INSTALLATION INSTRUCTIONS
This appliance is designed to be free standing only, and should not be recessed or built-in. Allow 5 inches of space between the back and sides of the wine cooler, which allows the proper air ventilation. Adjust the feet to keep the wine cooler level. Locate the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Ambient temperature below 55F (12.8C) or above 77F (25C) will hinder the performance of this appliance. This unit is not designed for use in a garage or any other outside installation. Avoid locating the wine cooler in moist areas. Plug the wine cooler into dedicated, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized service center. This unit is not designed to be installed in an RV or used with an inverter. After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down for 3 ~ 4 hours under before placing wine bottles in the wine cooler.
INSTALACIN DE SU ENFRIADORA DE VINOS
Remove the exterior and interior packing. Clean the interior surface with lukewarm water using a soft cloth. (Cleaning instruction on page 7)

WARNING

-Save these instructions-
To reduce the risk of fire, electrical shock, or injury when using your wine cooler, follow these basic precautions:
If any problems with the appliance persist, please contact our Customer Service Dept. to consult with a representative at 888 775-0202 or visit our website to request warranty service at www.magicchefewave.com.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance. Use of an extension cord can negatively affect the performance of the unit.
Never unplug the wine cooler by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle.
The cord should be secured behind the wine cooler and not left exposed or dangling to prevent accidental injury.
This wine cooler is not designed to be used with an inverter.
This wine cooler requires a standard 110-120 Volt A.C. /60Hz electrical outlet with three-prong ground.
Do not, under any circumstances, cut or remove the third ground prong from the power cord supplied.
This wine cooler should be properly grounded for your safety. The power cord of this wine cooler is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.

Antes de cambiar la luz interna del refrigerador del vino, entre en contacto con por favor nuestro departamento del servicio de cliente en 888 775-0202 para pedir el tablero del reemplazo LED con un representante.
OPERATING YOUR WINE COOLER
Antes de quitar la bombilla, d vuelta apagado al Enfriadora de vinos primero y despus desenchufe la unidad del enchufe de pared. La falta de hacer tan poda dar lugar a choque elctrico o a daos corporales. Utilice el destornillador Phillips para tomar hacia fuera atornillan. Quite la cubierta ligera transparente tirando hacia abajo suavemente. Saque los dos conectadores y quite el tablero del LED. Substituya por un nuevo tablero del LED que sea la misma forma y tamao. Substituya la cubierta ligera transparente y apriete el tornillo.

Changing The Inner Light

Temperature Control
Prior to changing the inner light of the wine cooler, please contact our Customer Service Dept. at 888 775-0202 to order replacement LED board with a representative.
Your wine cooler has one control panel for regulating the temperature. The temperature control panel is located on the left center of the wine cooler. To turn on the wine cooler, press the Power button located on the control panel. If correctly powered on, a green light will illuminate the Power button. The temperature of the wine cooler is pre-set by the manufacturer at 54F (12C). To increase or decrease the temperature to desired level, press + or - button on the control panel to adjust the temperature setting. The wine cooler uses semi-conductor cooling technology. For optimal performance of the appliance, we recommend that the wine cooler be installed in a location where the ambient temperature will be between 55F (12.8C) ~ 77F (25C). The operating temperature range of the wine cooler temperature control is from 46F (8C) ~ 65F (18C), +/- 3C. Please be advised that the ambient temperature of the wine cooler will affect the internal temperature of the cooler. Cooler ambient temperature will result in a cooler operating internal temperature and warmer ambient temperature will result in a warmer operating internal temperature. To select Celsius (C) or Fahrenheit (F), press the Temp button on the operation panel. Temperature Recommendations: Red Wine: 57F ~ 65F (14C ~ 18C) White Wine: 48F ~ 54F (9C ~ 12C)
If the unit is unplugged, loses power; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the wine cooler may not start. If there are no items inside the wine cooler, it may take approximately 3 ~ 4 hours to reach the desired temperature setting. The wine cooler is designed to fit eight standard unopened wine bottles. Bottles of different sizes or opened bottles may need to be positioned at different angles and therefore affect the storage capacity of the wine cooler.

