Wired Microphones 565SD

Unisphere Unisphere Unisphere Unisphere
2009 Shure Incorporated 27A13224 (Rev. 1)

Printed in U.S.A.

The 565SD microphone is a dual-impedance, unidirectional dynamic microphone with a strong, wire-mesh, spherical front grille that contains a highly effective wind and pop filter. Shipped connected for low-impedance operation, a 565SD microphone provides excellent vocal or speech reproduction on stages and studios, and is a popular choice for use in public auditoriums, churches, convention halls, and schools.

SPECIFICATIONS

Type Frequency Response Polar Pattern Output Impedance Sensitivity (at 1 kHz, open circuit voltage) Polarity Weight Dynamic (moving coil) 50 to 15,000 Hz Cardioid EIA rated at 150 (250 actual) L: 56.0 dBV/Pa (1.6 mV) H: 34.0 dBV/Pa (20 mV)

1 Pascal=94 dB SPL

FEATURES
Selectable dual-impedance operation Silent, lockable on/off switch Cardioid dynamic Frequency response: 50 to 15,000 Hz
Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3 Net: 0.298 kg (0.656 lbs) On/Off: Lockable ON/OFF switch Three-pin professional audio (XLR), male Chrome-plated die casting with steel mesh grille

IMPEDANCE SELECTION

Switch Connector Case
The microphone is shipped connected for low impedance operation. To change to high impedance proceed as follows: 1. Loosen plug element by turning slotted setscrew counterclockwise (turn counterclockwise to lower screw into plug element). Pull plug element from case. Be careful not to stretch or break wires. 2. The low impedence socket of the impedence selection connector is connected to Pin 3 of the plug element. Move the connector to the high-impedance socket (see diagram). 3. Reinsert plug element and tighten setscrew (turn clockwise to raise screw).

CERTIFICATION

Eligible to bear CE Marking. Conforms to European EMC Directive 2004/108/EC. Meets Harmonized Standards EN55103-1:1996 and EN55103-2:1996, for residential (E1) and light industrial (E2) environments. The Declaration of Conformity can be obtained from: Authorized European representative: Shure Europe GmbH Headquarters Europe, Middle East & Africa Department EMEA Approval Wannenacker Str. 28 D-74078 Heilbronn, Germany Phone: +0 Fax: +14 E-Mail: EMEAsupport@shure.de

SET SCREW PLUG ELEMENT

IMPEDANCE SELECTION CONNECTOR

ACCESSORIES AND PARTS

Furnished Accessories
Swivel Stand Adapter A25D

Polarity

To test two microphones and their cables for common polarity, connect them to an amplifier and talk or sing into them while holding them three or four inches apart. The sound from the speakers should be the same when talking into either microphone or directly between them if they have common polarity. If the sound level drops drastically, or if a dead spot is found when talking between the two microphones, either the microphones or their cables have different polarity. All cables and microphones can be tested in this manner to ensure that they have common polarity. To reverse the polarity of a low-impedance microphone cable, use either a Shure A15PRS Switchable Phase Reverser or interchange the wires connected to pins 2 and 3 of the XLR connector.