3-862-170-92(1)

Cassette-Corder
Operating Instructions (reverse side)

TCM-333/323

Sony Corporation 1998 Printed in China

About This Manual

The instructions in this manual are for TCM-333 and TCM-323. Before you start reading, check your model number. TCM-333 is the model used for illustration purposes. Any differences in operation are clearly indicated in the text, for example, TCM-333 only.
When to replace the batteries Replace the batteries with new ones when the BATT lamp dims.

z Operating the Unit

Recording

BATT lamp

To prevent a tape from being accidentally recorded over Break out and remove the cassette tabs. To reuse the tape for recording, cover the tab hole with adhesive tape.

Side A Tab for side A

To Stop playback/stop fast forward or rewind Pause playback
Press or slide p STOP PAUSE c in the direction of the arrow. To release pause playback, release PAUSE c*. Press and hold ) FF/CUE and release it at the point you want Press and hold 0 REW/REVIEW and release it at the point you want ) FF/CUE during stop 0 REW/REVIEW during stop r REC

Troubleshooting

Should any problem persist after you have made these checks, consult your nearest Sony dealer. You cannot press r REC. m The tab on the tape has been removed. You cannot press ( PLAY. m The tape has reached the end. Rewind the tape. The unit does not operate. m The batteries have been inserted with incorrect polarity. m The batteries are weak. m PAUSE c is slid in the direction of the arrow. m The AC power adaptor or car battery cord is not firmly connected (TCM-333 only). m The batteries have been inserted, but simultaneously the AC power adaptor is connected and not to be done to the wall outlet (TCM-333 only). No sound comes from the speaker. m The earphone is plugged in. m The volume is turned down completely. The sound drops out or comes with excessive noise. m The volume is turned down completely. m The batteries are weak. m The heads are contaminated. See Maintenance. Recording cannot be made. m Connection is made incorrectly. m The batteries are weak. m The record / playback head is contaminated. Recording cannot be erased completely. m The erase head is contaminated. m Recording or erasing is being made using recorded CrO2 (TYPE II) or metal (TYPE IV) tape.

Maintenance

Capstan Erase head
You can record right away with the built-in microphone.

z Getting Started

Search forward during playback (CUE) Search backward during playback (REVIEW) Fast forward** Rewind** Built-in microphone

Record/playback head

Cotton swab

Preparing a Power Source

Choose one of the following power sources.
After the batteries have been used for a while, the BATT lamp may flicker with the playback sound when you turn up the volume; however, this does not mean that you need to replace the batteries. The unit will play back normally for a while even after the BATT lamp dims. However, replace the batteries as soon as you can. If you do not, subsequent recording will not be done correctly.

Pinch-roller

Playing a Tape

EAR VOL

Dry Batteries
Make sure that nothing is connected to the DC IN 3V jack (TCM-333 only).
Start recording during playback
Battery life (Approximate hours)
Playback Sony alkaline LR6 (SG) Sony R6P (SR) 11 3

(EIAJ*)

Recording r REC p STOP 0 REW/ REVIEW PAUSE c p STOP ( PLAY
* PAUSE c will be also automatically released when p STOP is pressed (stop-pause-release function). **If you leave the unit after the tape has been wound or rewound, the batteries will be consumed rapidly. Be sure to depress p STOP.

z Additional Information

To clean the tape heads and path Wipe the heads, pinch rollers, and the capstans with a cotton swab moistened with alcohol every 10 hours of use. To clean the exterior Use a soft cloth slightly moistened in water. Do not use alcohol, benzine or thinner.
* Measured value by the standard of EIAJ(Electronic Industries Association of Japan). (Using a Sony HF series cassette tape)

Precautions

On power Operate the unit only on 3V DC. For AC operation, use the AC power adaptor recommended for the unit. Do not use any other type (TCM-333 only). For battery operation, use two size R6 (AA) batteries. On the unit Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. Should any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor (TCM-333 only), and have the unit checked by qualified personnel before operating it any further. Keep personal credit cards using magnetic coding or spring-wound watches etc. away from the unit to prevent possible damage from the magnet used for the speaker. If the unit has not been used for a long time, set it in the playback mode and warm it up for a few minutes before inserting a tape. On tapes longer than 90 minutes We do not recommend the use of tapes longer than 90 minutes except for a long continuous recording or playback. They are very thin and tend to be stretched easily. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer.
Note 1 Open the battery compartment lid. 2 Insert two size R6 (AA) batteries (not supplied) with correct polarity and close the lid. Notes
Do not charge a dry battery. Do not use a new battery with an old one. Do not use different types of batteries. When you do not use the unit for a long time, remove the batteries to avoid any damage caused by battery leakage and subsequent corrosion. (TCM-333 only) Dry batteries will not be expended when another power source is connected. The battery life may shorten depending on the operation of the unit.

0 REW/REVIEW ) FF/CUE

House Current (TCM-333 only)

AC power adaptor

1 Insert a normal (TYPE I) tape with the side to start recording facing the cassette holder. 2 Press r REC. Recording starts. At the end of the tape, recording stops and the unit turns off automatically.
To Stop recording Pause recording Press or slide p STOP PAUSE c in the direction of the arrow. To release pause recording, release PAUSE c*. Press and hold 0 REW/REVIEW during recording. Release the button at the point to start playback.

PAUSE c

Specifications
Recording system 2-track 1 channel monaural Frequency range 250 - 6,300 Hz Speaker Approx. 3.6 cm (1716 in.) dia. Power output 130 mW (at 10 % harmonic distortion) Output Earphone jack (minijack) for 8 - 300 ohms earphone Power requirements Two size R6 (AA) batteries (not supplied): 3V DC DC IN 3 V jack (TCM-333 only) accepts: AC-E30HG AC power adaptor (not supplied) suitable in the country where the unit is to be used. Sony DCC-E230 car battery cord (not supplied) for use on 12 V car battery. Dimensions (w/h/d) (incl. projecting parts and controls) Approx. 36.5 mm (1716 in.) Mass (not incl. batteries) Approx. 170g (6.0 oz) Design and specifications are subject to change without notice.
1 Insert a cassette with the side to start playing facing the cassette holder. 2 Press ( PLAY then adjust the volume. There is a raised dot to show the direction to turn down volume beside VOL. At the end of the tape, playback stops and the unit turns off automatically. If you plug in headphones (not supplied) to the EAR jack, you will get monaural output from both left and right channels.

DC IN 3V

To take out the batteries
Connect the AC power adaptor to DC IN 3V and to the wall outlet. Use the AC-E30HG AC power adaptor (not supplied). Do not use any other AC power adaptor.

Polarity of the plug

Specifications for AC-E30HG varies for each area. Check your local voltage and the shape of plug before purchasing.
Review the portion just recorded
To attach the battery compartment lid if it is accidentally detached
*PAUSE c will be also automatically released when p STOP is pressed (stop-pause-release function).
To monitor the sound Connect an earphone (not supplied) firmly to the EAR jack. Note
Do not use a CrO2 (TYPE II) or metal (TYPE IV) tape, otherwise the sound may be distorted when you play back the tape, or the previous recording may not be erased completely.