Tutorial for the S5560

Be sure to have a backup of the data on your phone! Flashing a phone is a tricky business so be sure to know the risks! What do you need for installation: The desired firmware The Multiloader application The Samsung S5560 USB-cable The S5560

Preparation:

Firmware Multiloader 5.60
Samsung S5560 USB cable How to get you phone into firmware mode:
Link FW-List P-S-U The application that will flash the new firmware to your mobile. Link MultiLoader Original cable. Press and hold the following buttons. (Picture. 1): (1) Volume down (2) Camera button. (3) Power button. Turn of your phone Remove your MicroSD and SIM card, put the battery back in
Picture 1. Download Mode. 5) 6) Flashing: 1) 2) 3) 4) Connect your phone with your pc. Before you start do a hard reset. Open the MultiLoader. Extract the firmware onto your desktop. Select the option (BRCM2133) in the control section of the MultiLoader. Put a check in Boot Change, Full Download and Master Rom: Use the original USB cable Enter the following code: *2767*3855#
BRCM2133 Boot Change Full Download Master Rom Boot = BOOTFILES
Click the Boot button and browse to the firmware folder on the desktop and select the file. Do the same for all the other buttons (work the list from top to bottom, skip FOTA, Tune and ETC).
Be sure to select the LOW version for the Rsrc2 button Check if your phone is correctly connected. If the Port Search is ready, click DOWNLOAD. 9) Leave your phone connected during the entire firmware installation. 10) When the MultiLoader says "All files complete", disconnect your phone, remove the battery, insert your MicroSD and SIM card 11) Turn on your phone, enter your PIN code. Your phone is now updated!
Following groups are NOT required: Amss FOTA, Tune ETC Always choose the LOW version. Click on Port Search
Remove battery. Insert battery. Flash is succesfully completed.

Page 1

Picture 2.
Example picture Samsung S5560.

Page 2