GMR325-2
Congratulations on your purchase of the Uniden GMR325-2 radio. This product is a lightweight, palmsized radio. Use it at sporting events to stay in contact with family and friends, hiking, skiing, outdoors, or in a neighborhood watch for vital communication.
To turn OFF this beep: Press and hold the call key while turning ON the radio. To turn ON this beep: Turn the radio OFF and ON again. Choosing a Channel Your GMR325-2 radio has 22 channels you can use to talk to others. In order to speak to someone, each of you must be set to the same channel. To choose a channel: Press the channel/scan L or M key to increase or decrease the channel number displayed. Channel Scan Feature Your GMR325-2 radio has a channel Scan feature that allows you to easily Scan all 22 channels. When an active channel is detected, the unit will pause on that channel until the channel is clear. Then after a 2 second delay, the unit will continue scanning. Pressing PTT button while the Scan is paused on a channel will allow you to transmit on that channel. To turn ON channel scanning: Press and hold either the channel/scan L or M key. The channel number on the display will rapidly cycle through the channels. To turn OFF channel scanning: Press either the channel/scan L or M key. Note: If you press either the channel/scan L or M key while the unit is pausing on a channel, scanning will resume. Talking on Your Radio To talk to others using the radio: 1) Press and hold the PTT button and speak in a clear, normal voice about 2-3 inches away from the microphone. While you are transmitting the tx icon is displayed. To avoid cutting off the first part of your transmission, pause slightly after pressing the PTT button before you start talking. 2) When you are finished speaking, release the PTT button. You can now receive incoming calls. While receiving, the rx icon is displayed. Transmitting a Call Alert Tone Your GMR325-2 radio is equipped with a call tone that will be transmitted when the call key is pressed. To transmit the call alert tone, press the call key. The tone will automatically be transmitted for a fixed length of time. Auto Squelch Feature The GMR325-2 is equipped with an automatic squelch system which shuts off weak transmissions and unwanted noise due to terrain conditions or if you have reached your range limit.
Monitor Mode Feature Your GMR325-2 radio allows you to listen for weak signals on the current channel at the press of a key. To turn ON monitor mode: Press and hold the volume/monitor L or M key. The rx icon will blink. To turn OFF monitor mode: Press the volume/monitor L or M key. The rx icon will stop blinking. Automatic Power Save Feature Your GMR325-2 has a unique circuit designed to dramatically extend the life of the batteries. If there is neither transmission nor an incoming call within 2 seconds, your radio switches to the Power Save mode. The radio is still able to receive transmissions in this mode. KEYLOCK ON/OFF Press and hold the call key until the "L" appears. After 1 second, the LCD will return to the channel display. To exit Keylock on mode, press and hold call again. Note: While in keylock on mode, it will still receive transmissions. ROGER BEEP Roger Beep is a BEEP that is sent to notify the end of transmission. Roger Beep can be heard through the speaker when Key Beep is on. Roger Beep is transmitted even if key beep is turned off. However Roger Beep will not be heard from the speaker. To turn OFF Roger Beep: Press and hold the channel/scan L Key while turning on the radio.
15 GMRS / 7 FRS Channels Long Battery Life Extended Long Range* Channel Scan Channel Monitor Battery Strength Meter Call Button Roger Beep Keytone on/off

PACKAGE CONTENTS

Your package contains the 2 GMR325 radios, this reference guide and 2 belt clips. You will need to purchase 6 AAA alkaline batteries in order to operate these units.

FCC GMRS LICENSE

The GMR325-2 radio operates on the General Mobile Radio Service (GMRS) frequencies which require a Federal Communications Commission license to operate. For licensing information and application forms, visit the FCC on-line at:www.fcc.gov/wtb/uls or call the FCC hotline at 1-800-418-3676. If you have any questions you can contact the FCC direct at 1-888-225-5322.
INSTALL THE OPTIONAL BATTERIES
*Range may vary depending on environmental and/or topographical conditions.
Your GMR325-2 radio uses 3 AAA alkaline batteries (not included) for power. We recommend using high quality alkaline batteries. To install the batteries: 1) Make sure your radio is OFF. 2) Remove the battery compartment door by pressing on and sliding the compartment door, allowing the door to be removed. 3) Install 3 AAA Alkaline batteries (not included) into the battery compartment. Be certain to follow the + and symbols in the compartment. Installing the batteries incorrectly will prevent the unit from operating. 4) Replace the battery compartment door by sliding the door into place.

SPECIFICATIONS

Channels Operating Frequency Power Source Output Power Battery Life Frequency Chart Ch. 11 Freq. 462.5625 462.5875 462.6125 462.6375 462.6625 462.6875 462.7125 467.5625 467.5875 467.6125 467.6375 Ch. 22 Freq. 467.6625 467.6875 467.7125 462.5500 462.5750 462.6000 462.6250 462.6500 462.6750 462.7000 462.GMRS / 7 FRS UHF 462.5500467.7125 MHz 3 AAA Alkaline Batteries (not included) 500mW Conducted 25 Hours typical (5/5/90 duty cycle)

USING THE RADIO

In order to get the most out of your new radio, read this reference guide completely before attempting to operate the radio. Turning the Radio On and Adjusting the Volume 1) Press and hold the key to turn the radio ON. 2) To change the volume level press the volume/monitor L or M key to increase or decrease the volume level. 3) Press and hold the key to turn the radio OFF. Adjusting the Sound (Key Beeps) Your radio emits a beep each time one of the keys (except for the PTT button and call key) is pressed. The sound of the Key Beep will increase or decrease depending on the volume level setting.

