ENGLISH 4 BAHASA MELAYU 14 BAHASA INDONESIA 25 TING VIT 74

ENGLISH

Important
Read these instructions for use carefully before using the appliance and save them for future reference. Only use the powerplug supplied to charge and use the appliance. The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. Only the powerplug supplied guarantees safe transformation. The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation. If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard. Charge, store and use the appliance at a temperature between 5cC and 35cC. Do not recharge the shaver in a closed pouch. Make sure the powerplug and the cord do not get wet. The appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.

Charging

Make sure the appliance is switched off before you start charging it. When you charge the shaver for the first time or after a long period of disuse, leave it to charge continuously for 4 hours. Charging normally takes approx. 1 hour. Do not leave the appliance connected to the mains for more than 24 hours. You can also shave without charging by connecting the shaver to the mains.

Charge indications

you empty C As soon asgreenstart charging theon. shaver, the pilot light goes When the battery has been fully charged, the green pilot light starts blinking. on C The red pilot light goesyou when the battery is almost empty.When switch the appliance off, the red pilot light blinks a few times.

Charging the appliance

Do not recharge the shaver in a closed cassette.
Put the appliance plug in the shaver. Put the powerplug in the wall socket. Remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the battery has been fully charged.

Cordless shaving time

A fully charged shaver has a cordless shaving time of up to 30 minutes.
Using the appliance Shaving
Remove the appliance plug from the shaver before you start shaving. Switch the shaver on by pressing the on/off button once.
Move the shaving heads quickly over your skin, making both straight and circular movements. Shaving on a dry face gives the best results.
Your skin may need 2 or 3 weeks to get accustomed to the Philishave system. 4
Switch the shaver off by pressing the on/off button once. Put the protection cap on the shaver every time you have used it, to prevent damage.

Trimming

For grooming sideburns and moustache.
Open the trimmer by pushing the slide upwards. The trimmer can be activated while the motor is running.

Cleaning and maintenance

Regular cleaning guarantees better shaving performance. The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the shaver. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.
C For easy and optimal cleaning, the Philishave Action Clean (shaving-head cleaner, type
HQ100) is available.Ask your Philishave dealer for information. The Philishave Action Clean may not be available in all countries. Contact the Customer Care Centre in your country about the availability of this accessory.

Shaving unit

When you clean the appliance, it is not necessary to take the shaving heads (cutters and guards) apart. If you want to take them apart, be sure not to mix up the cutters and guards, since grinding of the cutters in the guards only guarantees optimal performance for each matching set. If you accidentally mix up the sets, it could take several weeks before optimal shaving performance is restored. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button to open the shaving unit. Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time.
Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue as this may damage the shaving heads.
Open the shaving unit again and leave it open to let the appliance dry completely.
You can also clean the hair chamber without water by using the brush supplied.

Trimmer

Clean the trimmer every time you have used it. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Clean the trimmer with the brush. Lubricate the trimmer teeth with a drop of sewing machine oil every six months.

Storage

C Put the protection cap on the shaver to prevent damage.
Store the powerplug and the shaver in the luxury pouch.

Replacement

Replace the shaving heads every two years for optimal shaving results.
Replace damaged or worn shaving heads with Philishave HQ6 Quadra shaving heads only. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button to open the shaving unit. Turn the wheel anticlockwise (1) and remove the retaining frame (2).
Remove the shaving heads and place new ones in the shaving unit in such a way that the projections fit exactly into the recesses in the shaving unit. Put the retaining frame back into the shaving unit, press the wheel and turn it clockwise. Close the shaving unit.
heads have been properly C If the shaving shiny parts are pointing inwards inserted, the and towards each other.

Accessories

The following accessories are available: - HQ8000 powerplug.
- HQ6 Philishave Quadra shaving heads. - HQ100 Philishave Action Clean (shaving head cleaner). - HQ101 Philishave Action Clean refill (shaving head cleaning liquid). - HQ110 Philishave shaving head cleaner (shaving head cleaning spray).

Environment

The built-in rechargeable battery contains substances that may pollute the environment.

Disposal of the battery

Remove the battery when you discard the appliance. Do not throw the battery away with the normal household waste, but hand it in at an official collection point.You can also take the appliance to a Philips service centre, which will remove the battery for you and will dispose of it in an environmentally safe way. Only remove the battery if it is completely empty. 1 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Let the shaver run until it stops, undo the screws and open the shaver. Remove the battery.

