Reviews & Opinions
Independent and trusted. Read before buy Miele KM 500!

Miele KM 500

Manual

Preview of first few manual pages (at low quality). Check before download. Click to enlarge.
Manual - 1 page 

Download (English)
Miele KM 500 Cooking Table, size: 164 KB
Instruction: After click Download and complete offer, you will get access to list of direct links to websites where you can download this manual.

About

Miele KM 500About Miele KM 500
Here you can find all about Miele KM 500 like manual and other informations. For example: review.

Miele KM 500 manual (user guide) is ready to download for free.

On the bottom of page users can write a review. If you own a Miele KM 500 please write about it to help other people.

 

[ Report abuse or wrong photo | Share your Miele KM 500 photo ]

User reviews and opinions

<== Click here to post a new opinion, comment, review, etc.

No opinions have been provided. Be the first and add a new opinion/review.

 

Documents

doc1

Installation Instructions
KM 400 Electric Cooktop KM 402 / KM 403 Fryer KM 408-1 Contact Grill KM 410 / KM 411 Electric Barbecue
To prevent accidents and machine damage, read these instructions before installation or use.

M.-Nr. 863

Contents
IMPORTANT SAFETY INSTRUCTIONS. 4 Installation. 4 Safety distance above the appliances. 5 Appliance dimensions. 6 KM 400 / KM 408-1. 6 KM 402 / KM 403. 7 KM 410 / KM 411. 8 Installation. 9 Cutting out the countertop. 9 Laying out the support bars and clamps. 10 Securing the support bars. 11 Wood or Corian countertops. 11 Granite countertops. 11 Securing the spring clamps. 11 Wood or Corian countertops. 11 Granite countertops. 11 Locking the appliance into place. 12 Electrical connection. 14
IMPORTANT SAFETY INSTRUCTIONS
Note to the installer: Please leave this instruction book with the consumer for the local electrical inspectors use.

Installation

The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire. To prevent appliance damage, the cabinetry and venting hood should be installed first. The countertop must be bonded with heat resistant (212 F/100 C) adhesive to prevent distortion. The cooktops should only be installed in the illustrations, while maintaining the required safety distances shown. Do not install the cooktop between two tall cabinets, this is a fire hazard. a = Minimum safety distances: KM 400 = 2" (50 mm) KM 402 / 403= 2" (50 mm) KM 408-1 = 2" (50 mm) KM 410 / 411 =10" (250 mm) Deep fryers must not be installed next to gas cooktops. Gas flames can ignite splattering oil. A distance of at least 12" (305 mm) should be maintained between these two appliances.

recommended

not recommended

not allowed

Cooktops should not be installed above a dishwasher, washer, dryer, freezer or refrigerator. The high temperatures radiated downwards from the cooktops could damage these appliances. This equipment has not been designed for maritime use or for use in mobile installations such as aircraft or recreational vehicles. However, under certain circumstances it may be possible for an installation in these applications. Please contact the nearest Miele Dealer or the Miele Technical Service Department with specific requirements. Make sure that the power cord to the cooktop does not come into contact with any mechanical parts once the cooktop has been installed. Safety distance above the appliances
As a general rule there must be a minimum safety distance of at least 30 inches (760 mm) between the top of the appliance and any cabinet above it, b. The minimum distance of combustible surfaces located above and to the side of the cooktop, c, is 18" (457 mm). If the cabinet manufacturer recommends a different distance, follow that manufacturers recommendation. The minimum safety distance between the KM 410 / KM 411 and the bottom of a venting hood should be no less than 26" (650 mm).
If more than one appliance is installed beneath a hood and they have different minimum safety distances, the greater distance should be followed.
Keep this instruction book in a safe place and pass it on to any future owner.

Appliance dimensions

KM 400 / KM 408-1
a Clamps b Please allow an additional 3/4" (18 mm) depth below the cooktop for clearance of the power cord.

KM 402 / KM 403

a Clamps

KM 410 / KM 411

Cutting out the countertop
Installing one or multiple appliances: Cut out the countertop using the dimensions listed in the following table. Number of cooktops 5 All Miele combisets have the same length and width. Make sure that there is enough room beneath the countertop to allow for the depth of the various appliances. When installing a KM 402 / KM 403 or KM 410 / KM 411 remember to allow clearance for the drain valve that will be located in the cabinet beneath the appliances. Cut out width Dimension "B" 10 13/16" 22 1/8" 33 7/16" 44 13/1/8" 67 1/2" 78 13/16" (274 mm) (562 mm) (850 mm) (1138 mm) (1426 mm) (1714 mm) (2002 mm)
The tolerance for each dimension is 1 /16" (1 mm).
The following safety distances must be maintained: Between the cooktop and rear wall: 2" (50 mm). Between the cooktop and side wall or cabinet: KM 400 = 2" (50 mm) KM 402 / 403= 2" (50 mm) KM 408-1 = 2" (50 mm) KM 410 / 411 =10" (250 mm) Refer to section "Important Safety Instructions" for further information.

