ENGLISH

4-Channel Gateway Amplifier Amplificateur Gateway 4 canaux 4-

ESPAOL DEUTSCH FRANAIS

Owners Manual

ITALIANO

ND-G500

Mode demploi

NEDERLANDS

Contents

Before Using This Product.. 1
Information to User.. 1 In case of trouble... 2
Before Using This Product
Thank you for purchasing this PIONEER product. Before attempting operation, be sure to read this manual. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health.

Connecting the Unit.. 2

Connection Diagram.. 3

Installation.. 5

Installing the amplifier.. 5

Specifications.. 6

Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the users right to operate the equipment.

WARNING

Handling the cord on this product or cords associated with accessories sold with the product may expose you to chemicals listed on proposition 65 known to the State of California and other governmental entities to cause cancer and birth defects or other reproductive harm. Wash hands after handling.

Connecting the Unit

In case of trouble
When the unit does not operate properly, contact your dealer or the nearest authorized PIONEER Service Station.

CAUTION

Disconnect the negative () terminal of the battery to avoid the risk of short-circuit and damage to the unit. Do not route wires where they will get hot, for example where the heater will blow over them. If the insulation heats up, it may become damaged, resulting in a short-circuit through the vehicle body. Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, handbrake or seat sliding mechanism. Do not shorten any wires. Otherwise the protection circuit may fail to work when it should. Never feed power to other equipment by cutting the insulation of the power supply wire to tap from the wire. The current capacity of the wire will be exceeded, causing overheating. Never replace the fuse with one of greater value or rating than the original fuse. Use of an improper fuse could result in overheating and smoke and could cause damage to the product and injury including burns.
Never replace the fuse with one of greater value or rating than the original fuse. Use of an improper fuse could result in overheating and smoke and could cause damage to the product and injury including burns.

ESPAOL

Do not touch the amplifier with wet hands. Otherwise you may get an electric shock. Also, do not touch the amplifier when it is wet. For traffic safety and to maintain safe driving conditions, keep the volume low enough so that you can still hear normal traffic sound. Check the connections of the power supply and speakers if the amplifier fuse blows. Detect the cause and solve the problem, then replace the fuse with another one of the same size and rating. To prevent malfunction of the amplifier and speakers, the protective circuit will cut the power supply to the amplifier (sound will stop) when an abnormal condition occurs. In such a case, switch the power to the system OFF and check the connection of the power supply and speakers. Detect the cause and solve the problem. Contact the dealer if you cannot detect the cause. To prevent an electric shock or short-circuit during connection and installation, be sure to disconnect the negative () terminal of the battery beforehand. DO NOT allow amplifier to come into contact with liquids due to, for example, the location where the amplifier is installed. Electrical shock could result. Also, amplifier and speaker damage, smoke, and overheating could result from contact with liquids. In addition, the amplifier surface and the surface of any attached speakers could become hot to the touch and minor burns could result.

DEUTSCH FRANAIS

CAUTION To prevent damage and/or injury
This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recreational vehicle, truck or bus, check the battery voltage. If the car stereo is kept on for a long time while the engine is at rest or idling, the battery may go dead. Turn the car stereo off when the engine is at rest or idling.

ITALIANO NEDERLANDS 2

Connection Diagram
This product To Navigation System (TO NAVI) Audio input (AUDIO IN)

Rear view (AVIC-F500BT)

To Car (TO CAR)
Cradle (Supplied with AVIC-F500BT) Supplied with AVIC-F500BT AMP control male Black Blue/white female Black
Audio output (Left/Right)

ENGLISH ESPAOL

Speaker leads White: Front left + White/black: Front left Gray: Front right + Gray/black: Front right Green: Rear left + Green/black: Rear left Violet: Rear right + Violet/black: Rear right To Car stereo Black (ground)

To Car stereo

Fuse (10 A)

Yellow (Back-up)

Cap Do not remove cap if this terminal is not in use. Red (Accessory) Fuse resistor
Pink (CAR SPEED SIGNAL) Yellow/black (MUTE) Violet/white ( REVERSGEAR SIGNAL) Blue (AUTO ANTENNA) Orange/white (ILLUMI)

ITALIANO NEDERLANDS

To Car
Speaker leads White: Front left + White/black: Front left Gray: Front right + Gray/black: Front right Green: Rear left + Green/black: Rear left Violet: Rear right + Violet/black: Rear right