Antenna PTT (Push-To-Talk) Button Channel/scan up Key Channel/scan down Key Call Key Speaker Power On/Off Key Volume up/mon (monitor) Key Volume down/mon (monitor) Key
Microphone Channel Indicator Receive Indicator Battery Level Indicator Transmit Indicator

FCC INFORMATION

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Important: Changes or modifications to this unit not expressly approved by Uniden could void your authority to operate this unit. Your radio is set up to transmit a regulated signal on an assigned frequency. It is against the law to alter or adjust the settings inside the radio to exceed those limitations. Any adjustments to your radio must be made by qualified technicians. To be safe and sure: Never open your radios case. Never change or replace anything in your radio except the batteries. Your radio might cause TV or radio interference even when it is operating properly. To determine whether your radio is causing the interference, turn it off. If the interference goes away, your radio is causing it. Try to eliminate the interference by moving your radio away from the receiver. If you cannot eliminate the interference, the FCC requires that you stop using the radio. Hazardous Environments: Do not operate the radio in hazardous environments. Explosion or fire may result. Do not operate the radio near unshielded electrical blasting caps. Under certain conditions, radios can interfere with blasting operations and may cause an explosion. Turn your radio OFF to prevent accidental transmission when in a blasting area or in areas posted: "Turn off two-way radio." Construction crews often use remote control RF devices to set off explosives. Care and Safety: To clean the radio, use a soft cloth dampened with water. Do not use cleaners or solvents because they can harm the body of the unit and leak inside, causing permanent damage. Use a dry, lint-free cloth to clean the battery contacts. Do not submerge the unit in water. If the unit gets wet, turn it off and remove the batteries immediately. Dry the battery compartment with a soft cloth to minimize potential water damage. Leave the battery compartment cover off overnight to ensure complete drying. Do not use the radio until the unit is completely dry.
FCC RF EXPOSURE INFORMATION
WARNING! Read this information before using the radio In August 1996 the Federal Communications Commission (FCC) of the United States with its action in Report and Order FCC 96-326 adopted an updated safety standard for human exposure to radio frequency electromagnetic energy emitted by FCC regulated transmitters. Those guidelines are consistent with the safety standard previously set by both U.S. and international standards bodies. The design of the radio complies with the FCC guidelines and these international standards. Never allow children to operate the radio without adult supervision and the knowledge of the following guidelines. WARNING! It is up to the user to properly operate this radio transmitter to insure safe operation. Please adhere to the following: Use only the supplied or an approved antenna. Unauthorized antennas, modifications, or attachments could impair call quality, damage the radio, or result in violation of FCC regulations. Do not use the radio with a damaged antenna. If a damaged antenna comes into contact with the skin, a minor burn may result. Please contact your local dealer for a replacement antenna. Body-worn Operation This device was tested for typical body-worn operations using the supplied belt-clip. To maintain compliance with FCC RF exposure requirements, Body-worn operations are restricted to the supplied belt-clip. For hand-held operation, the radio should be held 1 inch from the user's face. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements and should be avoided. For more information about RF exposure, please visit the FCC web site at www.fcc.gov.

ONE YEAR LIMITED WARRANTY
Important: Evidence of original purchase is required for warranty service. WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden") ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below. WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of original retail sale. The warranty is invalid if the Product is: (A) damaged or not maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits, sub-assemblies, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owners manual for this product. STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at any time while this warranty is in effect, warrantor will either, at its option, repair or replace the defective unit and return it to you without charge for parts, service, or any other cost (except shipping and handling) incurred by warrantor or its representatives in connection with the performance of this warranty. Warrantor, at its option, may replace the unit with a new or refurbished unit. THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OVERPAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty
is void outside the United States of America and Canada. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owners manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). The Product should include all parts and accessories originally packaged with the Product. Include evidence of original purchase and a note describing the defect that has caused you to return it.The Product should be shipped freight prepaid, by traceable means, to warrantor: Uniden America Corporation Parts and Service Division 4700 Amon Carter Blvd., Fort Worth, TX 76155 (800) 297-1023, 8 a.m. to 5 p.m. Central, Monday through Friday www.uniden.com

Covered under one or more of the following U.S. patents: 4,684,870 4,734,049 5,203,015 5,214,789 5,491,745 5,497,508 5,517,677 5,557,606 5,574,994 5,610,946 5,613,201 5,625,870 5,627,876 5,628,059 5,634,196 5,634,205 5,678,176 5,697,096 5,717,312 5,722,070 5,787,345 5,901,341 6,021,326 6,084,861 6,163,691 6,195,415 6,353,730
2004 Uniden America Corporation All rights reserved Printed in China UTZZ01914ZA