Regenerator Suggested Settings

RG-1 Regenerator

FLY BY (Amp: Clean)

SHIMMER (Amp: Clean)

Marshall Amplification plc
Denbigh Road, Bletchley, Milton Keynes, MK1 1DQ, England. Tel : +44 (0)Fax : +44 (0)www.marshallamps.com
Whilst the information contained herein is correct at the time of publication, due to our policy of constant improvement and development, Marshall Amplification plc reserve the right to alter specifications without prior notice. 9 / 05
LOOK AROUND YOU (Amp: Clean)

Owners Manual

SWIRLIVERSE (Amp: Clean)

WARNING! 8

IMPORTANT Precautions
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

WARNING

From The Chairman
I would like to personally thank you for selecting one of our effects pedals. For over 40 years the Marshall name has been synonymous with the greatest guitar tones in music. We have worked hand in hand with guitarists from all levels throughout the world to maintain and improve that special ingredient, The Marshall Sound. Our range of effects pedals gives the opportunity to augment the classic Marshall tone to add Marshall character to a guitar set-up.
Do not expose the apparatus to rain or moisture. Do not expose the apparatus to dripping or splashing. No objects filled with liquids should be placed on or near the apparatus. Do not use this apparatus near water.
Clean only with dry cloth.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by Marshall Amplification plc could void the users authority to operate the equipment.
All our pedals are made with the same utmost attention to quality, in both materials and manufacture as our world renowned amplifiers, cabinets and combos, in order to provide you with optimum reliability and tone. I would like to wish you every success with all of your musical endeavours and also your new Marshall effects pedal, which I am sure you will find a pleasure to play for many years to come. Yours Sincerely,

European Product Only 1

ENGLISH
Heed all warnings. Follow all instructions. Keep these instructions.

Introduction

The Regenerator RG-1 is every modulation pedal you'll need in one package. It is a stereo modulation pedal recreating six different modulation modes for you to explore giving you full control over the modulation time, modulation depth and regeneration of every mode creating a truly awesome stereo sound field. Below is a complete run down of the Regenerator's features for your information. We have also enclosed a number of suggested settings to help guide you. It should be remembered that these are only suggested settings and you should really experiment as much as possible.

Setting Up

Always use good quality shielded leads. Always use 9V regulated DC supply with centre negative rated at 80mA or above. Although it may seem obvious the first action in achieving a good effected sound (be it duration / compression etc.) is to find the perfect bypassed sound. This will then allow the correct level to be set with the effect unit to allow a cut or boost in volume and a realistic tone. On clean channels it is advisable to set the gain (or volume) to a setting of no less than one quarter maximum so as not to get unrealistic results due to any volume dependent tonal shaping on the amplifier preamp.

Features

1. 'In' Jack Socket
This is the input jack for connection to your guitar or to the output of another effects pedal when linking pedals together.

2. 'Expression' Socket

An expression pedal can be connected to this socket to control the modulation speed. Moving the pedal overrides the speed control on the pedal allowing you to increase/decrease the control as you perform.
3. 'Out 1 / Left' Jack Socket - Passive Bypass
Out 1 is connected to a passive bypass circuit. The passive bypass ensures complete tonal integrity by disconnecting the output of the effects circuit when not in operation. When a jack is connected to Out 1 the pedal operates in mono mode.

Step Phaser

Adding a crystal staircase effect to the phaser mode allows you to trip around its sweeping textures. Get those good vibrations with this swirling vintage vibe mode.

Vintage Vibe

4. 'Out 2 /Right' Jack Socket - Spill-Over
Out 2 is connected to a spill-over circuit. When the pedal is switched off and the regen it has produced is allowed to 'spill' and rapidly decay over your playing while the input feeding the effects circuit is switched off. When a jack is connected to Out 2 the pedal operates in mono mode. When jacks are connected to Out 1 & Out 2 the pedal operates in Stereo mode, the 2nd output's phase is inversed creating an even more spacious modulation.

6. Speed

Controls the speed of the modulation tail from fully anticlockwise, providing slowly sweeping sounds, to fully clockwise, generating fast vibrato.

