2007 Ducati 1098

I n s ta l l a t i o n I n s t r u c t i o n s Parts List
Power Commander USB Cable CD-ROM
Button Adjustment Display
Installation Guide Power Adapter Wire T ap
Power Commander Decals Dynojet Decals Velcro

Alcohol Swab Zip ties

Faceplate Buttons

Expansion Port

The ignition MUST be turned OFF before installation!

USB Port

You can also download the Power from our web site at:
Commander software and latest maps www.powercommander.com
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
i729-411 www.powercommander.com 2007 Ducati 1098 - PCIII USB - 1

Fig. A

Remove the seat and solo cover. Remove the cover around the fuel tank (Fig. A).
Remove the fuel tank Remove the inner fairing cover on the right hand side (Fig. B).

Fig. B

Lay the PCIII in the tail section temporarily.

Fig. C

PCIII harness
Route the PCIII harness through the hole in the tail section (Fig. C).

Fig. D

Route the PCIII along the right hand side of the subframe. PCIII harness to the subframe using 2 of the large supplied zip ties (Fig. D) Secure the

Zip ties

i729-411

www.powercommander.com

2007 Ducati 1098 - PCIII USB - 2
Unplug the stock wiring harness from the rear injector (Fig. E)

Fig. E

This injector is located on top of the air box.
first remove the spring clip. driver.
To remove the connector you must
best done with a pick or small screwUnplug

This is

Zip tie
Plug the YELLOW colored wires wiring harness and rear injector (Fig. F).
from the PCIII in-line of the stock

Fig. F

Make sure to reinstall the spring clip on the stock connector. 10
Use 1 of the small supplied zip ties to
secure this connection to the fuel line. Make this connection as compact as

PCIII connector

Stock connector

possible.

Unplug the stock wiring harness from the front injector (Fig G).

access.

This connection is very difficult to

radiator.

front of the bike directly above the
It is best to get to thru the
Figure G was taken from the front of and above the radiator.
the bike inside the right hand fairing
2007 Ducati 1098 - PCIII USB - 3
Plug the ORANGE colored wires injector and stock wiring harness (Fig. H).
from the PCIII in-line of the front

Fig. H

Remove the right hand fairing.
Route the PCIII harness along the right hand side frame down tube. harness in place (Fig. J).
the existing wraps to hold the PCIII
Locate the Throttle Position Sensor on the right hand side of the throttle bodies.

Fig. J

Crimp the supplied wire tap to the ORANGE wire (C position).
Connect the GREY wire from the PCIII to the wire tap.

Grey wire

It is recommended to use dielectric grease on these connections.

Ground wire from PCIII

Attach the ground wire from the PCIII to the right hand engine cover bolt shown in Figure K

Fig. K

Reinstall the right hand fairing
2007 Ducati 1098 - PCIII USB - 4
Install the PCIII in the tail section using the supplied velcro. swab before attaching.
to clean both surfaces with the alcohol

Make sure

Reinstall all bodywork and fuel tank. When lowering the fuel tank make nection of the rear injector.
sure it does not interfere with the con-
Unless you have the Kit ECU you will not be able to make fuel changes below 20% throttle and below 5500rpm with this PCIII.
2007 Ducati 1098 - PCIII USB - 5

DUCATI 1098R

(2008 - 2009)
SLIP-ON OPEN & SLIP-ON STREET LEGAL EXHAUST SYSTEM
DUCATI 1098R (2008 - 2009)

DESCRIPTION

The Akrapovic SLIP-ON OPEN exhaust system for the new Ducati 848 is an invincible combination of performance and price. In addition to performance, the twin titanium or carbon fiber mufflers add a clean racing look. And the Ducati will put out a much more powerful racing sound. You will also save 2.7 kg compared to the stock Ducati exhaust system. The SLIP-ON street legal system is homologated and ready for road use. PERFORMANCE Measurements of the Akrapovic SLIPON OPEN system on the DUCATI 848 without muffler insert: Power & Torque: the Akrapovic SLIP-ON OPEN system greatly increases the potential of the twin cylinder engine. Both power and torque are increased over the entire rpm range, with the greatest increase shown in the low and top of the range. We measured 126.5 hp at 10500 rpm, while the max. increased power of 5 hp was measured at 4900 rpm. CONFIGURATION The Akrapovic SLIP-ON OPEN system for the Ducati 848 has a specific 2-2 configuration. The titanium link pipes are welded to the muffler. The header tubes and link pipes are attached with a sleeve joint, secured with a silicon-shielded spring. The muffler is available with a titanium or carbon fiber outer sleeve. The metal interior parts of both mufflers are made entirely of titanium. The outlet cap is made from carbon fiber in both cases. The mufflers are attached to the motorcycle with pair of carbon fiber clamps.

