Figyelem! vni az estl s a nedvessgtl. POZOR! Chrate ped detm a vlhkem. BEMRK!Skal beskyttes mod regn og fugtighed Varning! Skyddas frn regn och fukt.
Elektromos kbelt a pengto^l tvoltartani Elektrick snra mus byt' d'aleko od rezacieho nstroja. Tag stikket ud af stikkontakten, inden der rres ved kniven. Innan ngot som helst ingrepp p klippningsverktyget sker, tag ut kontakten fr elektrisk matning.

ENGLAND

DESCRIPTION IJ=HJI=JF=CA!#
Upper handles Lower handles Fastening knobs for upper handles Grass catcher Oil filler cap Oil drain plug Deck Adjusting cutting height Spark plug Fuel cap Engine start-grip Rear deflector Throttle lever Engine stop lever Reduction gear Clutch lever

B C D E F G H I J K L

ASSEMBLY OF GRASS CATCHER IJ=HJI=JF=CA!#

'If applicable'

ASSEMBLY REAR DEFLECTOR IJ=HJI=JF=CA!#

ASSEMBLY IJ=HJI=JF=CA!$

Manual lawn mower Assemble the handle and fit the brake lever with the pin and clip provided, assemble wheels as shown and throttle if supplied.
ASSEMBLY IJ=HJI=JF=CA!% ADJUSTMENT OF CUTTING HEIGHT IJ=HJI=JF=CA!&
When fitting and adjusting the wheels tilt the machine slightly. Do not tilt the machine more than 30 when fitting or adusting the wheels
Self-Propelled Assemble the handle and fit the levers with pins and clips provided, assemble wheels as shown and throttle if required.
SAFETY PRECAUTIONS IJ=HJI=JF=CA!&
l Always operate with the deflector or grasscatcher in the correct position. l Always stop the engine before removing the grasscatcher or adjusting the height of cut. l Never place your hands or feet underneath the deck or into the rear grass discharge chute while the engine is running.

IJ=HJI=JF=CA!&

Before mowing, remove all foreign objects from the lawn which may be thrown by the machine. While mowing, stay alert for any foreign objects which may have been missed. Never lift the rear of the mower while starting the engine or during normal operation.
Never place your hands or feet underneath the deck or into the rear discharge chute while the engine is running.
OPERATION IJ=HJI=JF=CA!&

ENGINE ADJUSTMENTS

Refer to the engine manufacturer's maintenance manual. CAUTION:- 0.6l Oil must be added to the engine before use.

IJ=HJI=JF=CA!'

STARTING THE ENGINE
Once the machine has been set up properly, start the engine as follows: a) Engines with choke system: when the engine is cold, position the accelerator lever (13) on START b)Operate the engine stop lever (14) to prepare the engine for start, keep lever pressed against handle while starting and using the machine - it operates the engine brake. c) Engines with primer system: Press the fuel-enrichment pump (Picture 'K' item 27) located on the carburettor 3 or 4 times position the accelerator lever (13) on MAX. For further information and explanations, read carefully the user instruction manual of the engine. d) Start engine. MANUAL STARTING: (While holding the engine stop lever (14)). lHold the engine start-grip (11) and pull the starter rope gently until you feel the resistance caused by compression. Return the starter rope slowly then pull the handle firmly towards you to its full extent.

MOWING

Keep the engine stop lever (14) depressed during machine operation. When the lever is released, the engine stops.
To cut the grass, push the lawn mower manually
How to insert automatic advance: Lift up the clutch handle (16) and keep it pressed in position. CAUTION: Engage the gear only when the engine is running. How to disengage advance: Release the clutch handle.
Keep the engine stop lever (14) depressed during machine operation. When the lever is released, the engine stops. To cut the grass, push the lawn mower manually or insert the automatic advance gear.
Important: If, when you press the clutch lever, the automatic advance gear does not engage, the clutch cable should be adjusted by inserting the spring (P) in one of the subsequent holes (R).
AUTOMATIC ADVANCEMENT IJ=HJI=JF=CA!'
Periodically check the automatic advance assembly and make sure to keep it clean. In particular, the pinion (17) and the gear (18) must be kept perfectly clean. To carry out this check, you must remove the wheel (19) by unscrewing the screw (20). IMPORTANT - Once the product has fuel or oil in the tanks do not tilt the machine at an angle of more than 30.