7. Depth

Controls the amount of modulation applied to the signal. For the vintage chorus, multi chorus and vintage flanger this controls the amount of delay between the direct sound and processed, greater depths causing a greater amount of detuning. For the phaser, step phaser and vintage vibe this controls the range of frequencies that are swept by the filters.

5. Mode

The Regenerator offers six different modulation modes. Selected by switching the mode knob in to one of the six positions. Vintage Chorus A classic chorus, adding mellow sweeps to high speed vibrato and everything in between to your sound. Multi Chorus Based upon Marshall's classic Supervibe pedal, its unique sweeping pattern allows you to create simple sweeps through to complex ensemble sounds.

8. Regen

Controls the level of the regeneration, the amount of effect sent back to the input. Fully anti-clockwise means no signal is sent back, while fully clockwise sends gives the most signal back accentuating the sound of the modulation sweeps.

9. Foot Switch

For switching the Regenerator on and off.

10. LED

Indicates when the Regenerator is in operation.
Vintage Flanger The versatile vintage flanger let's you go deep and detune your sound to extremes, turn up the regen for it to soar across your sound, or hold back to create natural flange effects. Phaser A rich phasing effect making your sound swell with energy, creating fluid waves which wash around your tone.

11. DC Input

For input of a 9V DC centre negative regulated adaptor should you not wish to use batteries.

Trouble Shooting

CHECK PEDAL CONTROLS CHECK GUITAR

Battery Replacement

1. To replace the battery, open the easily accessed coin screw battery cover plate by loosening screw as shown, then disconnect the battery connector lead. 2. Use PP3 or equivalent battery (for improved battery life use alkaline type). 3. Always ensure that the battery is removed when the pedal is not in use for long periods. 4. Dispose of old battery in a safe place.

WHAT IF NO OUTPUT NOISE IN BYPASS INDICATOR LED NOT ON SOUND TOO TREBLY OR FIZZY SOUND TOO MUSHY OR BASSY UNUSUAL FEEDBACK

INPUT LEAD

REDUCE TREBLE

CHECK AMP CONTROLS

DC INLET

CHECK BATTERY

CHECK LEADS

Technical Specification

Power: 9V DC Centre Negative Regulated Minimum Current Draw: 80mA Controls: Mode, Speed, Depth, Regen Switches: On/Off Switch Indicators: On/Off LED Jacks: 2 Input, 2 Output 'Jack sockets' Input Impedance: 1M Output Load Impedance: < 1k Dimensions: 120mm x 65mm x 55mm Weight: 510 grammes

UNUSUAL HUM

MOVE AWAY FROM AMP

PICKUPS MAY BE VIBRATING

BASS FEEDBACK

Price List September 2010
MODEL MODELE DESCRIPTION RETAIL PRICE PRIX DE VENTE INDICATIF

AS50D AS100D PEDL10001

ACOUSTIC SOLIST COMBOS: 50 watt acoustic combo w/ digital effects 2 x 50 watt 4 channel acoustic combo Single foot switch w/ LED status light for AS100D

$499.00 $875.00 $52.00

MG4 Series
New MG2FX MG10-MSH MG15 New MG15R MG15FX MG30FX MG50FX MG101FX MG102FX MG100HFX MG412A MG412B PEDL90008 PEDL90010 COVR00009
2 watt AC/DC busker amp w/ digital effects 10 watt 2 channel combo with 6" speaker 15 watt 2 channel combo with 8" speaker 15 watt 2 channel combo with reverb & 8" speaker 15 watt 4 channel combo with effects and 8" speaker 30 watt 4 channel combo with effects and 10" speaker 50 watt 4 channel combo with effects and 12" speaker 100 watt 4 channel combo with effects and 12" speaker 100 watt 4 channel amp with built in effects and 2 x 12" speakers 100 watt 4 channel head with effects 100 watt 4 x 12 angled speaker cabinet 100 watt 4 x 12 straightspeaker cabinet Stompware Assignable foot switcher for MG4 amps with built in tuner 2 way footswitch for MG50FX, MG100HFX, MG101FX,MG102FX Cover / Carrying bag for MG2FX
$165.00 $119.00 $165.00 $179.00 $249.00 $315.00 $525.00 $599.00 $659.00 $499.00 $415.00 $415.00 $65.00 $38.00 28.95
COVR00089 COVR00090 COVR00091 COVR00092 COVR00093 COVR00094 COVR00095
MG15FXMS New MG15FXMSDM PEDL90004
Vinyl cover for MG10 Vinyl cover for MG15 & MG15FX Vinyl cover for MG30FX Vinyl cover for MG50FX Vinyl cover for MG101FX Vinyl cover for MG102FX Vinyl cover for MG100HFX
Microstack pack including MG15FX head with spring reverb & a pair of 1 x 10 cabinets (top cab is slanted just like the big boys) Dave Mustaine Signature mini stack w/ picks, Megadeath sweatband, stickers, tour laminates, etc Dual footswitch for MG-DFX models
$25.00 $30.00 $38.00 $45.00 $48.00 $60.00 $48.00

