DIGITAL DELAY DD600

Thank you for showing your confidence in us by purchasing the BEHRINGER DIGITAL DELAY DD600. This digital Delay effects pedal is designed to deliver 24-bit high-resolution stereo delay sounds comparable to state-of-the-art studio processors. Thanks to its parameter controls, youll have plenty of cool sounds at your disposal to handle every situation.

1. CONTROLS

Select the effect mode via the MODE switch (see table below). Use the D.TIME control to fine-tune the delay time. The delay time describes how fast the signal repetitions will follow after the original signal. Depending on the selected mode, you can adjust it between 1 ms and 2000 ms. In HOLD and TEMPO modes, D.TIME is disabled. The F.BACK (feedback) control adjusts the amount of signal repetitions. In HOLD mode, F.BACK is disabled. LEVEL adjusts the effect level. Use the " TS IN connector to plug in the instrument cable. Use the " TS TEMPO connector to connect an external foot switch. Use the foot switch to tap in the song tempo (in TEMPO MODE). The " TS OUT A connector sends a mono signal to your amp. In E/D mode, it sends the effect signal only. Use the PAN OUT connector and OUT A to acheive a full stereo delay effect. In E/D mode, it sends the dry signal only.

Top view

The ON/BATT LED illuminates when the effect is activated. It also serves as a battery level indicator. Use the foot switch to activate/deactivate the effect. In HOLD mode, use the foot switch to start and stop the recording. The signal is recorded while holding down the foot switch. Playback begins immediately after releasing it.
MODE 11 DELAY HOLD REVERSE E/D TEMPO Effect description Short delay Short to medium delay Medium to long delay Long delay Record and play back your performance Signal is repeated in reverse Stereo delay using OUT A and PAN OUT Adds a quarter note Adds an eighth note Adds a dotted eighth note Adds a triplet D.TIME 1 - 50 ms 50 - 200 ms 200 - 800 ms 800 - 2000 ms (Rec. time: max. 2 s) 1000 - 2000 ms 1 - 400 ms D.TIME disabled. Tap tempo via external foot switch
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included). The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to scratch the unit. The DD600 has no On/Off switch. It is operable as soon as you insert a plug into the IN connector. Disconnect the plug, if you dont use the DD600. In doing so, you can extend the life time of the battery.
The SERIAL NUMBER is located on the underside. In rare cases interferences of the normal function may appear by external influence (e.g. electrostatic discharge), as for example sound disturbances or malfunctions. If this occurs, please turn down the volume on subsequent amplifiers and disconnect the input connector briefly to restart the application.

2. WARRANTY

For our current warranty terms, please refer to our website at http://www.behringer.com.

3. SPECIFICATIONS

IN TEMPO OUT A PAN OUT Power supply Connector " TS, 500 k Connector " TS, 500 k Connector " TS, 1 k Connector " TS, 1 k 9 V_, 100 mA regulated BEHRINGER PSU-SB USA/Canada 120 V~, 60 Hz China, Korea 220 V~, 50/60 Hz Europe/Australia 230 V~, 50 Hz Japan 100 V~, 50 - 60 Hz 2 mm DC jack, center negative 9 V type 6LRmA approx. 54 mm (2 1/8") x 70 mm (2 3/4") x 123 mm (4 4/5") approx. 0.39 kg (0.86 lbs)

Power connector Battery Power consumption Dimensions (H x W x D) Weight
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be made from time to time to existing products without prior notice. Specifications and appearance may therefore differ from those listed or shown.

4. SAFETY INSTRUCTIONS

Do not use near water, nor install near heat sources. Use only authorized attachments/accessories. Do not service product yourself. Contact our qualified servicing personnel for servicing or repairs, especially when power supply cord or plug is damaged. Betreibe das Gert nicht in der Nhe von Wasser oder Wrmequellen. Verwende bitte nur autorisiertes Zubehr. Fhre bitte keinerlei Reparaturen am Gert eigenstndig durch. Reparaturen sind nur von qualifiziertem Fachpersonal vorzunehmen, insbesondere bei Beschdigungen des Netzkabels oder Netzsteckers. Ne pas utiliser ni installer proximit de liquides ou de sources de chaleur. Utiliser exclusivement les accessoires autoriss. Ne pas raliser de maintenance soi-mme sur le produit. Contacter notre personnel technique pour tout service ou rparation, particulirement si le cordon ou le connecteur du bloc dalimentation est endommag. No utilizar cerca de agua o instalar cerca de fuentes de calor. Utilice slo accesorios y aditamentos autorizados. No intent reparar el producto usted mismo. Contacte a nuestro personal tcnico cualificado para servicio y reparaciones, especialmente cuando la fuente o el cable de alimentacin estn daados. . . . , .
Die deutsche Anleitung ist erhltlich @ www.behringer.com Manuel francophone en tlchargement sur www.behringer.com Manual en espaol disponible en www.behringer.com Manuali italiani disponibili @ www.behringer.com @ www.behringer.com Polska instrukcja dostpna jest pod adresem @ www.behringer.com Nederlandse handleiding beschikbaar @ www.behringer.com Suomenkielinen kyttohje saatavilla osoitteesta www.behringer.com Svensk manual finns tillgnglig p www.behringer.com Dansk vejledning findes p @ www.behringer.com Manual portugus disponvel @ www.behringer.com www.behringer.com
Technical specifications and appearance are subject to change without notice. The information contained herein is correct at the time of printing. BEHRINGER accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph or statement contained herein. Colors and specifications may vary slightly from product. Products are sold through our authorized dealers only. Distributors and dealers are not agents of BEHRINGER and have absolutely no authority to bind BEHRINGER by any express or implied undertaking or representation. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the express written permission of BEHRINGER International GmbH. ALL RIGHTS RESERVED. 2007 BEHRINGER International GmbH. BEHRINGER International GmbH, Hanns-Martin-Schleyer-Str. 36-38, 47877 Willich-Muenchheide II, Germany. Tel. +9206 0, Fax +9206 4903

FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
Responsible party name: Address: MUSIC Group Services USA, Inc. 18912 North Creek Parkway, Suite 200 Bothell, WA 98011, USA Phone: +Fax: +673 7647

Phone/Fax No.:

complies with the FCC rules as mentioned in the followingparagraph: This equipment has been tested and found to comply with the limits for a ClassB digital device, pursuantto part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected. Consult the dealer or an experienced radio/TV technician forhelp. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesiredoperation. Important information: Changes or modifications to the equipment not expressly approved by MUSIC Group can void the users authority to use the equipment.

behringer.com