When installing more than one combiset cooktop, a support bar must be installed between the appliances. Install the support bars as shown on the following page before setting the appliances into the countertop.
Laying out the support bars and clamps
a Clamps b Support bars This illustration shows the layout for 3 combisets, their respective support bars, b, and the 14 spring clamps, a, required for correct installation. If more than 3 combisets are being installed, add an additional 11 3/8" (288 mm) to the overall width of the cut out for each extra combiset, or use the table on the preceding page.
c Slight gap between support bar and countertop.
Securing the support bars Securing the spring clamps
Wood or Corian countertops ^ Arrange the bars, b, as shown in the illustration ^ Drill 1/16" (1.5 mm) pilot holes through the brackets and secure them using the supplied screws. ^ Fill the gap, c, between the bars and the countertop using the supplied silicon sealant. Wood or Corian countertops ^ Place the spring clamps, a, as shown in the illustration. ^ Drill two 1/16" (1.5 mm) pilot holes for each clamp and secure using the supplied screws.
Granite countertops For granite countertops, the support bars, b, can be secured using double-sided construction tape. Do not allow the bars to "float", they must be securely fastened. Fill the gap, c, between the bars and the countertop using the supplied silicon sealant. The screws are not necessary for granite countertops.
Granite countertops For granite countertops, the spring clamps can be secured using double-sided construction adhesive. Do not allow the spring clamps to "float", they must be securely fastened. The screws are not necessary for granite countertops.
Locking the appliance into place
Make sure the cooktops are aligned correctly before setting them into the countertop. Once the spring clamps are engaged, a special tool is required to release the cooktop from the clamps.
^ Guide the power cord through the cut out and connect the appliance to the electrical supply. ^ Position the cooktop over the cut out. With a hand on each side, above the clamps, a, press the cooktop down, locking it into the spring clamps. Make sure that the cooktop rim lies flat against the countertop on all sides.

Important

The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal for the countertop. If the cooktop is sealed into position, the countertop or the appliance may be damaged if the cooktop needs to be removed for maintenance or service.

Electrical connection

,WARNING: Disconnect the appliance from the main power supply before servicing. To reduce the risk of electric shock, make sure that the appliance is properly grounded after installation. To guarantee the electrical safety of this appliance; continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. The manufacturer cannot be held responsible for damages caused by the lack, or inadequacy of an, effective grounding system. Power supply: 240 V, 60 Hz, 15 A fuse rating or 208 V, 60 Hz, 15 A fuse rating

The oven is equipped with a power cord consisting of 3 leads. They must be connected to a dedicated line through the use of an approved junction box Black : connect to L1 (hot) Red: connect to L2 (hot)
Green: connect to GND (ground): For further information, see the wiring diagram provided with the appliance.
All electrical work should be performed by a qualified electrician in accordance with local codes and the: National Electrical code ANSI / NFPA No. 70-1481 for USA
WARNING: THIS APPLIANCE MUST BE GROUNDED
or - Canadian Electrical Code Part I (CSA Standard C 22.1) for Canada Note to the installer: Please leave these instructions with the consumer.
Alterations rights reserved / 0705

M.-Nr. 863 / 01 en - US

 

Tags

Motorola V3IE Comfort Handheld TX-22LT2F TA-N55ES XC-L7 Euro 8 HK32V001 Panasonic A100 HL-6050 TT8020 Crystal 650 Motorola V980 KDC-W410A LN26B350f1 BHP452Z MY521X PCV-LX900 CDP-C515 Se400S P3500 Psma0 DSC-W220 D 42 PS42A410c1 KV-29LS40K Prophecy ST-S3000ES DAP70 MT36AH Lunea OM-4TI 11 Home 2430-402 XG-NV6XU TH-42PX10 200 VOX TL-WR642G Wbr-6002 CT470 Timex W-89 T5100 MS8127C Seiko 4S15 MS9047C Panda RHT600R P4V800-X KAC-7201 AX4bpro Displays IC-3AT Illustrator 10 Baseball 2004 Voicemailpro Photosmart 318 SGH-C210 Magic WBR-G54 Review Nikkor Breadmaker PRO 3880 Vhrm439 QW1202H STR-K990 C500N TCS665E NV-MC20B Fostex E-16 Presario 5000 VL-E610S PMA-2000R KS-F105 1600F Analyser Easyshare CD33 WA63121 DR-90 Airis L115 WD6400H1q-00 VSX-D814 Estate F5D7632 TH-50PX600EN ATB10AT MS9017C 48245 HL-6050DN Factor PC IC-706mkiig AX-1050 EW878F KX-TG2257S DVP-NS76H F880D10D EMX860ST DMC-J3 Humminbird RF15 KX-TG8301PD PX650

 

manuel d'instructions, Guide de l'utilisateur | Manual de instrucciones, Instrucciones de uso | Bedienungsanleitung, Bedienungsanleitung | Manual de Instruções, guia do usuário | инструкция | návod na použitie, Užívateľská príručka, návod k použití | bruksanvisningen | instrukcja, podręcznik użytkownika | kullanım kılavuzu, Kullanım | kézikönyv, használati útmutató | manuale di istruzioni, istruzioni d'uso | handleiding, gebruikershandleiding

 

Sitemap

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101