Installation instructions

Subject

Car2PC-PIO adapter for Car PC / laptop integration with Pioneer car stereo

Models Supported

Pioneer DEH-P680MP Pioneer DEH-P8600MP Pioneer FH-P4200MP Pioneer DEH-P880PRS Pioneer DEH-P47DH Pioneer DEH-P77DH Pioneer DEH-P3800MP Pioneer DEH-P4800MP Pioneer DEH-P5800MP Pioneer DEH-P6800MP Pioneer DEH-P7800MP Pioneer DEH-P780MP Pioneer DEH-P9800BT Pioneer DEH-P980BT

Disclaimer

Modifying the radio may void any outstanding warranty it may have. This product is not affiliated with any of the OEM manufactures There are no warranties expressed or implied by purchase of this product While every care has been taken to provide a quality product, we cannot guarantee the Car2PC-PIO adapter to function correctly if installation is not done according to the instructions in this guide Were not liable for misuse of this product. Misuse includes improper installation, damage to the board or radio while trying to install, and illegal use of the modified radio

Tools needed:

Preparation
1. Turn off car engine and remove key from ignition

rev 2.2

2. Un-mount your radio from the dash in order to get access to the back side of the radio. 3. There is no need to disconnect the car stereo from the cars power during installation

Adapter installation

4. Attach yellow wire to the ground (cars frame) and red one to the battery +12V 5. Find a place where you can place Car2PC adapter. In many cars there is enough room in the dash to place Car2PC. Note: Make sure you mount Car2PC in a place with enough room so when you mount the car stereo back you do not break the adapter 6. You may use glove box or other spaces in a dash to direct USB+ Audio cables out 7. Mount your car stereo back into the dash, make sure its clips are securely fastened 8. Now you can turn you car stereo on (ignition should be on) and switch it over to CD Changer mode. It should show Disk 1, Track 01 on a display. 9. Congratulations! You have installed Car2PC-PIO adapter and you may use it right away with your PC/laptop

Troubleshooting

In case if sound volume is too low, just cut 3 thick wires on a harness as described here: http://www.indashpc.org/vbullettin/viewtopic.php?p=2388 Use our support forum for all issues with the adapter http://indashpc.org/vbullettin/

Support

For all technical questions please e-mail to info@car2pc.com. Your question will be answered within 24 hours.