Product Dimensions

Large Capacity Washing Machine Angled control W3033 / W3035

2" 23 1/

21 1/ 2"

22 1/ 2"

33 3/8" - 34 1/8"

3 3/4"

- 4 1/2

"

2"
Location Codes D - 5 foot flexible drain hose connects upper left rear. E - 120 Volt, 15 Amp 5 foot molded plug power supply connects upper left rear (NEMA 5-15 Configuration). W - 5 foot separate flexible hot and cold water intake hoses connect upper left rear. Notes All installations must be done in accordance with local codes See "Cut-out Dimensions" sheet for undercounter or built-in space requirements Remove transport struts in rear of machine before installation.
NOTE: Drawing is not to scale. SPECIFICATION SHEETS 010107
Large Capacity Washing Machines Flat controls - Decor Unit W3039

Decor White

5 7/8 "

1 1/2 "

Cut-out Dimensions
Built-in Installations Large Capacity Laundry Products

See N otes

32 3/8" - 35 1/4"
ric Elect ter & ction Wa e Conn tion oca L

24"

Location Codes C - Cutout for Electric and Vent or Drain pass-through. Adjust according to duct or drain location. Notes Typically requires removal of unit's lid. Out of box unit height dimension without lid is 32 5/16" - 32 11/16".
Laundry Stand WTS420 - White Only

22"

8" 23 3/
Notes For use with both large and super capacity washers or tumble dryers. All installations must be done in accordnace with local codes

11"

Stacked Washer & Dryer Example Combination W3033 + T8002
66 3/8" - 67 1/8"
Location Codes 5 foot flexible drain hose connects upper left rear. E1 - 120 Volt, 15 Amp 5 foot molded plug power supply connects upper left rear (NEMA 5-15 Configuration). E2 - 208/240 Volt, 30 Amp 5 foot molded plug power supply connects upper right rear (NEMA 14-30 Configuration). W - 5 foot separate flexible hot and cold water intake hoses connect upper left rear. Notes All installations must be done in accordance with local codes See "Cut-out Dimensions" sheet for undercounter or built-in space requirements Remove transport struts in rear of machine before installation.

Panel Information

Integrated Laundry W3039 Decor Unit
These units come equipped with a full size white front panel. These units are also designed to either accept a thin insert or a custom front panel supplied by the custom cabinet maker. Sizes are as follows: Version 1 - Thin insert Width: Thickness: Height: 23 1/4" for all machines up to 1/8" 25" in all cases

Miele Decor Laundry unit

With this version, a thin white frame will be exposed after installation Version 2 - Custom Front Panel Width: Thickness: Height: 23 3/8" for all machines up to 3/4" Up to 25"
With this version, the existing front panel is removed and replaced by the new custom panel

Hinge Notches

In certain installations, notches will be required to accomodate the hinges in the front panel.

Notch Pattern

For this installation, drill the following pattern in the appropriate locations.
Control Panel 3 7/8"
7/8" 1/4" 1"

Miele Decor Laundry

16 3/4" 1 3/8"
To center lines 1/4"

1"

To insure access to customer servicable features, a minimum 4" toe kick above finished floor (AFF) is required.
1 1/8" Drill all holes to a 5/8" depth NOTE: Drawing is not to scale. SPECIFICATION SHEETS 010107