Nokia Bluetooth Headset BH-304

9204669/1

ENGLISH
DECLARATION OF CONFORMITY
Hereby, NOKIA CORPORATION declares that this HS-79W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. the products described in this document without prior notice. Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused. The contents of this document are provided "as is". Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with the Nokia dealer nearest to you. Unauthorized changes or modifications to this device may void the user's authority to operate the equipment. Export Controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other
2007 Nokia. All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Bluetooth is a registered trademark of Bluetooth SIG, Inc. Nokia operates a policy of ongoing development. Nokia reserves the right to make changes and improvements to any of
countries. Diversion contrary to law is prohibited.

Introduction

The Nokia Bluetooth Headset BH-304 allows you to make and receive calls while on the move. You can use the headset with compatible devices that support Bluetooth wireless technology. Read this user guide carefully before using the headset. Also read the user guide for your mobile device, which provides important safety and maintenance information. Keep the headset and its accessories out of reach of small children. of sight, but they should be within 10 meters (33 feet) of each other. Connections may be subject to interference from obstructions, such as walls, or other electronic devices. The headset complies with the Bluetooth Specification 2.0 + EDR that supports the Headset Profile 1.1 and Hands-Free Profile 1.5. Check with the manufacturers of other devices to determine their compatibility with this device. There may be restrictions on using Bluetooth technology in some locations. Check with your local authorities or service provider.
Bluetooth wireless technology
Bluetooth wireless technology allows you to connect compatible devices without cables. The mobile device and the headset do not need to be in line

Get started

The headset contains the following parts shown on the title page: earloop (1), earpiece (2), power key (3), charger connector (4), microphone (5), volume key (6), indicator light (7), and answer/end key (8). Before using the headset, you must charge the battery and pair the headset with a compatible device.
Parts of the headset are magnetic. Metallic materials may be attracted to the headset. Do not place credit cards or other magnetic storage media near the headset, because information stored on them may be erased. Warning: Use only chargers approved by Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord.

Charge the battery

The headset has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device, as you may damage the device. 1. Connect the charger to a wall outlet. 2. Connect the charger cable to the charger connector. The red indicator light is on while charging. It may take a while before charging

Chargers

Check the model number of any charger before using it with this headset. The headset is intended for use with the AC-3, AC-4, and DC-4 chargers.
starts. If charging does not start, disconnect the charger, plug it in again, and retry. Charging the battery fully may take up to 1 hour and 30 minutes. 3. When the battery is fully charged, the indicator light turns to green. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 6 hours and 30 minutes of talk time or up to 150 hours of standby time. However, the talk and standby times may vary when used with different compatible Bluetooth devices, usage settings, usage styles, and environments. When battery power falls low, the headset beeps, and the red indicator light starts to flash.

Switch the headset on or off
To switch on, press and hold the power key until the headset beeps and the green indicator light is displayed. To switch off, press and hold the power key until the headset beeps and the red indicator light is displayed briefly.

Pair the headset

1. Ensure that your mobile device is switched on and the headset is switched off. 2. Press and hold the power key until the green indicator light starts to flash quickly. 3. Activate the Bluetooth feature on the mobile device, and set the device to search for Bluetooth devices. 4. Select the headset from the list of found devices.
5. Enter the passcode 0000 to pair and connect the headset to your device. In some devices you may need to make the connection separately after pairing. You only need to pair the headset with your device once. If the pairing is successful, the headset beeps and appears in the device menu where you can view the currently paired Bluetooth devices.

Basic use

Place the headset on the ear
The headset is ready to be used on your right ear. Slide the earloop over your ear (9), and point the headset toward your mouth (10). To use the headset on the left ear, rotate the earloop so that the loop is to the left of the "Nokia" logo (11). cover starting from the top (12), and push the new cover into place.

Call handling

To make a call, use your mobile device in the normal way when the headset is connected to the device. If your device supports last number redialing with the headset, press the answer/end key twice while no call is in progress. If your device supports voice dialing with the headset, press and hold the answer/end key when no call in

Change the cover

The headset may be supplied with front covers in different colors. To change the cover, pull the current
progress, and proceed as described in the user guide of your device. To answer or end a call, press the answer/end key. To reject an incoming call, press the answer/end key twice. To adjust the headset volume, press the volume key up or down. To mute or unmute the microphone, press the middle of the volume key. To switch the call between the headset and a compatible device, press and hold the answer/end key.

