Chapter 2 Introduction
Congratulations on your purchase of the NETGEAR 54 Mbps Wireless Router WGR614 v6. The WGR614 v6 router provides connection for multiple computers to the Internet through an external broadband access device (such as a cable modem or DSL modem) that is normally intended for use by a single computer. This chapter describes the features of the NETGEAR 54 Mbps Wireless Router WGR614 v6.

Key Features

The 54 Mbps Wireless Router WGR614 v6 with 4-port switch connects your local area network (LAN) to the Internet through an external access device such as a cable modem or DSL modem. The WGR614 v6 router provides you with multiple Web content filtering options, plus browsing activity reporting and instant alerts via e-mail. Parents and network administrators can establish restricted access policies based on time-of-day, Web site addresses and address keywords, and share high-speed cable/DSL Internet access for up to 253 computers. In addition to the Network Address Translation (NAT) feature, the built-in firewall protects you from hackers. With minimum setup, you can install and use the router within minutes. The WGR614 v6 router provides the following features: 802.11g wireless networking, with the ability to operate in 802.11 b-only, 802.11g-only, or 802.11b+g modes. Easy, Web-based setup for installation and management. Content Filtering and Site Blocking Security. Built in 4-port 10/100 Mbps Switch. Ethernet connection to a wide area network (WAN) device, such as a cable modem or DSL modem. Extensive Protocol Support. Login capability. Front panel LEDs for easy monitoring of status and activity.
Introduction 202-10099-01, April 2005
Reference Manual for the 54 Mbps Wireless Router WGR614 v6
Flash memory for firmware upgrades.
802.11g Wireless Networking
The WGR614 v6 router includes an 802.11g wireless access point, providing continuous, high-speed 54 Mbps access between your wireless and Ethernet devices. The access point provides: 802.11g wireless networking at up to 54 Mbps. 802.11g wireless networking, with the ability to operate in 802.11g-only, 802.11b-only, or 802.11g and b modes, providing backwards compatibility with 802.11b devices or dedicating the wireless network to the higher bandwidth 802.11g devices. 64-bit and 128-bit WEP encryption security. WEP keys can be generated manually or by passphrase. WPA-PSK support. Support for Wi-Fi Protected Access (WPA) data encryption which provides strong data encryption and authentication based on a pre-shared key. Wireless access can be restricted by MAC address. Wireless network name broadcast can be turned off so that only devices that have the network name (SSID) can connect.
A Powerful, True Firewall with Content Filtering
Unlike simple Internet sharing NAT routers, the WGR614 v6 is a true firewall, using stateful packet inspection to defend against hacker attacks. Its firewall features include: Denial of Service (DoS) protection. Automatically detects and thwarts DoS attacks such as Ping of Death, SYN Flood, LAND Attack, and IP Spoofing. Blocks unwanted traffic from the Internet to your LAN. Blocks access from your LAN to Internet locations or services that you specify as off-limits. Logs security incidents. The WGR614 v6 will log security events such as blocked incoming traffic, port scans, attacks, and administrator logins. You can configure the router to E-mail the log to you at specified intervals. You can also configure the router to send immediate alert messages to your E-mail address or E-mail pager whenever a significant event occurs.
2-2 202-10099-01, April 2005 Introduction
The WGR614 v6 prevents objectionable content from reaching your computers. The router allows you to control access to Internet content by screening for keywords within Web addresses. You can configure the router to log and report attempts to access objectionable Internet sites.

Security

The WGR614 v6 router is equipped with several features designed to maintain security, as described in this section. Computers Hidden by NAT NAT opens a temporary path to the Internet for requests originating from the local network. Requests originating from outside the LAN are discarded, preventing users outside the LAN from finding and directly accessing the computers on the LAN. Port Forwarding with NAT Although NAT prevents Internet locations from directly accessing the computers on the LAN, the router allows you to direct incoming traffic to specific computers based on the service port number of the incoming request, or to one designated DMZ host computer. You can specify forwarding of single ports or ranges of ports.

