NIKE OREGON SERIES ALTI-COMPASS ALTI LANCE 4

+/- to change value

Select 12 or 24 Hour Clock
In TIME mode you can set time and calendar information within two time zones.

Continue to Next Setting

BEGIN Adjust Function
Select Day or Month Display.
TIME Warp: Hold for 1 second in any mode to return to TIME mode
Power Save: Display shuts off to conserve battery life. Press any button to turn watch ON
EXIT Adjust Function Turn Button Chime ON / OFF Adjust Screen Contrast
Electrolite ON Hold LIGHT button for 2 seconds for a longer Electrolite (15 seconds) Switch Time Zones
In ALTITUDE mode you can view and calibrate your current altitude; view and reset your maximum and accumulated altitudes.

Calibrate Altitude

Reset Maximum Altitude Altitude Graph: Each Bar = 5 minutes; Full Graph = 2 hours Recall Accumulated / Maximum Data
Reset Accumulated Altitude
Switch Units: Feet / Meters Set Sample Rate In TIME and CHRON mode, Altitude is automatically sampled every 2.5 minutes
COMPASS mode displays a digital compass that points to the magnetic north pole. It can be adjusted to point to True North.
COMPASS mode not included on NIKE OREGON SERIES ALTI
Recall Compass Digital Arrow points North
Adjust Compass to True North
Reference a topographic map for your location's declination
Declination: The variation between Magnetic North Pole and True North Try Again
Display reads directional heading
Re-Calibrate Compass (after travel and batter y change)

Level Bubble

Keep Watch Level.
Rotate Watch 360 counter-clockwise so arrow always points in same direction
View Temperature Calibrate Temperature
WEATHER mode provides a barometer, therometer, and barometric weather forecaster.
Rising Pressure: Clear weather likely

2 sec 2 sec

Falling Pressure: Clouds / Precipitation likely Switch Units Farenheit / Celsius inch Hg / hPA

START Run

Switch display between Total Time and Lap Time
CHRONOGRAPH mode can be used to capture lap data, total time data and current altitude.
First Minute Display Reset RUN

2 se c

Mark LAP 1 / Altitude 1

Mark LAP 2 / Altitude 2

Save RUN
View Lap Memor y: 50 lap storage capabilty

RUN saved to DATA mode

Stop RUN
In Timer Mode you can setup to 5 repeating segments for customized interval training.

Set up to 5 segments

Start Timer
Color Layer shows portion of segment time remaining

Reset TIMER

Stop Timer Set a segment to 00:00'00" to deactivate it

Reset ALL Segments

View segments

Clear Selected RUN

In DATA mode you can review lap and total time data saved from CHRONOGRAPH mode.

Clear ALL RUNS

Select RUN

Total Time

LAP 1 Time Altitude

LAP 2 Time Altitude

LAP 3 TIme Altitude

Best Lap

Average Lap
In ALARM mode you can set four time alarms, two altitude alarms and one hydration alarm. The time alarm will sound intermittently for 55 seconds. The altitude alarm will sound for five seconds.

Alarm ON / OFF

Hydration Alarm: 0 to 60 minutes
Adjusted Alarms turn ON upon EXIT

Turn ALL Alarms OFF

4 se c

Select Alarm to Adjust

H20 RESIST 100 m OPERATING TEMPERATURE -5 to 50 Celsius

BATTERY TYPE

CR2032 3V Lithium

Material Specifications

CRYSTAL Mineral Glass STRAP Polyurethane CASE Titanium or Aluminum CASEBACK Stainless Steel BUTTONS Stainless Steel BUCKLE Stainless Steel
Note: Battery replacement must be performed by a certified Nike Ser vice Center to retain a valid warranty.

Mode Limits

CHRONOGRAPH 999:59' 59" TIMER 99:59' 59" MAXIMUM ALTITUDE 32,800 feet / 10,000 meters

Reset Watch

Warning! Keep watch batteries away from children. If swallowed, contact a doctor immediately. Warning! Batteries contain chemical substances. They should be disposed of properly according to local regulations.
2003 Nike, Inc. All rights reser ved.

version 2

Lance 3 Battery
WARNING! Keep watch batteries away from children. If swallowed, contact a doctor immediately. WARNING! Batteries contain chemical substances. They should be disposed of properly according to local regulations.
Battery Type: CR2025 3V Lithium Battery Life: The battery is estimated to last 1.5 years depending on frequency and use of certain features.
Battery Replacement: If the back case is sealed, you will need to send the watch to our authorized service center. We strongly recommend you do not remove the watch back yourself. Here's why. Many of our watch designs use special gaskets that create a water tight seal between the back plate and the watch case. The greatest risk of changing the battery yourself, or having a jeweler do it, is that this gasket will not be replaced properly. In this case water damage can occur. In addition to ensuring that your watch is water tight, our service centers will clean the components and replace damaged parts. Customer feedback on the price, duration and headache of this process has prompted us to start putting user serviceable battery hatches in our watches whenever possible.