Repairing Olympus Stylus 725 SW Lens

Tools used in this guide

1.5mm Hex Screwdriver (1) Phillips #00 Screwdriver (1) Small plastic prying tool (1)
Use this guide to replace a broken lens inside the camera.

2011 iFixit CC BY-NC-SA

www.iFixit.com

Page 1 of 6

Step 1 - disassembly Back Panel
Unscrew the 3mm long cover screws at the corners of the camera using a #00 Philips Screwdriver. Unscrew the 2mm long screws securing the sides of the camera which holds the back panel. Use the same screwdriver.

Step 2

Be careful when removing the back cover, you will need to detach the connecting ribbons Detach the ribbons using your thumb, sliding them out of their slots.

Page 2 of 6

Step 3 - disassembly Front Panel
Remove the top screws using a 1.5 mm screwdriver. Remove the single side screw located on the side of the camera where the tab is, using a #00 screwdriver.
Step 4 - disassembly Side Panels
Using a #00 Philips Head Screwdriver, remove the screws located on all four sides of the camera.

Page 3 of 6

Step 5
After removing all four of the screws, pry the side covers off of the camera.

Step 6 - Lens

Unscrew four 2mm long screws using the #00 Phillips screwdriver.

Page 4 of 6

Step 7
Remove four metal tabs from corners where the 2mm long screws were attached using tweezers.

Step 8

Remove the viewfinder lens using a prying device. There will be two ribbons attached to the viewfinder. Remove the ribbons by sliding them off the viewfinder with your thumb.

Page 5 of 6

To reassemble your device, follow these instructions in reverse order.
This document was last generated on Feb 12, 2011.

Page 6 of 6