MATERIAL

SAFETY

Page:1/6 MSDS No.:PPC-1662
Product Name: MT STARTER 105 Prepared Date:3-Oct-2000 Revised Date: 24-Feb-2009
1. PRODUCT AND COMPANY IDENTIFICATION
Product Name: MT STARTER 105 used for: Di181, Di181f Supplier Identification: Konica Minolta Business Solutions (Canada), Ltd. 369 Britannia Road East Mississauga, Ontario L4Z 2H5 Telephone: (905)890-6600 Facsimile: (905)283-2511 Emergency Telephone No. CHEMTREC Telephone: 1-800-424-9300 WHMIS: This product is NOT subject to the controlled products regulations.
COMPOSITION / INFORMATION

Substance [ ]

INGREDIENTS

Preparation [ X ]

Major Ingredients: [Generic Name] Ferrite Polyester resin Polyester resin Carbon black Amorphous silica +++: Suppliers confidential information Hazardous Ingredients: Chemical Name: Carbon black (< 1%) CAS No.: 1333-86-4 OSHA Z-Tables(USA): 3.5mg/m3 NTP(USA): Not listed California Proposition 65(USA): Listed Symbol(EC): Not listed DFG-MAK(GER): III 3B
[CAS No.] +++ +++ +++ 1333-86-4 7631-86-9
[%] 70-80 10-20 1-10 <1 <1
EEC-No.: 215-609-9 ACGIH-TLV(USA): 3.5mg/m3 IARC Monographs: Group 2B R-Phrase(EC): Not listed Worksafe-TWA(Austl): 3mg/m3
Page:2/6 MSDS No.:PPC-1662
3. HAZARDS IDENTIFICATION
Emergency Overview: Black powder (mean dia. is 5 - 15um by volume ). Almost oderless. Classification: Not classified as dangerous. (1999/45/EC) Most Important Hazards and Effects of the Products Ingestion Effect: None currently known. Inhalation Effect: None currently known. Minimal respiratory tract irritation may occur as with exposure to large amount of any non-toxic dust. Eye Effect: None currently known. Skin Effect: None currently known. Chronic Effects: Prolonged inhalation of excessive dusts may cause lung damage. Use of this product, as intended, does not result in inhalation of excessive dust. Environment Hazards: No data are available on the adverse effects of this product on the environment. Specific Hazards: Dust explosion (like most finely divided organic powders)

FIRST-AID

MEASURES
Ingestion: Wash out mouth with water. Drink one or two glasses of water. If symptoms occur, get medical attention. Inhalation: Move victim to fresh air immediately. If symptoms occur, get medical attention. Eye Contact: Flush eyes with plenty of water for 15 minutes. If symptoms occur, get medical attention. Skin Contact: Wash with water and mild soap.

FIRE-FIGHTING

Suitable Extinguishing Media: CO2, water spray, foam and dry chemical Extinguishing Media to Avoid: Full water jet Fire and Explosion Hazards: If dispersed in air, like most finely divided organic powders, may form an explosive mixture. Protection of Firefighters: Use self-contained breathing apparatus(SCBA).

ACCIDENTAL

RELEASE
Personal Precautions: None Environmental Precautions: None Methods for Cleaning Up: Wear personal protective equipment (See Section 8). Vacuum or sweep material and place in a bag and hold for waste disposal. Use vacuum equipped with High Efficiency Particulate Air(HEPA) filter. Vacuum should be electrically bonded and grounded to dispel static electricity. To avoid dust generation, do not sweep dry.
Page:3/6 MSDS No.:PPC-1662

7. HANDLING AND STORAGE

Handling Technical Measures: None Precautions: Do not breathe dust. Avoid contact with eyes. Safe Handling Advice: Try not to disperse the particulates. Storage Technical Measures: None Storage Conditions: Keep container closed. Store in a cool and dry place. Keep out of reach of children. Incompatible Products: None Packaging Materials: Bottles or Cartridge designated by Konica Minolta.

EXPOSURE

CONTROLS/PERSONAL

PROTECTION

Engineering Measures Ventilation: None required with intended use. Control Parameters(As total dust) OSHA-PEL(USA): 15mg/m3 ACGIH-TLV(USA): 10mg/m3 DFG-MAK(GER): 4mg/m3 Worksafe-TWA(Austl.): 10mg/m3 Personal Protective Equipment Not required under normal conditions. For use other than in normal operating procedures (such as in the event of large spill), goggles and respirators may be required. Hygiene Measures: Wash hands after handling.

