Oct.2002

M-512G

SERVICE NOTES

Issued by RJA
SPECIFICATIONS...2 PARTS LIST..2
Copyright 2002 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.

17058100E0

Printed in Japan (****) (SC)

SPECIFICATIONS

M-512G: Memory Card

Memory Size

64KByte

Dimensions

58.6 (W) x 136.0 (D) x 17.2 (H) mm 2-5/16 (W) x 5-3/8 (D) x 11/16 (H) inches

Weight

52g / 2 oz

Accessories

Owners Manual ENGLISH/JAPANESE(#03016756)

PARTS LIST

fig.part1e
SAFETY PRECAUTIONS: The parts marked have safety-related characteristics. Use only listed parts for replacement.
CONSIDERATION ON PARTS ORDRING
When ordering any parts listed in the parts list, please specify the following items in the order sheet. QTY PART NUMBER DESCRIPTION MODEL NUMBER Ex. Sharp Key C-20/2247017300 Knob (orange) DAC-15D Failure to completely fill the above items with correct number and description will result in delayed or even undelivered replacement.
NOTE: The parts marked # are new. (initial parts)

fig.part2e

NOTE: Consider about the natural environment carefully before through the old lithium battery away when you exchange to the new one.
Only new unit and some dedicated parts to be replaced can be supplied by the service center for repair purposes. If the main unit ever need to repaired, order a new one from the service center and replace it with a new one.
Since the M-512G is low priced, if it ever needs to be repaired, replace it with a new one instead of using(repairing) parts. (Do not open this unit or perform any internal modifications on the unit.) * For M-512G repair units at the service site, note the following: BOTTOM CASE TOP CASE

CASING # #

FINISHED GOODS # SK000114

FINISHED GODDS

FOR SERVICE ONLY
SCREW 40233012 SCREW M2.6X8 BINDING TAPTITE FEBZC 2

PACKING # #

03016745 03121956
OUTER PACKING CASE PACKING CASE

MISCELLANEOUS 02567234

LITHIUM BATTERY

CR2032

ACCESSORIES (STANDARD) # 03016756 17048113
OWNERS MANUAL WARRANTY CARD
ENGLISH/JAPANESE JAPANESE

Use only in the products which M-512E is designated. This card can also be used which instruments with use M-256E, M-256D or M-128D. (However, the amount of data that can be saved onto this card will be the same as when using a card originally specified for the instrument.)

INSTRUCTIONS

Copyright 2002 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. Before using this card, make sure to read the instructions below.

NOTES

Never touch terminals. Also, avoid getting terminals dirty. Do not expose the card to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. Excessive heat can deform or discolor the card. To avoid possible breakdown, do not use the card in a wet area, such as an area exposed to rain or other moisture. To avoid the risk of damage to internal components that can be caused by static electricity, please carefully observe the following whenever you handle the card. Before you touch the card, always first grasp a metal object (such as a water pipe), so you are sure that any static electricity you might have been carrying has been discharged. Save the bag and the box in which the card was originally shipped, and put the card back into them whenever you need to store or transport it. Be sure that you are holding the card with the face up, and insert it slowly until it is securely in place. How to use the Memory Card is fully explained in the owners manual of each device.

Battery Replacement

When the display of your device using M512G indicates a message such as MEMORY CARD Battery Low or DATA Card Battery Low, the battery in M-512G card is nearly worn out. Please contact Roland Service Station for the battery replacement, referring to the owners manual of your device. Be sure to load all the data from the M-512G onto your device before the battery replacement. The data stored in your M-512G card may be lost while replacing the battery.

Protect Switch

The Protect Switch is provided to prevent accidental erasure of data. Please be sure to keep it in the ON position except when writing new data. * In the interest of product improvement, the specifications and/or appearance of this card are subject to change without prior notice.

03016758 02-8-C3-11N

For EU Countries This product complies with the requirements of European Directive 89/336/EEC.