QCPrinted in Taiwan
Volume Control Pickup Selector
Front Pickup Front + Rear Rear Pickup

Tone Control Output Jack

1. To use magnetic pickup only, plug into output jack #1.
2. To use both magnetic & piezo pickup, plug into output jack #2.
Battery Compartment Battery Compartment
* No battery needed to use magnetic pickup only

Piezo Pickup Bridge

* Battery needed to use output jack #2

Volume Control

(for output jack #1)

Pickup Selector

Inside Knob: Tone Control Output Jack #1
* Output only from magnetic pickup * Bypass pre-amp inside (passive) Volume Control for output jack #2

Tone Control

for magnetic pickup

Outside Knob

Panpot for magnetic/piezo * Clockwise for magnetic. Counter-clockwise for piezo

Output Jack #2

* Output from magnetic & piezo pickup * Output through pre-amp inside (active)
NOTE 1 Output jack #1 & #2 can be used at one time. NOTE 2 When not in-use, unplug from output jack #2 to save battery. Output jack #1 dose not consume battery.
The SPERZEL Trim-Lok tuners offer easy string change and improved tuning stability when using the tremolo bridge. 1) Loosen the knob q on the back of the tuner. As the locking pin w in the string post goes down, remove the old string. 2) Place the new string from the bridge into the string hole e of the string post. Do not wind the string around the post. 3) Pull the new string tightly and tighten the knob q to lock the string. 4) Tune the strings to the pitch.

Loosen Tighten

Don't loose the knob q too much. It may drop out the tuner.

I String Action

Adjust the tremolo unit height by rotating the height adjustment bolts q.

I Intonation Adjustment

If the pitch at the 12th fret is sharp compared to the harmonic tone: Turn the intonation adjusting screw w clockwise. If the pitch at the 12th fret is flat compared to the harmonic tone: Tune the intonation adjusting screw w counter-clockwise. q e

I Arm Tension

Turn the arm tension screw e clockwise to make the arm tighter. Turn the arm tension screw e counter-clockwise to make the arm looser. w