$499.00 $629.00 $65.00

MARSHALL FX PEDALS: Echohead stereo echo pedal w/ 6 modes Stereo modulation pedal w/ 6 modes Reflector reverb pedal w/ 6 modes Vintage Vibrato/Tremolo Guvnor Plus / Overdrive Bluesbreaker II - Drive/Boost Jackhammer / Ultra-gain overdrive Compressor - Compressor/ Sustainer Metal FX POP display/demo board with power supply and setting charts * Free with the purchase of one set of 6 Marshall pedals and at least 3 back-ups PB8 Metal FX POP display with all 8 Marshall pedals hard wired in PSU400 Regulated power supply for FX pedals and pedal displays MT-1 Marshall Digital guitar/bass tuner * check with sales rep regarding special box lot price for 20 pc box EH-1 RG-1 RF-1 VT-I Vibratrem GV-2 BB-2 JH-I ED-1 PB6 * MICRO AMPLIFIERS: Micro Amp (Black) Micro Amp (Red) Micro Amp (Classic) Micro Stack MB BASS SERIES: 15 watt Bass combo, 1 x 8" speaker 30 watt bass combo, 1 x 10" speaker
$144.00 $144.00 $144.00 $95.00 $89.00 $95.00 $89.00 $89.00 $99.00 $999.00 $19.95 $19.95

MS-2 MS-2R MS-2C MS-4

$55.00 $55.00 $55.00 $65.00

MB15 MB30

$165.00 $239.00
MODEL MODELE DESCRIPTION RETAIL PRICE PRIX DE VENTE INDICATIF $579.00 $769.00 $649.00 $1,099.00 $899.00 $449.00 $639.00 $1,099.00
MBwatt bass combo w/ 1 x 12" speaker & compression MBbass combo w/ 1 x 15" speaker & compression MB450H 300 watt MB Bass head MBwatt bass combo w/ 4x10" speakers MBwatt bass combo w/ 2x10" speakers MBCwatt bass cab, single 15" speaker MBCwatt bass cab, 4 x 10" speakers MBC810 1,200 watt bass cab, 8 x 10" speakers * box lot discount may be applied to all orders that include at least the MB450H and one of the MB bass cabinets above DUST COVERS FOR MB SERIES AMPS AND CABINETS Vinyl dust cover for MB15 combo Vinyl dust cover for MB30 combo Vinyl dust cover for MB60 combo Vinyl dust cover for MB150 combo Vinyl dust cover for MC115 cabinet Vinyl dust cover for MB450 head Vinyl dust cover for MB4410 combo & MBC410 cabinet WARRANTY STATEMENT Five year limited warranty, One year limited warranty on speakers, 180 day limited warranty on tubes and fuses
COVR00075 COVR00076 COVR00077 COVR00078 COVR00079 COVR00080 COVR00081

$52.00 $57.00 $65.00 $70.00 $82.00 $56.00 $82.00
MS-Series micro amps and Marshall effects pedals warranted foone year
for defects in materials and workmanship The MSRP "Manufacturer's Suggested Retail Prices" referred to herein are only suggestions. You are under no obligation to accept these suggestions and you will in no way suffer in our business relations (or in your relations with any other persons) should you decide not to accept these suggestions. Prices do not include GST or PST. Specifications and prices are subject to change without prior notice.