Do not connect the shaver to the mains again after the battery has been removed.

Guarantee & service

If you need information or if you have a problem, please visit the Philips Web site at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.

Troubleshooting

Reduced shaving performance
Cause 1: the shaving heads are dirty.The shaver has not been rinsed long enough or the water used was not hot enough.
Clean the shaver thoroughly before you continue shaving (see chapter 'Cleaning maintenance').
Cause 2: long hairs are obstructing the shaving heads.
the retaining frame from the shaving C Removeturning the wheel anticlockwise. unit by Remove the shaving heads from the shaving unit.
C Remove the hairs from the cutters and guards with the brush supplied.
Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit, press the wheel and turn it clockwise.
Cause 3: the shaving heads are damaged or worn.
Remove the retaining frame. Remove the old shaving heads from the shaving unit and replace them with new ones Damaged or worn shaving heads (cutters and guards) may only be replaced with original HQ6 Philishave Quadra shaving heads. Put the retaining frame back into the shaving unit, press the wheel and turn it clockwise. 2
The shaver does not work when the on/off button is pressed.
Cause: the battery is empty.
Recharge the battery. See chapter 'Charging'.

BAHASA MELAYU

Penting
Baca arahan penggunaan ini dengan teliti sebelum menggunakan peralatan dan simpan untuk rujukan di masa depan. Gunakan plag kuasa yang disediakan sahaja untuk mengecas dan menggunakan peralatan. Plag kuasa mengubah 100-240 volt kepada voltan rendah dan selamat tidak melebihi 24 volt. Hanya plag kuasa yang disediakan boleh menjamin pengubahan kuasa yang selamat. Plag kuasa itu mengandungi sebuah transformer. Jangan potong plag kuasa untuk menggantikannya dengan plag yang lain kerana ini akan menimbulkan situasi berbahaya. Jika plag kuasa rosak, gantikan dengan jenis yang tulen untuk mengelakkan daripada kemudaratan. Cas, simpan dan gunakan peralatan pada suhu di antara 5cC and 35cC. Jangan mengecas semula pencukur di pau tertutup. Pastikan plag kuasa dan kord tidak kena basah.

www.philips.com ( ) Philips Domestic Appliance and Personal Care BV

( '' )

() HQ6 Philishave Quadra

2005/04/06

c c

Philips Shaving heads

Precision cutting system

3 shaving heads

Keep a close shave
Change heads every 2 years for the best results
Every year, your blades travel the height of Mt. Everest. 49 times! After such a workout, even the best materials can lose their edge. Retain your shaver's peak performance replace the heads once every 2 years.
Comfortably close Super Lift & Cut shaving technology with dual blade system Shaves even the shortest stubble Precision Cutting System

Shaving heads

HQ6/40
Precision cutting system 3 shaving heads

Specifications

Shaving heads per packaging: 3 Fits product types: HQ6425, HQ6426, HQ6466, HQ6465, HQ6832, HQ6847, HQ6850, HQ6851, HQ6852, HQ6870, HQ6871, HQ6890, HQ6894, HQ7415, HQ7815, HQ7830, HQ7850, HQ7870, 6828XL, 6887XL, 7610X, 7616X, 7866XL,

Highlights

7886XL, HQ662, HQ663, HQ664, HQ686, HQ665, HQ6825, HQ6826, HQ6827, HQ6828, HQ6830, HQ6848, HQ6865, HQ6867, HQ6885, HQ6888, HQ6889, HQ6893, HQ7405, HQ7615, HQ7616, HQ7617, HQ7814, HQ7816, HQ7817, HQ7820, HQ7821, HQ7825, HQ7829, HQ7845, HQ7864, HQ7865, HQ7868, HQ7885
Super Lift & Cut technology
Dual blade system: first blade lifts, second blade cuts for a comfortable close shave.

Precision Cutting System

Ultra-thin heads with slots to shave long hairs and holes to shave the shortest stubble.
Issue date 2011-04-19 Version: 5.0.1
2011 Koninklijke Philips Electronics N.V. All Rights reserved. Specifications are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners. www.philips.com

12 NC: 00000