PHYSICAL

CHEMICAL

PROPERTIES

Color: Black Almost oderless Not applicable Not applicable Around 110 - 125 * /[] (Softening Point) Not applicable No data available No data available Not applicable 3.2 * Insoluble in water. Not applicable
Appearance Physical State: Solid Form: Powder (mean dia. is 5 - 15um by volume) Odor: PH Boiling Point(C): Melting Point(C)/[F]: Flash Point(C): Ignition Temperature(C): Explosion Properties: Vapor Pressure: Specific Gravity: Solubility: Partition Coefficient, n-Octanol/Water:

Page:4/6 MSDS No.:PPC-1662
10. STABILITY AND REACTIVITY
Stability: Stable except above 200C(392F). Hazardous Reactions: Dust explosion, like most finely divided organic powders. Conditions to avoid: Electric discharge, throwing into fire. Materials to Avoid: Oxidizing materials. Hazardous Decomposition Products: CO, CO2, and smoke. Hazardous Polymerization: Will not occur.

TOXICOLOGICAL

INFORMATION
Acute Toxicity: Ingestion(oral), LD50(mg/kg): >2000(Rat) * Dermal, LD50(mg/kg): No data available Inhalation, LC50(mg/l): >1.93(Rat,4hour) * (This was the highest attainable concentration.) Eye irritation: Slight conjunctival irritation(Rabbit) * Skin irritation: Non irritant(Rabbit) * Skin sensitizer: No data available Local Effects: see Chronic Toxicity or Long term Toxicity Chronic Toxicity or Long Term Toxicity: In a two-year inhalation study of chronic toxicity and carcinogenicity using a typical toner in rats, there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human exposures. A minimal to mild degree of fibrosis was noted in 22% of the animals at the middle exposure level (4mg/m3), and a mild to moderate degree of fibrosis was observed in 92% of the rats at the highest exposure level(16mg/m3). The lung changes observed in the higher exposure groups are interpreted in terms of "lung overloading", a series of generic responses to the presence of large quantities of respirable, insoluble and relatively benign dusts retained for extended time periods in the lungs. Lung tumor frequency was unchanged among rats exposed to toner at the three exposure levels, and for air-only control rats. Epidemiological study to date have not revealed any evidence of the relation between exposure to titanium dioxide and diseases of the respiratory tract beyond general effects of dust. Carcinogenicity In 1996 the IARC reevaluated carbon black as a Group 2B carcinogen (possible human carcinogen). This evaluation is given to Carbon Black for which there is inadequate human evidence, but sufficient animal evidence. The latter is based upon the development of lung tumors in rats receiving chronic inhalation exposures to free carbon black at levels that induce particle overload of the lung. Studies performed in animal models other than rats have not demonstrated an association between carbon black and lung tumors. Moreover, a two-year cancer bioassay using a typical toner preparation containing carbon black demonstrated no association between toner exposure and tumor development in rats. Mutagenicity: Negative *(AMES test) Teratogenicity: No data available (*= Based on data for other Konica Minolta Products with similar ingredients)

Page:5/6 MSDS No.:PPC-1662
12. ECOLOGICAL INFORMATION
No data are available on the adverse effects of this material on the environment. Ecotoxicity: No data available Mobility: No data available Persistence and degradability: No data available Bioaccumulative potential: No data available

DISPOSAL

CONSIDERATION
When disposing of the waste or recovered material, consult federal, state and/or local regulations for the proper disposal method.

TRANSPORT

Information on Code and Classifications According to International Regulations UN Classification: None

REGULATORY

US Information Information on the label: Not required TSCA(Toxic Substances Control Act): All chemical substances in this product comply with all applicable rules or order under TSCA. California Proposition 65: Ingredient carbon black subject to California Proposition 65 is bound in polymer-matrices so that warnings are not required. EU Information Information on the label (1999/45/EC and 67/548/EEC): Not required Article14 (2.1) of Directive 1999/45/EC is not applicable to this product. Canada Information WHMIS : This product is NOT subject to the controlled products regulations.
HMIS Rating: The National Paint and Coating Association(USA): Health: 1 Flammability: 1 Reactivity: 0 Recommended Uses: Starter for Electrophotographic Equipment Explanation of term: IARC 2B means "possible human carcinogen". Revision Information: Regular revision on revised date. Literature References: ANSI Z400.1-1993 ISO 11014-1 Commission Directive 91/155/EEC IARC(1996): IARC monographs on the Evaluation of the Carcinogenic Risk of Chemicals to Humans, Vol. 65, Printing Process and Printing Inks, Carbon Black and Some Nitro Compounds, Lyon, pp.149-261 H.Muhle, B.Bellmann, O.Creutzenberg, C.Dasenbrock, H.Ernst, R.Kilpper, J.C.MacKenzie, P.Morrow, U.Mohr, S.Takenaka, and R.Mermelstein(1991) Pulmonary Response to Toner upon Chronic Inhalation Exposure in Rats. Fundamental and Applied Toxicology
Page:6/6 MSDS No.:PPC-1662
17, pp.280-299. Restrictions: The above information is believed to be accurate and represents the best information currently available to Our Corporation. However, Our Corporation makes no warranty with respect to such information, and Our Corporation assumes no liability resulting from its use. Users should make their own investigation to determine the suitability of the information for their particular purposes.