WL-1120AP

Quick Setup Guide

Ver. 1120AP01EN
Repeater, Bridge, Client, and WDS Mode
Wireless: Basic Setting This page includes all primary and major parameters. Any parameter change will cause the device to reboot for the new settings to take effect. Mode: This Wireless Access Point can support three modes AP, Client, and Bridge.

Important Information

The AP modes default IP address is 192.168.100.252 The default Subnet Mask is 255.255.255.0 The default SSID is 802_11b-SSID The default Channel is 11 The default DHCP client is Disabled The default is set to AP mode This Wireless Access Point can support four modes AP, Client, Bridge, Repeater (WDS) If you want to change to Repeater mode, please go to Wireless/ WDS Setting to enable the WDS function Under Bridge Mode, you can set WEP Key or WPA in order to prevent unrelated people to eavesdrop.
The default is set to AP mode. Click the pull down arrow you can change it to Client mode. To change to Repeater mode, you will have to go to Wireless/WDS setting to enable WDS. Network Type: When in Client mode, you can select between Ad-Hoc and Infrastructure. Wireless: WDS Setting In order to set WDS, you need to check on the Enable Wireless Access Controls check box.

LED Indicators

LED Indicator Power ErrStatus Link/Act. WEP MAC Ctrl Bridge LAN 1 Green LAN 2 Turns green when linked to a local network. Color Green RED Green RED RED RED Status Solid Turns solid green when power is applied to this device. Turns solid red when the device is not working properly. Connected and associated to at least a client station. When this function is enabled. When this function is enabled. Turn solid when the device is running in the WDS function.
Repeater, Bridge, and Client Setup
Flashing N/A. When power on self-test failure occurs. Receiving/ Sending data N/A N/A N/A Receiving/ Sending data

Repeater Mode

Device A: Mode: AP WDS: Enable Mac Address: Device Bs AP Mac Address Device B: Mode: AP WDS: Enable Mac Address: Device As AP Mac Address
Please make sure both A and B are set to the same ESSID and Channel.

Bridge Mode

Device A: Mode: Client Network Type: Ad-Hoc Device B: Mode: Client Network Type: Ad-Hoc

Installation Steps

1. 2. 3. 4. 5. Please install your network cards first before the AP Screw-in the antenna (clockwise) into the Antenna connector Connect the power and LAN cable to the back Use your wireless card to do a site survey, the default SSID is 802_11b-SSID and Channel is 11 If you need to change APs configuration, please follow the procedure below: The APs default IP address is 192.168.100.252. Please make sure your computer IP is in the same subnet as the AP (i.e. 192.168.100.x) Open the web browser and enter 192.168.100.252. When asked for Login and Password, just press Enter.
Please make sure both A and B are set to the same ESSID and channel To enhance security, you can disable the Broadcast SSID function under Wireless->Advance Settings. Then turn on WEP or WPA.

Client Mode

Device A: Mode: Client Network Type: Infrastructure Device B: Mode: AP Please make sure both A and B are set to the same ESSID and Channel.