Nokia Bluetooth Headset BH-101

9206519/1

ENGLISH
DECLARATION OF CONFORMITY
Hereby, NOKIA CORPORATION declares that this HS-94W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. the products described in this document without prior notice. To the maximum extent permitted by applicable law, under no circumstances shall Nokia or any of its licensors be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused. The contents of this document are provided "as is". Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with your Nokia dealer for details. Export Controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited.
2007 Nokia. All rights reserved. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Bluetooth is a registered trademark of Bluetooth SIG, Inc. Nokia operates a policy of ongoing development. Nokia reserves the right to make changes and improvements to any of

Introduction

The Nokia Bluetooth Headset BH-101 allows you to make and receive calls while on the move. You can use the headset with compatible phones that support Bluetooth wireless technology. Read this user guide carefully before using the headset. Also, read the user guide for your phone, which provides important safety and maintenance information. Keep the headset out of the reach of small children. without cables. The phone and the headset do not need to be in line of sight, but they should be within 10 metres (33 feet) of each other. Connections may be subject to interference from obstructions, such as walls, or other electronic devices. The headset complies with the Bluetooth Specification 2.0 + EDR that supports the Headset Profile 1.1 and Hands-Free Profile 1.5. Check with the manufacturers of other devices to determine their compatibility with this device.
Bluetooth wireless technology
Bluetooth wireless technology allows you to connect compatible devices

Get started

The headset contains the following parts shown on the title page: earloop (1), charger connector (2), earpiece (3), volume keys (4), indicator light (5), multifunction key (6), and microphone (7).
Before using the headset, you must charge the battery and pair the headset with a compatible phone.
Parts of the device are magnetic. Metallic materials may be attracted to the device. Do not place credit cards or other magnetic storage media near the device, because information stored on them may be erased.

Charge the battery

Before charging the battery, carefully read Battery information. 1. Connect the charger to a wall outlet. 2. Connect the charger cable to the charger connector (10). The indicator light is red during charging. It may take a while before charging starts. Charging the battery fully may take up to 2 hours. 3. When the battery is fully charged, the indicator light turns green. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 8 hours of talk time or up to 180 hours of standby time. However, the talk and standby times may vary with different compatible Bluetooth devices, usage settings, usage styles, and environments.

Chargers

This device is intended for use when supplied with power from the following chargers: AC-3, AC-4, and DC-4. Warning: Use only chargers approved by Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty, and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord.
3. Activate the Bluetooth feature on the phone, and set the phone to search for Bluetooth devices. 4. Select the headset from the list of Switch on or off found devices. To switch on, press and hold the 5. Enter the passcode 0000 to pair multifunction key for about 5 seconds. and connect the headset to your The headset beeps, and the green phone. In some phones, you may indicator light starts to flash. The need to make the connection headset tries to connect to a paired separately after pairing. You only device. need to pair the headset with your To switch off, press and hold the phone once. multifunction key (for about 5 seconds) until the headset beeps and If the pairing is successful, the headset appears in the phone menu the red indicator light flashes once. where you can view the currently Pair the headset paired Bluetooth devices. 1. Ensure that your phone is switched When the headset is connected to on and the headset is switched off. your phone and is ready for use, the green indicator light flashes slowly. 2. Press and hold the multifunction key (for about 8 seconds) until the green indicator light starts to flash quickly. When battery power is low, the headset beeps once every minute and the red indicator light flashes slowly.

Basic use

Place the headset on the ear
The headset is ready to be used on the right ear. Slide the earloop over your ear (11), and gently push the earpiece into your ear. You can bend the earloop to make it fit the shape of your ear. Point the headset towards your mouth (12). To use the headset on the left ear, detach the earloop (8). flip it, and attach it so that the loop is to the left of the Nokia logo (9). If your phone supports voice dialling with the headset, press and hold the multifunction key for about 2 to 3 seconds until the phone starts voice dialling, and proceed as described in the user guide of the phone. Voice dialling cannot be used during a call. To answer or end a call, press the multifunction key. To reject an incoming call, press this key twice. To adjust the headset volume during a call, press either volume key. To switch the call between the headset and a compatible phone, press and hold the multifunction key for about 2 to 3 seconds.

Call handling

To make a call, use your phone in the normal way when the headset is connected to your phone. If your phone supports last number redialling with the headset, press the multifunction key twice while no call is in progress.

Clear settings or reset

To delete the pairings from the headset, switch on the headset, and press and hold the multifunction key
and the volume up key for about 5 seconds until the indicator light alternates between red and green. To reset the headset if it stops functioning, although it is charged, press and hold the multifunction key, and plug the headset into a charger.

Troubleshooting

If you cannot connect the headset to your compatible phone, check that the headset is charged, switched on, and paired with your phone.

Battery information

Your device is powered by a rechargeable battery. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. Use of an unapproved charger may present a risk of fire, explosion, leakage, or other hazard. If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the battery. If the battery is completely discharged, it may take several minutes before the charging indicator light is displayed. Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime. If left unused, a fully charged battery will lose its charge over time. Always try to keep the battery between 15C and 25C (59F and 77F). Extreme temperatures reduce the capacity and

lifetime of the battery. A device with a hot or cold battery may not work temporarily. Battery performance is particularly limited in temperatures well below freezing. Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged. Never use any charger that is damaged.

Care and maintenance

Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely. Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged. Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics. Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. Do not attempt to open the device. Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and fine mechanics. Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device.
Do not paint the device. Paint can clog the moving parts and prevent proper operation. If the product is not working properly, take it to the nearest authorised service facility for service. Disposal The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies to the European Union and other locations where separate collection systems are available. Do not dispose of these products as unsorted municipal waste. By returning the products to collection you help prevent uncontrolled waste disposal and promote the reuse of material resources. More detailed information is available from the product retailer, local waste authorities, national producer responsibility organizations, or your local Nokia representative. For the product Eco-Declaration or instructions for returning your obsolete product, go to country-specific information at www.nokia.com.