classic 2006-2011 & Custom 2007-2011 One-Piece Seat
Tools Required: 10 mm wrench 7/16 wrench Hardware: Two 1/4-20 x 3/4 Bolts- Classic (Included) Two 1/4-20 x1 Bolts- Custom (Included) Two 3/8 Tall Spacers- Custom (Included)
Baseplate Features: The one-piece marine-grade fiberglass baseplate is a direct replacement for the stock seat. Rubber bumpers are positioned to prevent the seat from touching the frame and fender. Stock Seat Removal Steps 1. Insert ignition key into left side cover and turn key clockwise to unlock stock seat. 2. Lift rear of seat up and then back to remove. Mounting of Mustang Seat 1. Remove the latch pin bracket from the center of the stock seat with a 10 mm wrench. 2. CLASSIC ONLY: Install bracket to seat using supplied 1/4-20 x 3/4 bolts. Tighten with a 7/16" wrench. Do not over tighten bolts. CUSTOM ONLY: Install spacers between stock bracket and seat. Secure bracket and spacers with 1/4-20 x 1" bolts. Tighten with a 7/16" wrench. Do not over tighten bolts. 3. Slide nose bracket of seat under the gas tank receiver. Push seat all the way forward then down onto fender latch. 4. Push center of seat down until click is heard; seat is now locked.
Enjoy the comfort of your new Mustang Seat!
These steps are guidelines to help you install your new Mustang product. If you need further assistance, please call us at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to questions@mustangseats.com, or visit our website at www.mustangseats.com. For care and maintenance of our seats, please go to our website under "Support". Ref part #75628, 76128, 76127, 76126, 79416, 79417

Mounting Suggestions: Kawasaki Vulcan 900 Classic 2006-09 & Custom 2007-09 Tank Bib
Mounting of Mustang Tank Bib 1. Remove single dash 6 mm bolt with a 4 mm Allen wrench. 2. Lift rear of dash up about 1", then push forward off of mounting pins. 3. Place the cutout in Tank Bib over the speedometer, then under the front mounting pins. Pull bib back until the rear of cutout is over the dash mounting hole. Align front of dash with tank's mounting pins. Slide dash back until mounting hole lines up with hole on tank, then re-install the 6 mm Allen bolt. Tighten with a 4 mm Allen wrench. 4. Remove the two tank mounting bolts and washers with a 12 mm wrench. Re-install them through the holes in bottom of bib. Tighten with a 12 mm wrench. Step 3 Enjoy the custom look of your Mustang Tank Bib! Step 1

Step 2

Step 4

Studded

These steps are guidelines to help you install your new Mustang product. If you need further assistance please call us at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern or send an e-mail to questions@mustangseats.com or visit our website at http://www.mustangseats.com