GB AWO/D 049

A. Door open indication This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately, e.g.: B. Service indication C. Water tap closed indication D. Clean pump indication

PROGRAMME CHART

G C D A B
E. Programme selector F. Start/Pause button G. Programme sequence indicator

H. Reset button

Type of wash/Notes Programme Care Labels - for temperature selection, respect the manufacturers recommendations on the care label Cotton with prewash

Max Load

Detergents and additives Prewash Main Wash Softener
Special options Spin speed reduction 500 rpm Rinse hold

Spin Speed rpm

Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc.). Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Curtains and delicate clothing, dresses skirts, shirts and blouses. Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. If you select Rinse Hold do not leave items to soak for too long. Textiles made of linen, silk, wool and viscose marked as handwashable. If you select Rinse Hold do not leave items to soak for too long. A very gentle spin is used in this programme. Same as the last rinse and the final spin in the Cotton programme. In this programme spinning is intensive. Same as the spin cycle in the Cotton programme. In this programme spinning is gentle. Same as the spin cycle in the Wool programme. Drain only - no spinning. Alternative method of terminating programme after Rinse Hold.

5.0 5.0 2.5 2.5 1.5 3.0

Yes Yes

Yes Yes Yes Yes Yes Yes

1000 1000

Cotton

40 - 60 - 95 C

Synthetics with prewash

Synthetics 30 - 40 - 60 C Delicates

Quick wash

Cold - 40 C
Handwash 30 - 40 C Rinse & Spin Spin Gentle Spin Drain

1.0 5.0 5.0 1.0

400 1) 1000
optional / Yes : dosing required For improved garment care, spin speed is restricted to 400 rpm in this programme.
Whirlpool is a registered trademark of Whirlpool USA
CONSUMPTION DATA Temperature Programme Cotton Cotton*** Cotton Synthetics Synthetics Quick wash Delicate Wool Handwash Handwash (C) (kg) 5.0 5.0 5.0 2.5 2.5 3.0 1.5 1.0 1.0 1.0 (l) 49** 50** (kWh) 1.90 0.85 0.60 0.70 0.55 0.40 0.50 0.60 0.60 0.50 Load Water Energy Approx. Programme Duration (hours : minutes) 2:00 2:20 2:00 1:30 1:15 0:30 0:45 0:45 0:40 0:40
PROGRAMME START Open the tap and press the Start/Pause button. The indication lamp next to the Start/Pause button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phase is finished, the corresponding indication goes out. DOOR OPEN INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to Cancel (Reset) a running programme before the end. RED INDICATIONS Service Lighting up of the Service indication can be caused by a fault in an electrical component. Refer to the Troubleshooting Guide in your Instructions for Use; if the fault persists, contact our After Sales Service. Water tap closed The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the Troubleshooting Guide in the Instructions for Use. Clean pump Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (Removing the Filter).
PROGRAMME END All the lights of the programme sequence indicator are off, and the Door open indication lights up. 1. Turn the programme selector to the Off/O position. 2. Close the water tap. 3. Open the door and unload the machine. 4. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the Start/Pause button to pause the programme. The light flashes. 2. Select the new programme (with temperature), any options and another spin speed if you want. 3. Press the Start/Pause button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The Reset button cancels a programme before the end. Press the Reset button for at least 3 seconds. Any existing water is drained out before the door can be opened.

Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label.
ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in your Instructions for Use. Close the door and turn the programme selector to the desired programme and temperature. The indication lamp next to the Start /Pause button flashes. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lamp lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. Spin speed reduction 500 rpm button Reduces the predetermined automatic maximum spin speed to treat your laundry more gently.
Rinse hold button The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. This option is particularly recommended for the programmes Synthetics and Delicates. This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Note: The programme stops to Rinse hold at the time the Rinse hold light in the programme sequence indicator is on. The indication lamp next to the Start/Pause button flashes. Terminate the Rinse hold option: Press the Start/Pause button; the programme will terminate automatically with the final spin cycle for the present wash programme. If you do not wish to spin the clothes, turn the programme selector knob to the Drain programme and press the Start/Pause button.