ISO connector

Installation
Do not install in: Places where it could injure the driver or passengers if the vehicle stops suddenly. Places where it may interfere with the driver, such as on the floor in front of the drivers seat. Make sure that wires are not caught in the sliding mechanism of the seats, resulting in a shortcircuit. DO NOT allow amplifier to come into contact with liquids due to, for example, the location where the amplifier is installed. Electrical shock could result. Also, amplifier and speaker damage, smoke, and overheating could result from contact with liquids. In addition, the amplifier surface and the surface of any attached speakers could become hot to the touch and minor burns could result. To ensure proper installation, use the supplied parts in the manner specified. If any parts other than the supplied ones are used, they may damage internal parts of the amplifier, or they may become loose causing the amplifier to shut down. Never replace the fuse with one of greater value or rating than the original fuse. Use of an improper fuse could result in overheating and smoke and could cause damage to the product and injury including burns. The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifiers to heat dissipate freely.
CAUTION To prevent malfunction and/or injury
To ensure proper heat dissipation of the amplifier, be sure of the following during installation. Allow adequate space above the amplifier for proper ventilation. Do not cover the amplifier with a floor mat or carpet. DO NOT allow amplifier to come into contact with liquids due to, for example, the location where the amplifier is installed. Electrical shock could result. Also, amplifier and speaker damage, smoke, and overheating could result from contact with liquids. In addition, the amplifier surface and the surface of any attached speakers could become hot to the touch and minor burns could result. Do not install the amplifier on unstable places such as the spare tire board. The best location for installation differs with the car model and installation location. Secure the amplifier at a sufficiently rigid location. Make temporary connections first and check that the amplifier and the system operate properly. After installing the amplifier, confirm that the spare tire, jack and tools can be easily removed.

. . , .

, . , -. , . , . , . , , ( ). . . , . () . , - , . , , . .

FRANAIS ITALIANO

! /
12 . , . , . , .

NEDERLANDS 2

(TO NAVI) (AUDIO IN)

(AVIC-F500BT)

(TO CAR)
( AVIC-F500BT) AVIC-F500BT AMP /
: + / : : + / : : + / : : + / : () oxpae (10 A) ()

, . ()

(CAR SPEED SIGNAL) / (MUTE) / (REVERSGEAR SIGNAL) (AUTO ANTENNA) / (ILLUMI)
: + / : ISO : + / : : + / : : + / :
: , . , , . , . , -. . , , . . , , . - , , , . . . , . , . , . , . . , -. . , , . . , , . . . , . , , , .

() , () .

, . . , .

! /

, , , :
.. 14,4 ( 10,8 15,1 ) .... . .. 10 ( , 4 ) .... 4 .... 10 1 ... 140 () 28 () 174 () ... 0,8 ( ) .... 50 1 (4 ) .. 22 4 ( 14,4 , 4 , 50 15 , 5%) .. 4 ( 4 8 (2 )) .. 01,5 (20 /1 , 20 /1 ) /.... 60 (1 4 20 ) .... 0,2 % (-) ... 50 (Rg=1 k, -) / ..... : 5,6 V / 22 k : 46 / 10,56 k

. .

B 5 720 16.06.97 Pioneer Europe NV , . : 6 ( , , .): 5

ITALIANO NEDERLANDS 6

PIONEER CORPORATION
4-1, MEGURO 1-CHOME, MEGURO-KU, TOKYO 153-8654, JAPAN 4-1, 1-, -, 153-8654,
PIONEER ELECTRONICS (USA) INC. P.O. Box 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404 PIONEER EUROPE NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium TEL: (0) 3/570.05.11 PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-7555 PIONEER ELECTRONICS AUSTRALIA PTY. LTD. 178-184 Boundary Road, Braeside, Victoria 3195, Australia TEL: (03) 9586-6300 PIONEER ELECTRONICS OF CANADA, INC. 300 Allstate Parkway, Markham, Ontario L3R 0P2, Canada TEL: 1-877-283-5901 TEL: 905-479-4411 PIONEER ELECTRONICS DE MEXICO, S.A. de C.V. Blvd.Manuel Avila Camacho piso Col.Lomas de Chapultepec, Mexico, D.F. 11000 TEL: 55-9178-4270
Published by Pioneer Corporation. Copyright 2008 by Pioneer Corporation. All rights reserved. Publication de Pioneer Corporation. Copyright 2008 Pioneer Corporation. Tous droits de reproduction et de traduction rservs. Printed in China Imprim en Chine
<KNKNX> <08B00000>

<CRD4344-A/S> E5