Take picture

Instant Pocket Camera

Select
28 ft (.6 m 2.4 m) 2 ft (.6 m ) 2 ft (.6 m )

Indoors

Outdoor: Sunny

Outdoor: Cloudy

Load Film

Press button.

Use Polaroid I-Zone instant pocket lms. Save this sheet for reference Wait. Ready light glows.
Aim. Best pictures from 28 ft. (.62.4 m).
Load lm. Press the button.
Pull tab straight, rmly, and quickly. Do not stop.
Close door. Make sure its closed.
Shade from bright sun and pull tab straight, rmly, and quickly. Do not stop.
Have Fun! DO NOT CUT INTO PHOTOS. To prevent exposure to caustic paste, cut where indicated.

Load batteries

Use two AA alkaline batteries. Change the batteries when the ready light does not glow, or if it takes longer than 20 seconds to glow. To save battery power, the camera shuts off after each picture.
Limited Warranty: Polaroid will, at our option, repair or replace any camera found defective in manufacture within the warranty period (12 months). The warranty period is determined by the date of camera purchase. Keep the receipt as proof of purchase. Otherwise the warranty period is determined by the date of manufacture. This warranty does not apply to damage caused by accident, misuse or tampering and excludes all consequential damages except in jurisdictions not allowing such exclusions or limitations. Polaroid will replace any lm that is defective in manufacture, labeling or packaging, provided representative samples are returned to a Polaroid dealer or ofce. This warranty excludes all consequential damages except in jurisdictions not allowing such exclusions or limitations. Caution: This camera is battery operated. Closely supervise children when they are operating the camera or when you are using it in their presence. To prevent electrical shock, the camera should not be exposed to or immersed in water or other uids, disassembled, or operated if dropped and damaged. Follow local legal requirements for disposing of or recycling the non-hazardous, AA alkaline batteries.
Light blue blotches or marks on the photo Shade camera from bright sunlight. When pulling tab, pull straight and rmly. Do not stop. Picture too dark Too far from subject or wrong setting. Picture too light Too close to subject or wrong setting.
Film Caution: This process uses a caustic paste. If any paste appears, avoid contact with skin, eyes and mouth and keep away from children and animals. If you get some paste on your skin, wipe it off immediately and wash with water to avoid an alkali burn. If eye or mouth contact occurs, quickly wash the area with plenty of water and see a doctor. Copyright 1999 Polaroid Corporation, Cambridge, MA 02139 U.S.A., owner of the trademarks Polaroid and Polaroid I-Zone (and design).
If you need information or help, please call Polaroid Customer service or visit us at www.polaroid.com or izone.polaroid.com. USA Toll Free 1-800-343-5000 Australia 643 (02) (if in Sydney metropolitan area) New Zealand (09) 303 1479

Film Data Sheet i-Zone Pocket Sticker Film Integral Color Print Film

Description

General purpose High-speed, medium-contrast, integral film for instant color prints. The film is balanced for daylight and electronic flash exposure. On the back side of each photo there is an adhesive that allows the user to place the photo on a variety of surfaces such as book covers, lockers, walls, refrigerators, etc.

Pocket Film

Sticker Film

Key Applications

Amateur photography Promotional photography Photographic souvenirs Party/special event photography

Film Speed

ISO 640/DIN 29

Compatible Hardware

i-Zone Pocket Camera ID 1-2-3 Barbie Pocket Camera Bugs Bunny and Tweety Bird Pocket Camera Tomy Xiao/Pocket Camera

Format

65/8 x 13/8 in. (16.8 x 3.5 cm)

Image Area

13/8 x 7/8 in. (3.6 x 2.4 cm)

Finish

Glossy

Special Treatment

Exposures per Unit

12 exposures per pack

Alternative product

Development Time

3 minutes approximately

Caution

This film uses a small amount of caustic paste. If any paste appears, avoid contact with skin, eyes and mouth and keep away from children and animals. If you get some paste on your skin, wipe it off immediately, then wash with water to avoid an alkali burn. If eye contact occurs, quickly wash the area with plenty of water and see a doctor. Do not cut or take apart pictures or battery. Do not burn battery or allow metal to touch terminals.

Limited Warranty

See information on the film box. Polaroid and Polaroid I-Zone (and design) are trademarks of Polaroid Corporation, Waltham, MA 02451 USA. Barbie is a trademark owned and used under license from Mattel, Inc. Copyright 1999 Mattel, Inc. All rights reserved. Looney Tunes, characters, names and all related indicia are trademarks of Warner Bros. Copyright 1999.
Film Data Sheet Technical Data
The information in this data sheet represents the typical performance of Polaroids Pocket film. However, there may be some variation between film lots.
Characteristic H&D curve for normal development
3 H&D Curves @ 70oF/21oC Blue Green
Recommended speed: ISO/DIN 640/290 Recommended processing time and temperature: Approximately 3 minutes at 700F/210C Balance: Daylight and electronic flash (5500oK) Contrast: Medium Resolution (1000:1): 7-10 line pairs/mm
Sample Density -3 -2 -1 0

Relative Log Exposure

D-Max: The density value for the films darkest black. D-Min: The lowest density value that a film exhibits. In prints, the whiteness of the brightest highlight, relative to the unprocessed print. Slope: The positive ratio of the log E increments of the straight line region of the curve, as determined by the 1/4-3/4 increment method. The slope of an H&D curve indicates the overall contrast of a film: low contrast slopes less than 1.10; medium contrast slopes from 1.10 to 1.70; high contrast slopes greater than 1.70.

Sample Density

Characteristic H&D curve for cold development
Characteristic H&D curve for hot development
H&D Curves @ 95 oF/35 oC

Blue Green Red

H&D Curves @ 55 oF/18 oC

-3 -2 --3 -2 -1 0

Reciprocity law failure A wide range of shutter speeds can be used without loss of film speed or requirements for color filtration. For longer exposure times, some exposure compensation and filtration is suggested. Reciprocity The ability of the film to respond in a constant manner to a constant exposure (light intensity x time). Reciprocity failure occurs during very long or very short exposures, requiring the photographer to increase exposure.

Reciprocity Law Failure

Blue 1.8 1.6 Green Red
1.4 1.2 1.0.8.6.4.2 0.0001".001".01".1" 1" 10" 100"

Exposure Time (seconds)

Modulation Transfer Function

Modulation

0.1.2.3.5
Spatial Frequency (lp/mm)

Spectral Sensitivity

Blue 1000 Green Red

Wavelength (nm)

Spectral Sensitivity: Shows the equivalent energy needed at each wavelength in order to activate the emulsion so that it produces a neutral density of.75.