PERFORMANCE

stock max. rear wheel power HP / rpm
(measured on Dynojet ATV)

AKRAPOVIC

max. increased power

166.5 / 9850

168.7 / 9930

2.3 / 10000

CONFIGURATION
header tubes material tube shape -
collector link pipe TITANIUM CYLINDRICAL
interference crossover tubes header tube inner sleeves header tubes - collector connection link pipe - muffler connection muffler metal interior muffler clamp muffler insert EU US
WELDED TITANIUM CARBON-FIBER YES -
lambda sensor header tube flanges collector / header tube link pipe connection muffler inlet cap /outlet cap muffler outer sleeve muffler bracket heat shield catalytic converter
NO SLEEVE JOINT + SILICON SHIELDED SPRINGS Ti Carb.-fiber Ti Carb.-fiber -

ADDITIONAL DATA

weight comparison (kg) stock 5.75 AKRAPOVIC S.S. link pipe noise measurements (dB / rpm) possibility of periodic service without removing A.E.S. legal for street use stock 96dB / 4875 oil YES NO / YES TITANIUM link pipe 3.05 difference stock - S.S. AKRAPOVIC 100.3 / 4875 oil filter YES stock - titanium 2.7
Technical specifications of Akrapovic exhaust systems and related products subject to change without notice.
Product code: (107952) S-D10SO3-ZC, (107951) S-D10SO3-ZT open
(108115) S-D10SO3C-HZT street legal
Akrapovi d.d. 2008 all rights reserved

EXHAUST PHOTO

DUCATI 1098R (2008)
SLIP-ON OPEN EXHAUST SYSTEM

SHEMATIC

(V-TUV072L) NOISE REDUCTION INSERTS
(M-Z01305TL) FULL TITANIUM MUFFLER / LEFT (M-Z01305CL) TITANIUM/CARBON-FIBER OUTER SLEEVE MUFFLER / LEFT

DUCATI

2007-2008
Product code: S-D10SO3-ZC S-D10SO3-ZT
(V-TUV072) NOISE REDUCTION INSERTS
(M-Z01305T) FULL TITANIUM MUFFLER (M-Z01305C) TITANIUM/CARBON-FIBRE OUTER SLEEVE MUFFLER (P-MCCZ7) CARBON FIBER CLAMP FOR CARBON OUTER SLEEVE (P-MCTZ7) CARBON FIBER CLAMP FOR TITANIUM OUTER SLEEVE P-HST2AL STICKER

(P-S1) SPRING

SLIP-ON STREET LEGAL EXHAUST SYSTEM
V-TUV072L NOISE REDUCTION INSERTS
M-HCZ01305TL FULL TITANIUM MUFFLER / LEFT
DUCATI 1098 /S 2007/ 2008 system/ STREET LEGAL 1098 R 2008/ 2008/ 2009 1198S 2009 Product code: S-D10SO3C-HZT SLIP ON exhaust
V-TUV072 NOISE REDUCTION INSERTS
M-HCZ01305T FULL TITANIUM MUFFLER
P-MCTZ7 CARBON FIBER CLAMP FOR TITANIUM OUTER SLEEVE
P-HST2AL STICKER P-S1 SPRING
Product code: (108115) S-D10SO3C-HZT street legal

DIAGRAM / CHART

STOCK EXHAUST
AKRAPOVIC SLIP-ON EXHAUST 125

120 115

110 105

EngTrq

WhlPwr

100 95

7000 EngSpd RPM 10000