Clear settings or reset

To clear all the pairing settings from the headset, switch off the headset, and press and hold the power key and the answer/end key until the red and green indicator lights start to alternate. To reset the headset if it stops functioning, although it is charged, plug the headset into a charger, and press the power key and the answer/ end key at the same time.

Battery information

Your device is powered by a rechargeable battery. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime. If left unused, a fully charged battery will lose its charge over time. Never use any charger that is damaged. Leaving the device in hot or cold places, such as in a closed car in summer or
winter conditions, will reduce the capacity and lifetime of the battery. Always try to keep the battery between 15C and 25C (59F and 77F). A device with a hot or cold battery may not work temporarily, even when the battery is fully charged. Battery performance is particularly limited in temperatures well below freezing. Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged.

Care and maintenance

Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely. Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged. Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics. Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. Do not attempt to open the device. Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and fine mechanics.
Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. Do not paint the device. Paint can clog the moving parts and prevent proper operation. All of the above suggestions apply equally to your device, battery, charger, or any enhancement. If any device is not working properly, take it to the nearest authorized service facility for service. Disposal The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that in the European Union all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. Do not dispose of these products as unsorted municipal waste. Return the products to collection to prevent possible harm to the environment or human health from uncontrolled waste disposal and to promote the sustainable reuse of material resources. Collection information is available from the product retailer, local waste authorities, national producer responsibility organizations, or your local Nokia representative. For more information, see product Eco-Declaration or country-specific information at www.nokia.com.

ECOECO-DECLARATION

11-0111-01-2008
Eco-declaration for Nokia Bluetooth Headset BH-304
Product type: Audio Enhancement Weight: 11g

Materials

The product does not contain1: Azo colorants and pigments with carcinogenic amino compounds Asbestos Benzene Beryllium Oxide Chlorofluorocarbons CFCs/HCFCs/Halons as banned in the Montreal Protocol Polychlorinated Biphenyls (PCB) or Polychlorinated Terphenyls (PCT) Short Chained Chlorinated Paraffins Endangered species of flora and fauna
Versions of this product that are sold in China comply with the China legislation Management Methods on the Prevention and Control of Pollution caused by Electronic Information Products commonly known as China RoHS. The product does not contain the following substances in concentrations higher than allowed in the EU RoHS Directive 2002/95/EC: Cadmium Chromium VI+ Lead Mercury Polybrominated Biphenyls (PBB) or Polybrominated Diphenyl Ethers (PBDE)
In levels more than 100 ppm by weight in the product All information in this eco-declaration is based on scientific analysis and/or data provided by suppliers. There may be some variance in the information.
Copyright 2007 Nokia. All rights reserved. Nokia is a registered trademark of Nokia Corporation.
Further material information
Antimony trioxide, Brominated and Chlorinated flame retardants are not added in the covers. The surfaces that are intended for direct and prolonged skin contact do not release nickel (Ni) above levels specified in (94/27/EEC). Polyvinylchloride (PVC) is not used in this product or product packaging material.
Recycling Recycling and disassembly
All mechanical plastic parts have been marked where practically possible2. Plastic parts are marked in accordance with ISO 11469 and ISO 1043-1 to -4 standards. Product has been marked according to WEEE directive requirement for recycling. Do not dispose of your product as unsorted municipal waste. Product contains a built-in Li-ion Polymer battery.
Dependant on size, location and materials of the part All information in this eco-declaration is based on scientific analysis and/or data provided by suppliers. There may be some variance in the information.
INSTRUCTIONS FOR THE USER
Always unplug the charger from the wall socket after the device is fully charged. This avoids unnecessary power consumption of the charger in standby and saves energy. Electronic devices shall not be thrown into household waste but be separated for correct recycling. For environmentally sound recycling, contact your local Nokia service point or check local regulations for correct disposal of household electronics. Please separate the packaging material according to responsible waste disposal options and sorting for recycling. See the Recycling Map on http://www.nokia.com/environment to find the nearest collection point for used mobile phones and accessories.