English 1. Tilt wheel plus zoom.
Push wheel to either side to scroll side to side. Click and roll the wheel to zoom in and out. (Works only if software is installed.) 2. Battery Warning LED. This LED glows green briefly when the mouse is turned on and when the batteries are good. It flashes red when the batteries are low. 3. Left and right mouse buttons. 4. Launch the Logitech SetPoint software to customize button and tilt wheel assignments.
Franais 1. Roulette multidirection-
Espaol 1. Botn rueda inclinable
y zoom. Incline el botn rueda para desplazamientos horizontales. Haga click en el botn rueda y grelo para aplicar zoom. (Slo si se ha instalado el software.) 2. Diodo de advertencia sobre las pilas. Este diodo se ilumina en verde un instante al activar el mouse si el nivel de carga de las pilas es bueno. Si emite destellos rojos, significa que la carga es baja. 3. Botones izquierdo y derecho. 4. Utilice el software Logitech SetPoint para personalizar asignaciones de tareas de botn y rueda inclinable.
nelle avec zoom. Poussez la roulette droite ou gauche pour un dfilement correspondant vers la droite ou la gauche. Cliquez sur la roulette pour effectuer un zoom avant ou arrire (fonctionne uniquement si le logiciel est install). 2. Tmoin d'avertissement du niveau des piles. Ce tmoin s'allume brivement en vert lorsque la souris est sous tension et lorsque les piles sont charges. Il clignote en rouge lorsque le niveau des piles est faible. 3. Boutons droit et gauche de la souris. 4. Lancez le logiciel Logitech SetPoint pour personnaliser les affectations du bouton et de la roulette.

English

Mouse Not Working. 1. Make sure the power switch on the bottom of the mouse is set to the ON position. 2. Make sure the receiver is plugged into a USB port on the computer and the computer is on. Try another USB port if necessary. 3. Check battery installation. Replace the batteries if the Battery Warning LED flashes red. 4. If cursor movement on your computer monitor is slow or intermittent around a wireless network, press the Reset button on the bottom of the mouse for 4 seconds. 5. If none of the above has worked, use the Logitech Reconnection Utility (works only if the software has been installed). Windows: Go to the Start Menu and select Start/Programs/Logitech/Mouse and Keyboard/Reconnection Utility. (If your PC has no touchpad, press the Start Menu key on your keyboard to open the Start Menu, and then use the Arrow keys to navigate this menu.) Macintosh: Run the Logitech Reconnection Utility, follow the on-screen instructions, and click OK after the mouse becomes active.