SAFETY RULES

Training
a)Persons under 16 years of age and persons who are not familiar with the user instructions must not use the lawn mower. b)The operator is responsible for the safety of other people in the working area. Keep children and domestic animals at a safe distance when the lawn mower is in use. c)This machine is to be used exclusively for cutting natural grass. Never use the mower for other purposes (e.g., for flattening out bumps in the ground, such as mole-hills or ant- hills). d)Work only when there is sufficient light. e)Before mowing, remove all foreign objects from the lawn which may be thrown by the machine. While mowing, stay alert for any foreign objects which may have been missed. l Refuel outdoors only and do not smoke while refuelling. l Fill up the fuel tank before starting the engine. Under no circumstances open the fuel tank cap or add petrol when the engine is running or when it is still hot. l If the petrol has overflowed, do not under any circumstances start up the engine.Move the mower away from the area where fuel has bean spilt and avoid any source of possible ignition until the petrol fumes have dissipated. l Replace the fuel tank cap and tighten it down firmly. e)Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. f) When mowing, never run; you must always walk. g)Exercise extreme caution when turning or when pulling the lawn mower towards you. h)Particular precautions must be taken when mowing on slopes or downhill stretches: lUse appropriate antislip footwear. l Always be sure of your footing. l Mow across the face of slopes, never up or down. l Take great care when changing direction. lDo not mow on excessively steep slopes. i)Never use the lawn mower unless the guards and safety devices (e.g. deflector, grass catcher) are securely in position and in good condition. j)Ensure that the grass catcher and deflector are correctly located. failure to do so may result in foreign objects being ejected by the blade. k)For reasons of safety, the engine must never exceed the speed. (r.p.m.) indicated on the label. l) Take care when starting the engine and be sure to follow the user instructions. Never place your hands or feet underneath the deck or into the rear discharge chute while the engine is running. m) Never lift the rear of the mower while starting the engine or during normal operation. n) If the blade happens to hit any obstacle, stop the engine at once and remove the spark plug cap. Then get an expert to examine the blade.

Maintenance and storage

a)Make sure that all nuts, bolts, and screws are kept well tightened to keep the mower in a safe operating condition. b)Never leave the machine with fuel in the tank within an enclosed area where the fuel vapours could reach naked flames or sparks. c)Allow the engine to cool before storing in any enclosure. d)Keep the engine, silencer, battery compartment and petrol tank free from grass, leaves and excess lubricant, in order to reduce the danger of fire. e)Frequently check the grass catcher for wear or deterioration f)For safety reasons, be sure to replace worn-out or damaged parts in due time. g)If the fuel tank has to be drained, it is essential that this be done outdoor. h)Assemble the blades following the corresponding instructions and use only blades bearing the maker's name or the trademark of the manufacturer or supplier and marked with the reference number. i)To protect hands during disassembly or assembly of the blades, it is absolutely essential to wear suitable protective gloves.
Setting up and operating the lawn mower
a)When mowing, wear strong footwear (boots or heavy shoes) and long trousers. b)Before you start mowing, make sure that the blade and blade fixing screw are securely fastened. If the blade is damaged, it must be replaced. c)Turn off the engine, wait until the blade has stopped and remove the spark plug cap before: l transporting, lifting or moving the machine away from the working area; l carrying out maintenance or cleaning, or when carrying out any operation on the blade; l adjusting the cutting height; l leaving the machine unattended. Caution! The blade starts turning as soon as the engine is started d)Caution! The fuel is highly inflammable: lStore fuel in containers specifically designed for this purpose.

MAINTENANCE

Caution! Switch off the motor and disconnect the spark plug before undertaking any maintenance work.
lFor a four stroke engine, check the oil level and change the oil when dirty. For further explanation, see ENGINE INSTRUCTION BOOK. lFrequently check the mower and ensure that all grass deposits are removed from beneath the deck. lNever clean the mower by pouring water over it: this may seriously damage the electric start system.
lTake care, the exhaust muffler may be very hot. lFrequently remove the wheel screws clean whith petroleum and oil before replacing. Ball bearings must be greased before remounting. lFrequently check the blade for damage. lThe lawn mower must be checked by a SERVICE DEALER.

BLADEIJ=HJI=JF=CA!'

lWhen reassembling, make sure that the key (25) is correctly seated in the shaft and that the cutting edges face in the direction of the engine rotation. The blade screw (22) must be torqued to 5,34 Kgm (52,4 Nm).

lTo remove the blade (21) unscrew the screw (22). lCheck the conditions of the blade-support (23), the washer (24), the key (25) and the washer (26) and replace any parts which are damaged.