short review on a makita half inch router.
Wood Tips: Router - George Vondriska demonstrates the difference between plunge and fixed based routers. A WoodWorkers ...
First Cuts on the Makita Compact Router. She cut like butter. The Spindle mounts I made in the last video did great. Now I just ...
112" MODEL 36016
Collet chuck capacity
NO load speed (RPM)
N ... or replaced by an authorized service center unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced by authorized service center. Don't use tool if ... be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
Installing or removing router bit CAUTION : Always be sure that the tool is switched off and unplugged before ... templet guide provides a sleeve through which the bit passes, allowing use of the router with templet patterns.
Screw the templet guide on the base plate.
Secure the templet ... accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury ...
118 I D 3116 I D 114 I D
- ' US
112" ROUTER Model 3601B
Note: The switch, noise suppressor and other part configurations may differ from ...
RJ Metal Fab Inc
Mar 11, :00 AM Late Model CNC and Conventional Metal Fabricating Equipment Location : Cambridge, ONTARIO Contact : Jim Hodder 416-242-3560
Tuff Edge Inc
TIME : LOCATION: Mar 04, Carnforth Road Don Mills, ONTARIO TERMS AND CONDITIONS PAYMENT: MUST BE MADE IN FULL DAY OF SALE. PAYMENT IS CASH, CASHIER'S CHECK, CERTIFIED CHECK, WIRE TRANSFER, COMPANY CHECK ONLY IF ACCOMPANIED BY A LETTER FROM YOUR BANK GUARANTEEING AMOUNT OF CHECK FOR DEPOSIT AND/OR PAYMENT IN FULL. NO PERSONAL CHECKS. FULL PAYMENT MUST BE MADE BEFORE REMOVAL OF PURCHASE. REMOVAL: LAST DAY OF REMOVAL IS WEDNESDAY, MARCH 17, 2010 BY 5:00 PM , AND AS FURTHER DEFINED IN THE SALE CATALOGUE. EVERYTHING IS SOLD "AS IS, WHERE IS". ALL SALES FINAL. COST AND RESPONSIBILITY FOR REMOVAL OF PURCHASE REMAINS WITH THE PURCHASER. EVERY EFFORT WILL BE MADE TO FACILITATE REMOVAL. WHILE QUANTITIES AND DESCRIPTIONS ARE BELIEVED TO BE ACCURATE, THE AUCTIONEER, OWNERS OR COUNSEL MAKE NO WARRANTIES OR GUARANTEES EITHER EXPRESSED OR IMPLIED AS TO ...
... to the cutter shank before fitting the cutter to the router.
FITTING YOUR ROUTER
If your router has a square or rectangular base you may need to ... below. Note that the four clamps should be spaced as equally as possible around the router base. Once the locators are correctly positioned, use a spanner to securely tighten the ... D
Fit the mounting plate into the bearing channels of your Workcentre. Set your router height so that the cutter shank protrudes through the hole in the mounting plate. ... main table of the Workcentre is used to support material when overhead routing. The router cutter will probably not reach the workpiece even at full cutter depth. Do not ... to the plate. Only use the jigsaw upside down in conjunction with the Triton Router & Jigsaw Table.
Use the on/off switch on the Workcentre rather than the ... deep pass. This results in more accurate trenches and a smoother finish, and your router cutters will stay sharp longer.
Due to our company policy of continuous product improvement, ...