Energy Saving Tips

Moving Your Wine cooler

Vacation Time

Cleaning Your Wine cooler

CARE AND MAINTENANCE

Upon installation of your new appliance, it is recommended that it be cleaned thoroughly. Turn off the wine cooler first and then unplug the unit from the wall outlet. Remove all contents. Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. Be sure to keep the door gasket (seal) clean to keep the unit running efficiently. The outside of the wine cooler should be cleaned with mild detergent and warm water. Dry the interior and exterior with a soft cloth. Dust or anything else blocking the vent may hinder the cooling efficiency of the wine cooler. Vacuum the vent if necessary. Clean the air filter net every three months.
The wine cooler should be located in the coolest area of the room, away from heat producing appliances or heating ducts, and out of the direct sunlight. Ensure that door is closed when the wine cooler is turned on.
Turn off the wine cooler first and then unplug the unit from the wall outlet. Remove all the contents. Clean the wine cooler. Leave the lid open slightly to avoid possible formation of condensation, mold, or odors. Short vacations: Leave the wine cooler operating during vacations of less than three weeks. Long vacations: If the appliance will not be used for several months, remove all content and unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave the door open slightly: blocking it open if necessary.
Turn off the wine cooler first and then unplug the unit from the wall outlet. Remove all the contents. Securely tape down all loose items inside your wine cooler. Tape the doors shut.

CUIDE Y LA CONSERVACION

PARA LIMPIAR SU ENFRIADORA DE VINOS
Una vez finalizada la instalacin, se recomienda una limpieza completa de la unidad. D vuelta apagado al enfriadora de vinos primero y despus desenchufe la unidad del enchufe de pared. Quite todo el contenido. Limpie el interior con un pao humedecido en una solucin de agua tibia y bicarbonato de soda. La solucin se prepara con aproximadamente 2 cucharadas de bicarbonato de soda y un cuarto de agua. Recuerde mantener limpia la junta de la puerta (burlete) para que la unidad funcione correctamente. La parte exterior del enfriadora de vinos se debe limpiar con una solucin de agua tibia y detergente suave. Seque el interior y exterior con pao suave. El polvo o cualquier cosa que bloquea el respiradero puede obstaculizar la eficacia que se refresca del enfriadora del vino. Limpie el respiradero con la aspiradora en caso de necesidad. Limpie la red del filtro de aire cada tres meses.

PROBLEM Wine cooler does not operate.
You can solve many common wine cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling for service.

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE Not plugged in. The circuit breaker tripped or a blown fuse. Temperature control is set too warm. Turn the control to a cooler setting and allow several hours for the temperature to stabilize. Door is kept open too long or is opened too frequently. Warm air enters the wine cooler every time the door is opened. Open the door less often. The door is not closed completely. The door gasket does not seal properly. The wine cooler has recently been disconnected for a period of time. 4 hours are required for the wine cooler to cool down completely. Temperature control is set too cold. Turn the control to a warmer setting and allow several hours for the temperature to stabilize. Check to assure that the wine cooler is on a level surface. The wine cooler is touching the wall. Re-level the wine cooler and move it from the wall. If continued vibration occurs, turn off the wine cooler and unplug the power plug. Contact Customer Service Dept. for further assistance. Door is slightly open. Door is kept open too long, or is opened too frequently. Open the door less often. The door is not sealed properly. Door is slightly open, causing cold air from inside the wine cooler to meet warm moist air from outside. The wine cooler is not on a level surface. The gasket is dirty.
Se forma humedad en las paredes externas del enfriadora de vinos La puerta no cierra convenientemente.
The door will not close properly.
Moisture forms on outside of wine cooler.
Moisture forms on inside wine cooler walls.

Vibrations.

Temperature inside the wine cooler is too cold.
Temperature inside the wine cooler is too warm.
For Service or Assistance please call 888 775-0202. Or visit us on the web at www.magicchef-ewave.com to request warranty service.
This warranty covers appliances in use within the continental United States, Puerto Rico and Hawaii. The warranty does not cover the following:
MC Appliance Corporation warrants each new Wine cooler to be free from defects in material and workmanship and agrees to remedy any such defect or to furnish a new part(s) (at the companys option) for any part(s) of the unit that has failed during the warranty period. Parts and labor expenses are covered on this unit for a period of one year after the date of purchase. A copy of the dated sales receipt / invoice is required to receive warranty service or a refund.
This warranty is in lieu of all warranties expressed or implied and no representative or person is authorized to assume for us any other liability in connection with the sale of this product. Under no circumstances is the consumer permitted to return this unit to the factory without prior written consent from MC Appliance Corporation.