STEP 1 Check package contents (mi6866)
STEP 3 Battery installation
1. Align the two holes in the plug with the socket pins, then snap the plug into place. Place the battery in the compartment with the wires in the upper right corner. 2. Replace cover by sliding it upwards until it clicks into place.

Quick Start Guide

mi6896/6895/6870/6866 STEP 1 Check package contents (mi6896/6895)
Make sure your phones packaging includes the following:
Dial the phone number. -OR Dial the phone number. Press. Receiving a call Press OFF. , SPEAKERPHONE, or any dialing key except
Charger power adaptors (3)

Base unit

Handset

Belt clip

Hanging up Press OFF or place the handset in its base.
STEP 4 Charge the battery
Base unit Handsets (4) Chargers (3) Telephone line cord Battery Quick start guide

STEP 7

Set the Clock
1. Place the handset in the base unit/chargers. 2. Charge the battery for at least 16 hours before first use.
1. Press TIME/SET to listen to the current setting. 2.Press TIME/SET again to indicate changes needed. 3.Press CHANGE to change the day, hour, minute, or year. 4.When you hear the correct setting, press TIME/SET to advance to the next setting. NOTE: If you have caller ID service, the time will automatically be updated with the first incoming call after you program the year into the system.

Telephone line cord

Belt clips (4)

Batteries (4)

Quick start guide Base power adaptor Wall mount bracket Users manual

Base power adaptor

Wall mount bracket

Users manual

STEP 1 Check package contents (mi6870)
STEP 2 Connect power to telephone base/ chargers
Plug the power adaptor into an electrical outlet not controlled by a wall switch, and the connector into the power jack on bottom of the telephone base/chargers.
STEP 5 Connect to phone line
Plug one end of the telephone line cord into the telephone line jack at the bottom of the telephone base. Then plug the other end of the cord into the wall telephone outlet. Telephone outlet

STEP 8

Record your outgoing announcement

Charger power adaptor

AC power outlet AC power outlet
1. Press SETUP, the system announces Announcement. Press PLAY or press RECORD. To continue setup, press SETUP. 2.Press REC/MEMO and speak toward the MIC on the base to record an announcement for up to 90 seconds. 3.Press PLAY/STOP / ( when finished recording). NOTE: For complete feature instructions, please refer to your users manual.

Handsets (2)

Charger

Belt clips (2)

Batteries (2)

Quick start guide

STEP 6 Making and receiving calls
Making a call Press or SPEAKER and listen for dial tone. NOTE: Use only the power adaptors supplied with your VTech telephone.
IMPORTANT! If your product is not working properly: 1. Refer to your users manual. 2. Visit our website at www.vtechphones.com or in Canada, www vtechcanada.com. 3. Call our customer service at 1-800-595-9511 or 1-800-in Canada.

96-006136-020-100