Autosensing Ethernet Connections with Auto Uplink
With its internal 4-port 10/100 switch, the WGR614 v6 can connect to either a 10 Mbps standard Ethernet network or a 100 Mbps Fast Ethernet network. Both the LAN and WAN interfaces are autosensing and capable of full-duplex or half-duplex operation. The router incorporates Auto UplinkTM technology. Each Ethernet port will automatically sense whether the Ethernet cable plugged into the port should have a normal connection such as to a computer or an uplink connection such as to a switch or hub. That port will then configure itself to the correct configuration. This feature also eliminates the need to worry about crossover cables, as Auto Uplink will accommodate either type of cable to make the right connection.
Extensive Protocol Support
The WGR614 v6 router supports the Transmission Control Protocol/Internet Protocol (TCP/IP) and Routing Information Protocol (RIP). For further information about TCP/IP, refer to Appendix B, Network, Routing, Firewall, and Basics.
IP Address Sharing by NAT The WGR614 v6 router allows several networked computers to share an Internet account using only a single IP address, which may be statically or dynamically assigned by your Internet service provider (ISP). This technique, known as NAT, allows the use of an inexpensive single-user ISP account. Automatic Configuration of Attached computers by DHCP The WGR614 v6 router dynamically assigns network configuration information, including IP, gateway, and domain name server (DNS) addresses, to attached computers on the LAN using the Dynamic Host Configuration Protocol (DHCP). This feature greatly simplifies configuration of computers on your local network. DNS Proxy When DHCP is enabled and no DNS addresses are specified, the router provides its own address as a DNS server to the attached computers. The router obtains actual DNS addresses from the ISP during connection setup and forwards DNS requests from the LAN. PPP over Ethernet (PPPoE) PPPoE is a protocol for connecting remote hosts to the Internet over a DSL connection by simulating a dial-up connection. This feature eliminates the need to run a login program such as Entersys or WinPOET on your computer.
Easy Installation and Management
You can install, configure, and operate the 54 Mbps Wireless Router WGR614 v6 within minutes after connecting it to the network. The following features simplify installation and management tasks: Browser-based management Browser-based configuration allows you to easily configure your router from almost any type of personal computer, such as Windows, Macintosh, or Linux. A user-friendly Setup Wizard is provided and online help documentation is built into the browser-based Web Management Interface. Smart Wizard The WGR614 v6 router Smart Wizard automatically senses the type of Internet connection, asking you only for the information required for your type of ISP account. Firmware Update The WGR614 v6 router can be updated if a newer version of firmware is available. This lets you take advantage of product enhancements for your WGR614 v6 as soon as they become available.

2-4 202-10099-01, April 2005

Introduction

Visual monitoring The WGR614 v6 routers front panel LEDs provide an easy way to monitor its status and activity.

Maintenance and Support

NETGEAR offers the following features to help you maximize your use of the WGR614 v6 router: Flash memory for firmware upgrades. Free technical support seven days a week, twenty-four hours a day, for 90 days from the date of purchase.

Package Contents

The product package should contain the following items: 54 Mbps Wireless Router WGR614 v6. AC power adapter. Vertical stand. Category 5 (CAT5) Ethernet cable. NETGEAR 54 Mbps Wireless Router WGR614 v6 Resource CD (230-10091-02), including: This guide. The Installation Guide. Application Notes and other helpful information. 54 Mbps Wireless Router WGR614 v5 Installation Guide. Registration, Warranty Card, and Support Information Card.
If any of the parts are incorrect, missing, or damaged, contact your NETGEAR dealer. Keep the carton, including the original packing materials, in case you need to return the router for repair.

The Routers Front Panel

The front panel of the WGR614 v6 router contains the status lights described below.
Figure 2-1: WGR614 v6 Front Panel
You can use the status lights to verify connections. Viewed from left to right, the table below describes the lights on the front panel of the router.

Table 2-1.

Label Power
Status Light Descriptions
Activity On Amber Blinking On Green Solid Off Solid Amber On Off On Off On Blink On (Green) Blink (Green) On (Amber) Blink (Amber) Off Description Power is supplied to the router and it is performing its diagnostic test. Power is supplied and the router it has passed its diagnostic test. Power is not supplied to the router. The router has failed its diagnostic test. The unit is performing the power on self test diagnostic. The unit successfully completed the power on self test diagnostic. The Wireless port is initialized and the wireless feature is enabled. The wireless feature is turned off or there is a problem. The Internet port has detected a link with an attached device. Data is being transmitted or received by the Internet port. The LAN (local area network) port has detected link with a 100 Mbps device. Data is being transmitted or received at 100 Mbps. The Local port has detected link with a 10 Mbps device. Data is being transmitted or received at 10 Mbps. No link is detected on this port.

Test Wireless

Internet LAN
2-6 202-10099-01, April 2005

The Routers Rear Panel

The rear panel of the WGR614 v6 router contains the items listed below.

Wireless Antenna

Reset Button

4 LAN Ports

Internet Port
Figure 1-2: WGR614 v6 Rear Panel
Viewed from left to right, the rear panel contains the following features: AC power adapter outlet for 12 V DC @ 1A output, 22W maximum Four Local (LAN) 10/100 Mbps Ethernet ports for connecting the router to the local computers Internet (WAN) Ethernet port for connecting the router to a cable or DSL modem Factory Default Reset push button for Restoring the Default Configuration and Password Wireless antenna
2-8 202-10099-01, April 2005