Limpieza y mantenimiento (Engrase) a un Rotor para antenas de Radio Aficionado YAESU G2800GXA.
Testing of the Yaesu G-1000DXA Rotor and control box. Video taken 2-12-2016.
Now to source the indicator pot.........
Amateur Amplifiers & Rotors
ALS-600 AL-811 PW-1
The Icom IC-PW1 is a 1000 watt linear ... G-5500 Azimuth-Elevation List $945.00 Order #0180
The Yaesu GS-232B Rotor Computer Interface provides digital control of most Yaesu antenna rotators. The 3 wire async serial ... RS232C port. Supplied items include: Control cable for the Azimuth rotor (5 in to mini DIN), Control cable for the Az/El rotor (Dual 5 pin to DIN cable), DC power cable ... for the SDX series. $ List $870.00 Order # .95
Please see ROTOR CABLE on page 56.
Universal Radio 6830 Americana Pkwy. Reynoldsburg, Ohio 43068
Quality Equipment Since 1942 ...
... idea, I also encountered I am afraid to say preassembled rotor replacement boxes that were SMD but assembled MANUALLY instead of an automated process using robotics. Well Rene ERC ... enclosure simply held on the back side of most rotor controller and with the large enclosure used to control manually your rotor. The ERC-M is designed around a more ... powerful Atmel Mega644P-20 CPU and an optional FTDI USB chip set, as always the rotor position ... was unable to calibrate on the FIRST try. Important Note: Where most rotor interface most rotor interfaces uses a simple pots or combination of a couple of pots ... to let you calibrate your rotor position expecting a 0-5vdc. Most rotor controllers are NOT using 05vdc and even if they do this manual process is difficult and unreliable ... . Ren's DF9GR has always used a software based calibration process that is simple, flexible and highly reliable even with highly unreliable rotors ...
... Protocol supported: GS232A-Az and GS232A-Az/Elev or GS232B-Az and GS232B-Az/Elev. Rotor controllers supported: More then 36 different ones from 5 different manufacturers. Firmware release tested: Release ... -R utility, like just about everything else in this tiny interface having to do with rotor handling for each axis. Some of the other interesting settings are the overshoot parameters giving ... are widely used and supported protocols that makes this unit easy to use with most rotor control software.
Installation, Calibration and Operations (10/10): Again, Rene's well prepared documentation featuring ... 39 rotor controllers from five manufacturers was really helpful to understand and properly install the unit into ... most Rotor controllers. He uses a colour/numeric coded scheme that's simple enough to understand and ...